溶液稀釋法 的英文怎麼說

中文拼音 [róngyèxīshìfǎ]
溶液稀釋法 英文
cutback method
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 液 : 名詞（液體） liquid; fluid; juice
  • 稀 : Ⅰ形容詞1 （事物出現得少） rare; scarce; uncommon 2 （事物之間距離遠; 空隙大） sparse; scattered 3...
  • 釋 : Ⅰ動詞1 （解釋） explain; elucidate 2 （消除） clear up; dispel 3 （放開; 放下） let go; be reliev...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 溶液 : solution; liquor; scald; aqua
  • 稀釋 : [化學] dilution; thinning; attenuation; deliquate; dilute稀釋處理化 dilution; 稀釋劑 diluent; att...
  1. Standard test method for resin solution dilutability by volumetric gravimetric determination

    容積重量測定法測定樹脂溶液稀釋度的標準試驗方法
  2. Paints and varnishes - determination of " soluble " metal content - part 7 : determination of mercury content of the pigment portion of the paint and of the liquid portion of water - dilutable paints - flameless atomic abs

    色漆和清漆"可溶性"金屬含量的測定第7部分:色漆的顏料部分和水可稀釋漆的液體部分的汞含量的測定無焰原子吸光譜法
  3. Standard test method for dilution ratio of active solvents in cellulose nitrate solutions

    硝酸纖維素溶液中活性溶劑稀釋比的標準試驗方法
  4. Immobilization of polylysine ( pll ) onto hec and chitosan - coated membranes via activation reagents provided pll affinity membrane, respectively. a simple method for quantitative analysis of solid chitosan based on the ninhydrin reaction was achieved by diluting the reaction solution with 50 % ( v / v )

    以高濃度的茚三酮顯色液與固體殼聚糖反應，再採用乙醇水溶液稀釋反應液的方法，解決了固載在基材上殼聚糖含量的測定問題。
  5. Aim : to analyze the mechanism, thermadynamic theoretical basis, dynamic mechanism and influencing factors of thermally induced phase separation ( tips ) in order to completely grasp the factors affecting the size, distribution and form of pores, so that the adjusted range of pore can be widened and the preparation of porous membrane can be repeated and controlled. methods : considering from the structural characteristics of tissue engineered materials, the methods of preparing porous membrane using tips technique, the hermadynamic theoretical basis, dynamic mechanism and influencing factors were analyzed, the problems and investigative directions in the future were also analyzed. tips technique is a process of phase separation of polymer homogenous solution under quenching, and it is suitable for diameter and structural form of the micropore materials prepared using tips are closely correlated with the kind and dispensing proportion of polymer attrnuant, polymer concentration and polymer molecular mass, etc. conducted, including determination of polymer - solvent system phase diagram, study of form and appearance of porous membrane of different thickness, study of form and appearance of porous membrane prepared with systems of different x, which is the parameter of polymer - solvent interaction

    目的:分析熱致相分離成膜過程的機理、熱力學理論基礎、動力學機制以及影響因素，以便充分掌握影響孔度大小、分佈、形態的因素，使孔度調控范圍得以拓寬，使多孔膜的制備能重復可控.方法:從組織工程材料結構特點出發，分析熱致相分離聚合物多孔膜的制備方法及該法成膜的熱力學理論基礎、動力學機制以及影響因素.並分析實驗中存在的問題及今後的研究方向.結果:以熱致相分離法可制備聚合物多孔膜.熱致相分離法制備多孔膜是高聚物均相溶液在淬冷條件下發生相分離的過程，它適用於上臨界共溶溫度型聚合物一稀釋劑二元體系.熱致相分離法成膜的過程，可以認為是旋節線機理佔主導地位.熱致相分離法制備的微孔材料，其孔隙率、孔徑大小、結構形態與聚合物稀釋劑的種類、組成配比、聚合物濃度、聚合物分子量等因素密切相關.結論:可採用熱致相分離技術制備多孔膜，通過改變不同的成膜條件可獲得一系列不同孔徑尺寸和孔徑分佈的多孔膜材料.對熱致相分離成膜過程中聚合物-溶劑體系的相圖測定，不同厚度的多孔膜形貌研究，不同x （聚合物-溶劑相互作用參數）體系所制備的多孔膜形貌等需深人研究
  6. Nuclear energy - chemical separation and purification of uranium and plutonium in nitric acid solutions for isotopic and dilution analysis by solvent chromatography

    核能.用溶劑色譜法對同位素和稀釋度分析用的硝酸溶液中鈾和鈈的化學分離和提純
  7. It was showed that mipm between 50 - 300 ? m with macro - pores could be prepared via both seeds swelling and suspension polymerization method and suspension polymerization method, the former method could prepared the mipm with narrower size distribution while the later one was easier to carry out and more time - saving. the morphology of the mipm was influenced by many factors including swelling solvent, stirring speed, dosage of seeds, dispersant, dilute and progenic solvent

    M的、具有大孔結構的mipm ，前者的產物具有相對較窄的粒徑分佈，但後者的制備工藝則較簡單、制備周期也較短；溶脹劑、攪拌速度、種球用量、分散劑、稀釋劑和致孔劑是影響產物微球形態的主要因素；乳液聚合法能夠制備得到0 . 16 - 0 . 56
分享友人
分享到 Line

分享到臉書