溶液模型 的英文怎麼說

中文拼音 [róngyèmóxíng]
溶液模型 英文
solution model
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 液 : 名詞（液體） liquid; fluid; juice
  • 模 : 模名詞1. （模子） mould; pattern; matrix 2. （姓氏） a surname
  • 溶液 : solution; liquor; scald; aqua
  • 模型 : 1 （仿製實物） model; pattern 2 （制砂型的工具） mould; pattern3 （模子） model set; mould patter...
  1. ( 2 ) pbs nanoparticles with different morphologies, such as shuttle - like, rod - like, needle - like and spherical, were prepared in w / o microemulsion containing non - ionic surfactant op, iso - octyl alcohol ( or n - pentanol ), cyclohexane and aqueous solution

    （ 2 ）採用op異辛醇（或正戊醇）環己烷水溶液所形成的w o型微乳液作軟模板，合成出了梭形、棒狀、針狀和球形等不同形貌的pbs納米粒子。
  2. Finally, by studying the heat transfer coefficient and the mechanism of mass transfer through the membrane pores, a complete mathematical model was proposed for the removal of voc from dilute aqueous solutions by vmd

    根據對傳熱系數和膜孔內傳質機理的研究，最後得到了真空膜蒸餾脫除水溶液中voc全過程的數學模型。
  3. Knudsen diffusion model and the mixed flow model were solved numerically for the ethanol - water system. good agreement between experimental and theoretical values was found. but the mixed flow model is better

    乙醇水溶液的vmd試驗表明，兩種組分同時通過膜微孔時， knudsen擴散模型和過渡流模型都基本能反映實際過程，但過渡流模型更接近實際情況。
  4. In order to make clear the regulation of the combustion and the heat - transport process of fire - retardant treated wood, the combustion of untreated, fire - retardant solution soaked, and fire - proof paint coated white pine ( pinus bungeana ) and northeast china ash ( fraxinus mandshurica ) wood as well as the rising process of temperature at different sites in wood were measured in this study, taking a multi - function fire - proof experiment oven to simulate the typical process of fire

    摘要為了弄清楚阻燃處理木材的燃燒及其熱傳導規律，該研究採用多功能耐火實驗爐模擬典型火災的發生過程，測定了未處理、阻燃劑水溶液浸漬處理、塗刷防火塗料白皮松和水曲柳木材的燃燒及木材內不同位置的升溫過程。
  5. The disperse degree of the ceramic can greatly affect uniformity of the composite, which limit the poling voltage and affect the piezoelectricity. in this paper, the relationships among constitutes, microstructures, dielectric and piezoelectric properties were calculated by employing the banno unit cell mode ; pzt ceramic were synthesized by the hydrothermal method and the appropriate solution was selected according the adsorption of pvdf on the ceramic particle surface ; then, relationships between the disperse degree and the fabrication process were studied. base on these, the pzt / pvdf composites intermingled some pan were prepared and the microstructures were investigated

    論文首先利用bannounitcell模型，計算了pzt pvdf壓電復合材料的組成、結構、與其壓電和介電等性能之間的關系；針對壓電復合材料存在的均勻分散性差的缺點，選用水熱法制備的粒度均勻的pzt陶瓷粉末，並採用溶液混和法與聚合物pvdf進行分散復合，重點研究了不同工藝條件下陶瓷的均勻分散性及其與材料微觀結構之間的關系。
  6. Corrosion action slope cable used in cable - stayed bridge in different corrosion medium such as synthesis sea water, solution nacl and simulation acid rain are studied by electrochemical method, for example, linear polarization, tafel extrapolation and ac impedance method

    對此，本論文以人造海水、 nacl溶液、模擬酸雨作為腐蝕介質，針對不同類型的鋼絞線，採用線性極化法、 tafel外推法和交流阻抗法等電化學方法研究斜拉橋拉索結構中鋼絞線在不同介質中的腐蝕行為。
  7. In order to improve the utilization efficiency of energy and equipment, a general steady simulation model of complex cross - feed multi - effect evaporation was established for the purpose of in - depth research on rule of multi - effect evaporation. in this model, the energy - saving measures, including extra steam being led off to preheat material liquid, the condensation water flash and solution flash, were adopted, and the solid separation was also considered in the process of evaporation

    為了提高多效蒸發系統能量與設備的利用效率以及深入研究多效蒸發過程的規律，建立了帶有冷凝水閃蒸、溶液閃蒸和引出額外蒸汽預熱原料液等節能措施並考慮蒸發過程有固相析出的復雜錯流多效蒸發穩態模擬通用模型。
  8. Abstract : the model parameters for uniquac and nrtl equations are obtained by using the infinite dilute activity coefficients of a component at several temperature and the nonlinear regressive technique. the vaporliquid equilibrium ( vle ) data calculated by using the parameters for uniquac or nrtl equation is agreement with that from vle experiment

    文摘:通過一個組分在不同溫度下的無限稀釋活度系數，利用非線性回歸確定了四氫呋喃1 ， 4丁二醇、水1 ， 4丁二醇二元體系的uniquac 、 nrtl溶液模型參數.用所獲得的兩溶液模型參數對三元氣液平衡數據進行理論推算，並與實測的三元氣液平衡數據進行比較，發現兩結果比較吻合
  9. The results show that wilson equation and the regular solution model are suitable for the strong positive deviation systems, but not for the strong negative and coexisted deviation ones

    結果表明： wilson方程和正規溶液模型對強正偏差體系比較適合，不適用於強負偏差體系和混合偏差體系。
  10. Correlations of aqueous solubility of amino acids by a modified regular solution model

    應用改進的正規溶液模型關聯氨基酸在水中的溶解度
  11. So the fitting effect of mivm is better than that of the regular solution model in binary solid alloys

    分子相互作用體積模型在二元固態合金中的活度擬合效果優于正規溶液模型。
  12. As to the weak deviation systems, they are fitted well with wilson equation and regular solution model

    對於弱偏差體系，兩者的擬合效果都較好。相對來說， wilson方程要優于正規溶液模型。
  13. Relatively, wilson equation fits better than regular solution model, but the symmetrical systems are fitted better with regular solution model

    對于其中的對稱體系，則正規溶液模型的擬合效果更佳。
  14. But it is not for the regular solution model, because the influence of temperature has been taken into account when the parameters are calculated

    正規溶液模型在計算二元系參數時已經考慮了溫度的影響，則未發現此類現象。
  15. In this thesis, the thermodynamic properties of 24 binary al - based liquid alloys are then fitted with wilson equation and the regular solution model

    隨后利用wilson方程和正規溶液模型對24個二元鋁基液態合金體系的熱力學性質進行了擬合。
  16. The molecular interaction volume model ( mivm ) and the regular solution model have been applied to fit the activities of components in 37 binary solid alloys

    摘要應用分子相互作用體積模型和正規溶液模型對37個二元固態合金體系的組元活度進行了擬合。
  17. The results also show that wilson equation and regular solution model are not suitable for the systems that had immiscible gaps in the liquid phases

    對于存在液-液分層現象的體系， wilson方程和正規溶液模型的擬合效果都較差，都不適合於這類體系的熱力學性質計算。
  18. The comparison of application of wilson equation and regular solution model in the al - based liquid alloys shows that the suitability of regular solution model is restricted because it is only fit for the systems in which the components has the approximate size and structure

    Wilson方程和正規溶液模型在二元及多元鋁基液態合金體系中的比較研究表明：正規溶液模型因為原則上只適用於組元的分子大小和結構相近的體系，其適用范圍受到了限制。
  19. Abstract : according to characters of different research ways, the research development of thermodynamic models of metallic melts is systematically introduced, such as solution model method, geometrical model method, interaction coefficient method, analytical method and experienced model method

    文摘:根據不同研究方法的特點，綜述了溶液模型法、幾何模型法、相互作用系數法、解析計演算法以及經驗模型法等金屬熔體熱力學模型的研究進展，並對這些方法進行了簡要的評述。
  20. Then based on the results in binary liquid alloys, thermodynamic properties of 6 ternary and 1 quaternary liquid alloys are predicted and compared. for most multi - component systems that are investigated, the predicted activities of al with wilson equation are in better agreement with the experimental results

    在對二元系進行比較分析的基礎上，又利用wilson方程和正規溶液模型對6個三元系和1個四元系的組元活度進行了預測和比較研究。
分享友人
分享到 Line

分享到臉書