溶度 的英文怎麼說

中文拼音 [róngdù]
溶度 英文
dissolubility
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  1. Solubility products are sometimes known with similar accuracy.

    溶度積時有時也具有同樣的準確度。
  2. Essential oils - evaluation of miscibility in ethanol

    香精油.乙醇中混溶度的評估
  3. Swelling test, dsc and tg were used to determine the solubility parameter, glass - transition temperatures and thermolysis temperatures of polycondensates

    使用溶脹試驗、 dsc 、 tg對其溶度參數、玻璃化轉變溫度、熱分解溫度等參數進行了測定。
  4. In order to improve its cycle performance and reduce capacity loss, we have synthesized series of lithium nickel manganese vanadate by using the moist chemical method in the reaction conditions of different temperature and calcination time. the structure characterization and element analysis tests are preformed by means of xrd, ir, raman and xps

    為了改善其循環性能以及減少充放電過程中的容量損失，我們對其中的ni2 +進行部分替代，採用濕化學方法合成出了錳對鎳不同取代量的產物linil _ 、 mn萬04 ，並結合xrd 、 xps 、 ir和r田刀an圖譜對其固溶度及摻入其中的錳的價態進行研究。
  5. At the initial stage of planar technique, b was employed as ideal diffusion impurity in base - region of npn si planar devices because of the match of its solid - solubility and diffusion coefficient in si with those of p in emission - region, and the good shield effect of sio2 film to b. but because of the relatively large solubility ( 5 1020 / cm3 at 1000 ) and the small diffusion coefficient, the linear slowly - changed distribution of acceptor b in pn junction can not be formed, which could not cater to the requirement of high - reversal - voltage devics. thereafter b - a1 paste - layer diffusion technology and close - tube ga - diffusion technology had been developed, while the former can lead to relatively large the base - region deviation and abruptly varied region in si, which caused severe decentralization of current amplification parameter, bad thermal stability and high tr ; the latter needed the relatively difficult pack technique, with poor repeatability, high rejection ratio, and poor diffusion quality and productio n efficiency

    在平面工藝初期，由於b在硅中的固溶度、擴散系數與n型發射區的磷相匹配， sio _ 2對其又有良好的掩蔽作用，早被選為npn硅平面器件的理想基區擴散源，但b在硅中的固溶度大（ 1000時達到5 10 ~ （ 20 ） ，擴散系數小， b在硅中的雜質分佈不易形成pn結中雜質的線性緩變分佈，導致器件不能滿足高反壓的要求，隨之又出現了硼鋁塗層擴散工藝和閉管擴鎵工藝，前者會引起較大的基區偏差，雜質在硅內存在突變區域，導致放大系數分散嚴重，下降時間t _ f值較高，熱穩定性差；後者需要難度較大的真空封管技術，工藝重復性差，報廢率高，在擴散質量、生產效率諸方面均不能令人滿意。
  6. Phase solubility analysis

    相溶度分析
  7. But the alloys fabricated by normal ingot metallurgy worsen the mechanical properties due to the coarse block - like or plate - like angular primary si particles. multi - layer spray deposit ( mlsd ) technology is a kind of rapid solidification with high cooling velocity up to 1 04 - 1 06k / sec, which can improve the microstructure, lessen segregation and increase the solid - solution of the alloy

    利用多層噴射沉積技術的高冷速（可達10 ~ 4k / s ） ，可顯著改善al - si合金的顯微組織、減少偏析、提高合金固溶度等，使合金性能得以大幅度提高，擴大其應用范圍。
  8. Study on the activity and dissolution of mgo in mgcl2 solution

    2溶液中溶度的研究
  9. Solubility measurement of ternary system lacl3 - bapoa - h2o

    的溶度測定
  10. Chemical products for industrial use. determination of liposolubility

    工業用化學製品.脂溶度的測定
  11. Ksp 25 270solubility product constants at

    溶度積常數
  12. Effect of temperature on the

    三維溶度參數的影響
  13. The application of xrd analysis on the measuring of the solubility of solid solution

    在固溶體固溶度測定中的應用
  14. The solubility - product constant ksp

    溶度積常數
  15. Concentration solubility product

    濃度溶度積
  16. Since viscosity of emulsion is important to elm separation process, it is necessary to research the viscosity of emulsion. during the study of separation of copper in the model industry waste by emulsion liquid membrane, some operating parameters are investigated, including the value of ph in the external phase, the concentration of acid in the internal phase, the concentration of copper in external phase, the concentration of surfactant, the kinds of carriers in the membranes phase as well as the concentration of carriers

    對乳液膜體系分離銅離子的研究，主要是考察分離條件（如外水相的ph 、內水相酸的濃度，外水相銅離子的濃度，載體種類、載體濃度、表面活性劑的濃度等）對銅離子提取程度的影響，通過實驗得到，外水相的ph值是乳液膜分離銅離子的一個重要原因，這主要是由於cu （ oh ） _ 2溶度積和界面反應的化學平衡決定的。
  17. The solubility - product constant

    溶度積常數
  18. Solubility product constants

    溶度積常數
  19. In recent years, by use of the characters including high - penetration ability of ga in sio2, small diffusion stress in si, large diffusion efficiency and large solid - solubility, open - tube ga - diffusion technology in sio2 / si system was realized

    近年來，巧妙地利用ga具有強穿透sio _ 2的能力，在si中具有擴散應力小、擴散系數大、固溶度較大等特點，實現了開管sio _ 2 si系下的擴散。
  20. The energy spectrum detect results show that electric field promotes the solution of cu element and well distribution, and accelerates the dissolution of undissolved - phase containing cu

    電場固溶后元素檢測結果顯示，電場提高了cu元素的固溶度，促進了cu元素的均勻分佈。
分享友人
分享到 Line

分享到臉書