溫水浸漬 的英文怎麼說

中文拼音 [wēnshuǐjìnzì]
溫水浸漬 英文
warm water retting
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 漬 : Ⅰ名詞1 （地面的積水） floodwater on low lying land 2 [方言] （積在物體上難以除去的油泥等） stain;...
  • 溫水 : hot water; warm water溫水箱 reservoir; 溫水養殖 warm water cultivation; 溫水游泳池 heated swimmin...
  1. In this paper, the aqueous sol of sno2 ultrafme particles were prepared by the colloid chemistry method. here we found that the partical properties of sno2 was concerned with experimental parameters such as type of peptization acid, sn4 + concentration, peptization time, peptization temperature, ageing time et al

    本文採用膠體化學法制備了sno _ 2納米粒子水溶膠，細致研究了膠溶酸類型、 sn ~ （ 4 + ）濃度、膠溶溫度、膠溶時間、陳化時間等對納米粒子性質的影響，並利用浸漬提拉法制備了sno _ 2超微粒子薄膜。
  2. The results showed that : there were five stages in the rising process of the internal temperature of untreated, fire - retardant solution soaked, and fire - proof paint coated wood during the fire ; the carbonization rate of wood decreased by 21. 1 % ~ 35. 6 % and the rising speed of internal temperature also declined greatly when wood was soaked in fire - retardant solution or coated with fireproof paint ; the carbonization rate of white pine was 8. 5 % ~ 17. 4 % higher than that of the northeast china ash ; for untreated wood, the carbonization rate in tangential direction was 5. 8 % ~ 10. 5 % higher than that in radial direction ; the internal temperature of wood varies with the developing direction of combustion

    結果表明：火災發生過程中未處理木材、阻燃浸漬處理和塗刷防火徐料木材內部溫度上升過程出現5個階段；經過阻燃浸漬處理和塗刷防火塗料后，木材的燃燒炭化速度降低了21 . 1 % ~ 35 . 6 % ，內部溫度上升速度大幅度下降；白皮松木材的燃燒炭化速度比水曲柳木材的燃燒炭化速度快8 . 5 % ~ 17 . 4 % ；未處理木材沿弦向的燃燒炭化速度比徑向快5 . 8 % ~ 10 . 5 % ；木材內部的溫度變化沿燃燒推進方向不同而不同。
  3. In order to make clear the regulation of the combustion and the heat - transport process of fire - retardant treated wood, the combustion of untreated, fire - retardant solution soaked, and fire - proof paint coated white pine ( pinus bungeana ) and northeast china ash ( fraxinus mandshurica ) wood as well as the rising process of temperature at different sites in wood were measured in this study, taking a multi - function fire - proof experiment oven to simulate the typical process of fire

    摘要為了弄清楚阻燃處理木材的燃燒及其熱傳導規律，該研究採用多功能耐火實驗爐模擬典型火災的發生過程，測定了未處理、阻燃劑水溶液浸漬處理、塗刷防火塗料白皮松和水曲柳木材的燃燒及木材內不同位置的升溫過程。
  4. Soak specimen in warm after a specified time then observe whether specimen surface had degenerative conditions as blister, fadeaway, swell. … etc. to judge its quality and calculate the change rate of weight before / after test

    恆溫水槽：材料經本水槽一定時間之溫水浸漬試驗后，觀察是否變質，表面有無起泡、褪色、膨脹等現象，以判暄品質，亦可計算試驗前後之重量變化率。
  5. Standard test method for saltwater pressure immersion and temperature testing of photovoltaic modules for marine environments

    海洋環境用光電組件的鹽水壓力浸漬試驗和溫度試驗的標準試驗方法
  6. Here is a loving portrait of a man who lived for fishing, who had “ the bay of biscay breaking in his eyes ”, who “ spread the black honeycomb of his nets wide on the waters, filled them with the salt sweetness of the sea, lifted them dripping with moonlight and fish

    這是一幅以漁為生的男人溫情的肖像描畫： 「比斯開灣闖入他的眼簾」 ， 「在海面上，他遍撒下黑色蜂窩狀漁網，將其浸漬于海水咸津的香甜之中，隨後起網，便捕獲到滿兜的魚兒連同月光。
  7. After dipped in amino trimethylene phosphonic acid ( atmp ) solution, anodic oxide films are annealed in pipe stove. the influences of concentration and temperature of atmp solution and annealing temperature on rising time, withstanding voltage and specific capacitance of anodic oxide films are studied. after hydration, anodic oxide films treated with atmp or not are analyzed by ft - ir

    2 .將化成箔在氨基三甲叉膦酸（ atmp ）溶液中浸漬，取出烘乾后再進行熱處理，研究了atmp溶液濃度、浸漬溫度和熱處理溫度對氧化膜升壓時間、比容、耐電壓的影響，找到其最佳耐水合處理工藝;採用ft - ir對水合作用后的atmp處理氧化膜和未經耐水合處理氧化膜進行了分析。
  8. The optimum concentration and temperature of dtpmp solution and optimum annealing temperature are discussed. in addition, hydration resistant effect of anodic oxide films treated with adp, atmp and dtpmp respectively is discussed through ft - ir, xps, afm and i - v characteristics testing

    探討了dtpmp溶液濃度、浸漬溫度和熱處理溫度對氧化膜升壓時間、比容、耐電壓的影響，並找到其最佳耐水合處理工藝;同時採用ft - ir 、 xps 、 afm和i - v特性測試對adp 、 atmp 、 dtpmp三種試劑對氧化膜的耐水合處理效果進行了對比研究。
分享友人
分享到 Line

分享到臉書