溫水迴路 的英文怎麼說

中文拼音 [wēnshuǐhuílù]
溫水迴路 英文
warm water return
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 溫水 : hot water; warm water溫水箱 reservoir; 溫水養殖 warm water cultivation; 溫水游泳池 heated swimmin...
  1. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下，當裝置穩態功率變化時，冷卻劑平均溫度與蒸汽壓都保持不變，與通常採用的冷卻劑平均溫度恆定運行方案相比，有效地改善了核動力裝置的總體運行性能，特別是在低負荷運行時，可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件，這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  2. Safety device containing an audible alarm will break the circuit automatically when the pump is overloaded, temperature overheats or there is a shortage of oil or water

    設想周到的各種電子保護裝置，如無熔絲開關，缺水或缺油，溫度異常及泵浦過負荷等自動警示系統，迴路能自動切斷，確保安全。
  3. Genetic algorithm is used to optimize the parameters of pid controller that is used to control the plant lon ( local operating network ) is designed to control vav air - conditioning system. by this means the static pressure control and minimum total supply air volume control are experimented. the paper analyzes the coupling among loops, the whole system ' s stability and energy saving effect under the two control methods

    針對目前變風量空調系統的模型都是用機理建模方法建立的情況，本論文用最小二乘法對機組部分進行系統辨識，建立了水閥?送風溫度、變頻風機?靜壓兩個迴路的模型，經驗證比較接近實際系統；採用遺傳演算法對pid控制器的參數進行尋優，尋優結果令人滿意；設計了變風量空調系統的lon控制網路，以此為實現手段，進行了定靜壓控制和最小總送風量控制，並在兩種控制方式下，分析了各個迴路的耦合情況、兩種控制方式的穩定性和節能效果。
  4. After we analyses fully the factors of influencing the feed water, combustion and steam temperature, compare controlling program, design circuits of feed water, combustion and steam temperature

    燃燒和蒸汽溫度擾動的各種因素和對控制方案進行分析?比較的基礎上，對沸騰爐給水控制迴路?燃燒控制迴路和蒸汽溫度控制迴路進行了具體的設計
  5. By use plc, system can complete function as follow : this auto - control system be applicable to the temperature and smoke and dust the deal the variety quick, control the process is difficult with the operation is ; by the temperature controlor can automatically follow to the wet tower " exit temperature, error in the ? 3 v including ; by to automatically spray fog to lower the electric resistance, with the function for full the electricity equipment accepting the dust ; because of adopting feedback closed loop, and come to a to respond to the speed quick, constant temprature control the accuracy is high ; because of adopting the sensors, and make the system circumstance to leak water quick ; system have many control parameter can set exit control temperature and adjust value low limit by key ; can communication with remote computer and have remote control

    通過使用plc ，使該自控系統可以完成如下功能：適用於溫度及煙塵量變化快、控制過程難以操作的場合；通過溫控表自動跟蹤增濕塔出口溫度，誤差達到3以內；通過自動噴霧來降低粉塵比電阻，以此充分發揮電收塵器的作用；由於採取了閉環反饋迴路，達到了響應速度快，恆溫控制精度高；通過使用各種檢測傳感器，使得異常情況泄水快；該自控系統具有多套控制參數，增濕塔出口控制溫度及調節閥下限值可通過按鍵設定；可與上位機通訊，具有「現控遠控」功能。
  6. Water in the primary circuit is maintained at a high temperature of over 300 degree c under high pressure of above 150 bars to prevent it from boiling

    在運作期間，一迴路的水溫會高達攝氏300度以上，並保持150巴以上的高壓，以防沸騰。
分享友人
分享到 Line

分享到臉書