溫度穩定 的英文怎麼說

中文拼音 [wēndùwěndìng]
溫度穩定 英文
temperature stabilization
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 穩 : 形容詞1 （穩定; 穩當） steady; stable; firm 2 （穩重） steady; staid; sedate 3 （穩妥） sure; rel...
  • 定 : Ⅰ形容詞1 （平靜; 穩定） calm; stable 2 （已經確定的; 不改變的） fixed; settled; established Ⅱ動詞...
  • 溫度 : [物理學] temperature
  • 穩定 : 1 （使穩定） stabilize; steady 2 （穩固安定） stable; steady 3 （物質的性能不易改變的作用） stabi...
  1. The alloy has excellent thermal stability.

    合金有極好的溫度穩定性。
  2. Voltage reference is a vital basic module which is widely adopted in analog circuits ( mixed signal circuits ). its temperature stability and antinoise capability influence the precision and performance of the whole system

    電壓基準源是模擬電路（混合信號電路）設計中廣泛採用的一個關鍵的基本模塊，它的溫度穩定性以及抗噪性能影響著整個電路系統的精度和性能。
  3. It is also found that replacement of substrate and adjustment of film stack structure would lead to the change of drift, this will enhance the temperature stability of filter

    同時經過計算分析發現通過更換膜系基板和調整膜系結構可以改變濾光片中心波長的漂移，這個結果有助於提高濾光片的溫度穩定性。
  4. The equivalent circuits is synthesized for the case where the te10 mode is the only propagating waveguide mode, which based on basic waveguide - circuits equivalent circuits such as cross - coupled coaxial line rectangular waveguide junctions, rectangular waveguide transmission lines etc. then we make the computation program for the equivalent circuits to analyse and optimize the vco circuit, and get the each parameter ' s influences on vco output signal

    本文從波導電路的等效電路出發，綜合出3mmvco基波工作時只考慮te10模的等效電路，依據此編製程序完成了振蕩器電路的分析優化，得出了電路中各個參數對振蕩器頻率溫度穩定度性能的影響。
  5. The task come from a magnetism material factory, their plant needs to reconstruct. the plant is used in working procedure that sinters magnetism material

    本課題來自材料廠的設備改造，該設備用於磁性材料的燒結工序，該工序對燒結過程的溫度穩定性要求較高。
  6. This paper gives a brief introduction of the formation mechanism of sma and the handing property of pavement from the aspects of theory and research. at the same time, this paper also studies the effect of aggregate size on road - related performance in some different grads. except, it also having inspected to use the sbs, the pe and the combination material of sbs and pe to analyze the influence to the function of material road

    瀝青瑪蹄脂碎石混合料（ sma ）以其溫度穩定性好、抗滑性能優良、低噪音、使用耐久等優點在公路建設中越來越受到重視，本文對sma組成特點，強度形成機理與路面使用性能從理論和試驗研究角度進行論述，並針對不同級配的瀝青瑪蹄脂碎石混合料，分析了粗、細集料的粒徑變化對其路用性能的影響，同時也考察了用sbs 、 pe 、 sbs和pe復合改性后的瀝青結合料對混合料的路用性能影響。
  7. Magnetic materials - part 12 : guide to methods of assessment of temperature capability of interlaminar insulation coatings iec 60404 - 12 : 1992

    磁性材料.第12部分:層間絕緣塗層的溫度穩定性的評定
  8. The result of a great deal of experiment shows that the digital control method proposed in this paper is better than the analog one widely used at present. the stability of optical output power and spectrum including temperature stability and long time stability is advanced in great degree

    經過大量的實驗表明：與傳統的模擬控制方法相比，本文設計的數字控制方法能夠顯著的提高sld光源的出纖光功率和光譜的穩定性（包括溫度穩定性和時間穩定性） 。
  9. In the forth chapter, the performances of mr dampers designed and fabricated at chongqing university have been tested in national center for test and supervision of coach quality, including schematics of damping force vs. displacement of piston head, damping force vs. velocity of piston head, etc. for some given electric currents of the coil. the experimental results demonstrate that damping force offered by mr damper consists of background damping generated by resistance of mr fluid and damping caused by magnetic field

    對不同勵磁電流條件下的理論阻尼力與測試阻尼力進行了比較，分析了產生誤差的主要原因；對阻尼器產生溫度效應產生的主要原因進行了分析，提出了應該提高磁流變體的溫度穩定性；推導了磁流變體的感性和容性流動方程，從理論上分析了磁流變體的感性和容性對阻尼器特性的影響。
  10. Firstly, the temperature varies in a large range in the place where the gap sensor works, so this paper analyzes the temperature drift of gap sensor, and finds out that the main reasons which result in temperature drift are the resistance of detecting coil and demodulating circuit parameters. to resolve this problem, a practical design of detecting coil is given, and a compensative measure considering the detecting coil and demodulation circuit is proposed to improve the temperature stability of gap sensor

    首先，針對間隙傳感器工作環境溫度變化較大的情況，本文對間隙傳感器溫度漂移現象進行了分析，認為檢測線圈電阻和檢波電路參數變化是造成傳感器溫漂的主要原因，建立了檢測線圈的數學模型，提出了檢測線圈和檢波電路綜合補償方法，解決了間隙傳感器的輸出信號溫度穩定性的問題。
  11. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電光應用試驗表明：用離子交換法製作的電光波導，其離子交換濃度、折射率變化符合餘弦誤差函數，光學均勻性以及器件的溫度穩定性較好；製作的強度調制電光開關，消光比為150 ： 1 ，對1064nm激光的插入損耗為2 . 5 ；製作的電光調制器用於激光脈沖整形試驗，從脈沖寬度50ns的激光脈沖削出脈寬1ns的高質量光脈沖，該電光開關經過長達三年多的使用，沒有出現晶體變黑現象，說明本實驗的低電導率ktp晶體能夠耐受長時間的調制電壓。
  12. The bats can simulate well on the temperature value and change of surface soil and subsurface soil, which can reflect very well that the daily changed temperature of subsurface is obviously lower than that of surface. snowmelt is considered in the computing of mohe ' s soil temperature, which decrease the effect of forced comeback. in the result, the characteristics of temperature stablization in snowmelt time span and the variety trend in other time span also are well simulated

    2 ） bats模式對漠河表層和次表層土壤溫度的變化趨勢及量值有很好的模擬性能，能夠反映出次表層土壤比表層土壤溫度日變化幅度明顯減小的特點，在對漠河融雪期間土壤溫度的計算過程中，考慮了雪融，減小了強迫恢復作用，對融雪期間溫度穩定少變的特點也能很好地模擬出來。
  13. The exactment and stability of current and temperature for the instrument is achieved the aim and meet the design requirement

    驅動電流精度和溫度穩定度都達到了預定的目標，滿足了設計要求。
  14. Theoretical study on temperature stability of precision temp - enclosure

    精密控溫箱內腔溫度穩定性的理論研究
  15. In the paper, we put forward the combination of micro electronic technology, mems technology and vacuum micro electronic technology to develop a micro electronic pressure sensor with overload protection. the pressure sensor consists. of elastic anode membrane, isolation layer, vacuum micro cavity and field emission catelectrode tip array with overload protection. such pressure sensor has many advantages, such as high temperature stability, radiation resistance, fast response, high sensitivity, small volume, simple secondary instruments and bulk production

    本文在重慶市科技「十五」項目的資助下，提出利用微電子技術、 mems技術和真空電子技術相結合的方法，研究一種帶過保護功能的真空微電子壓力傳感器，該壓力傳感器由帶過保護的場致發射陰極錐尖陣列、彈性陽極膜、絕緣層、真空微腔所構成，具有溫度穩定性好、抗輻射、快響應、高靈敏、體積小、二次儀表簡單、可批量生產等優點，具有廣泛的應用市場。
  16. This reduced temperature dependence permits a simplified drive circuit and reduces the need for temperature stabilization.

    與溫度的關系變得不密切，也就使驅動電路簡化並減少對溫度穩定的要求。
  17. The main purpose of this thesis is to improve the 3mm vcos frequency stability that work in harmonic to obtain the more strict demands of new electronic equipments

    本文主要任務是改善原有3mm壓控諧波振蕩器的頻率溫度穩定度，使其滿足系統對3mm振蕩源越來越高的要求。
  18. Because mz interferometric optical fiber gyroscope has bigger nonreciprocal phase, the system thermal stability, polarization noise and the error caused by the fluctuation of light source is particular analysed, some effective methods is proposed such as : using the " quasi - white - light " interferometry and the fiber polish technology accurately to control the fiber length, using depolarization light to minish the polarization error, and using temperature control, optical power control and depolarizer to stabilize the output of the light source

    結合mz干涉式光纖陀螺的存在較大非互易相移的特點，著重從其溫度穩定性、偏振噪聲以及光源波動引起的誤差三個方面分析了抑制噪聲、提高檢測精度的方法，提出了：採用「準白光」干涉測量法結合光纖研磨技術精確控制光纖長度差的辦法；採用非偏振光源抑制偏振噪聲的方法；採用溫度控制、功率控制以及消偏器實現穩定化陀螺光源的方法。
  19. The dma 38 requires very little sample and performs a measurement quickly and accurate to 3 - digits. a built - in solid state thermostat automatically ensures stable measuring temperatures between 15 and 40 c

    Dma 38要求極少的樣品量，測量快速且精確度可達3位數。內置一個固態自動調溫計以確保測量溫度穩定在15 - 40 c
  20. Introduced a new way for dispersion compensation in transmission using uniform fiber bragg gratings. at the last, the analysis of fiber grating production with a phase mask was carried out. based on diffraction and interference theories, we access the near - field optical intensity distributions produced by a periodic mask and draw the important conclusion that we must put the mask near the fiber as we can in the experiment

    最後論文討論了光纖光柵的製作，分析了掩膜板后干涉光場的分佈，指出了掩膜板製作應該盡量實現零級抑制，且在系統調試中，光纖要盡量靠近掩膜板放置這一重要結論，在此基礎上利用現有實驗設備製作出了光纖光柵，研究了不同曝光條件對光柵製作的影響，並利用實驗分析了光柵的溫度穩定性。
分享友人
分享到 Line

分享到臉書