溶液電導法 的英文怎麼說

中文拼音 [róngdiàndǎo]
溶液電導法 英文
electric conductivity method of solution
  • : 動詞(溶化; 溶解) dissolve
  • : 名詞(液體) liquid; fluid; juice
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : 動詞1. (引導) lead; guide 2. (傳導) transmit; conduct 3. (開導) instruct; teach; give guidance to
  • : Ⅰ名詞1 (由國家制定或認可的行為規則的總稱) law 2 (方法; 方式) way; method; mode; means 3 (標...
  • 溶液 : solution; liquor; scald; aqua
  1. The results showed that the conductive composites including expanded graphite filler have the best conductive property when they were produced with the same processing. and the solution intercalation is the best methold to produce the lowest percolation threshold conductive composites when a type of conductive filler was used. because of the flam - retardant property of the graphite, we also studied the composites " flammability

    研究結果表明,採用同一種工藝條件,以膨化石墨作為填料的復合材料的性能最好;而採用同一填料以插層制備的復合材料的性能最好。
  2. In this article, the bellcore method was used to prepare polymer electrolyte membrane based on pvdf - hfp, and polymer electrolyte membranes under different conditions were prepared by changing sorts of solvents 、 ratio of dbp and solvent. effects of ratio of plasticizer and solvent on the liquid uptake 、 sem 、 mechanism capability 、 ionic conductivity 、 electrochemical stability window of polymer electrolyte membrane were also studied. through optimizing the preparation technics, the integrated effects of additives such as pc 、 ec 、 dbp and nanophase al2o3 on the ionic conductivity 、 liquid uptake were studied

    本文以聚偏氟乙烯-六氟丙烯共聚物pvdf - hfp為基質,採用bellcore制膜制備了pvdf - hfp聚合物解質膜,通過改變增塑劑dbp的含量、劑的種類及劑的含量制備了不同條件下的聚合物解質膜,分別研究了增塑劑含量、劑含量等對聚合物解質膜的吸率、表面形貌、機械性能、離子率、化學穩定窗口等的影響;對制備工藝進行了優化,研究了各種添加劑如pc 、 ec 、 dbp及納米al2o3對聚合物解質膜的離子率、吸率等性能的綜合影響。
  3. This paper gives a method to measure the conductivity base on choosing frequency. after adding to the electrode with two ac square waves of appropriate frequencies, we can measure the output dc voltage of the circuit

    本論文提出了一種選頻率測量方,選擇兩個合適頻率的交流方波施加於極,測出路輸出直流壓,通過解方程組求出時間常數,然後求得阻,進而得到率。
  4. The conductivites of a super - saturated caco3 solution with and without the addition of a scale inhibitor were measured

    這種方基於率測定原理,是通過在加入阻垢劑和不加阻垢劑的特定水環境下測定各種成垢化合物的過飽和度來實現。
  5. Finite difference time - domain method is used to calculate the reflection for these probes and absorbing boundary condition is used to deal with the singularity in the axis of the coaxial - line in the simulation. by comparing the reflection of different probes, the best probe has been selected according to sensitive requirement. the influence of parameters : such as thickness of protective film, length of protruding inner conductor of the coaxial - line probe to the measurement has been studied

    通過時域有限差分進行數值模擬分析,並採用吸收邊界處理同軸線軸心奇異點,計算出各種探頭測量相同的反射系數,根據其測量的靈敏度,選出最優設計;並通過分析所選探頭的各種設計參數,如薄膜厚度、內體伸出長度等的變化對測量結果的影響,找出該探頭各參數的最佳范圍,使其具有高度靈敏性,以適用於測量化學反應的介常數。
  6. In this thesis, the mechanism of high conductivity along c direction in ktp crystal grown by high temperature solution method was firstly elucidated. a scheme of doping certain elements to reduce the conductivity of ktp crystal along c direction was put forward

    本文首先闡述了致高溫生長的ktp晶體c向率較高的形成機理,提出採用摻入特定元素的離子來降低ktp晶體c向率的方案。
  7. Abstract : in this paper the synthesis methods of silver nanostructure materials, such as nanocubes, triangular nanoprisms, nanorods, nanowires, nanotubes, dentrites, flake, nanodisks, nanobelts, and so on, were introduced, the methods include reducing precipitation, photoinduced conversion, irradiation reduction, electrodeposition, template, microwave - assisted, ultrasonic - assisted, hydrothermal assemble, microemulsion, and so on

    摘要:介紹了納米立方體、三角形納米稜柱、納米棒、納米線、納米管、樹枝狀、片狀、納米盤、納米帶等納米結構銀的制備方,包括還原沉澱、光誘轉化、輻射還原化學沉積、模板、微波或超聲波輔助、水熱、微乳等。
  8. Test solutions of electric conductivity analyzers. preparation method of sodium chloride solutions

    率儀的試驗.氯化鈉制備方
  9. ( 3 ) the piezoelectric quartz crystal impedance ( qci ) technique was employed to monitor in situ the pb2 + - induced precipitation of bsa onto a gold electrode and the precipitate dissolution via edta in an aqueous solution

    ( 3 )用壓石英晶體阻抗( pqci )現場監測了水中鉛離子誘牛血清白蛋白( bsa )沉澱及沉澱由na _ 2edta解的過程。
  10. Relation between concentration of salt in aqueous solution and its conductivity

    確定水中鹽的濃度
  11. Open the fluid inclusion by heat explosion, extract the ore - forming solution, measure the relative density of the ore - forming solution through its electric conductivity, and apply the results to the test of mineralization and ore - search by geological analogy

    用熱爆打開包裹體提取成礦,以度度量其相對濃度,以地質類比通過從已知到未知的分析,將其結果用於成礦找礦試驗。
  12. In attempt to prepare and study the novel electrically conductive nanocomposites, with polyethylene ( pe ) served as the matrix, maleic anhydride grafted polyethylene ( gpe ) served as eg intercalates and expanded graphite ( eg ) served as a conductive filler, prepared gpe / eg, pe / gpe / eg electrically conductive composites via solution intercalation ( si ), direct melt mixing ( dmm ) and master batch melt mixing ( mmm ) methods. by means of testing conductivity and mechanical property, with the measures of tem, sem, om, xrd and dsc, studied the relationship between preparation method, material composition, and electrically conductive as well as mechanical property. the main outcomes never reported at home and abroad literature were obtained as follows : 1 the gpe / eg electrically conductive nanocomposites were prepared via si method

    本論文以制備和研究新型高分子納米復合材料為目的,以聚乙烯( pe )為基體,馬來酸酐接枝聚乙烯( gpe )為插層劑,膨脹石墨( eg )為填料,採用插層( si )、直接熔體混合( dmm )和兩者相結合的熔體母料混合( mmm )制備了gpe eg 、 pe gpe eg復合材料,通過率和力學性能測試,運用tem 、 sem 、 om 、 xrd和dsc等手段,研究了制備方、材料組成、形態結構和性能及力學性能之間的關系,得到以下未見國內外文獻報道的研究結果: 1採用si成功制備了gpe eg納米復合材料,其逾滲閥值( _ c )為1 . 59vol ,遠低於dmm制得gpe eg常規復合材料的_ c ( 3 . 13vol ) 。
  13. The studies made in the thesis are summarized as follows : 1. a series piezoelectric quartz crystal ( spqc ) sensor has been applied to detect l - glutamic acid and l - lysine. the effect of formaldehyde on the frequency shift was studied

    本學位論文研究工作總結如下:一、利用串聯式壓石英傳感器對的靈敏響應用兩種方對l -谷氨酸和l -賴氨酸進行了定量測定,並探討了甲醛濃度對測定的影響。
  14. The best compositions and contents of aot reverse microemulsion in the work were studied by measuring the maximum amount of solubilizing water in micelles from the abrupt change of electroconductivity

    本文根據測定體系的最大增水量,從而分別確定了在現有實驗條件下aot微乳體系各組分的種類和相應的濃度范圍。
  15. After the precise measure liquor conductivity under certain temperature, the temperature compensation of conductivity is studied in this paper. the method of temperature compensation with single chip machine is studied emphasizedly. the method include polyfiting formula and consulting scheme

    在解決準確測量某溫度下率基礎上,本文還對率的溫度補償作了總結和研究,重點研究了運用單片微機進行溫度補償的方,包括擬和經驗公式和查表。
  16. Preparation method of standard solution for the measurement of conductivity meter

    率儀測量用校準制備方
  17. Study on a new evaluation method of scale inhibitors based on solution conductivity measurement

    快速評定阻垢劑性能的試驗研究
  18. Standard test method for hydraulic conductivity compatibility testing of soils with aqueous solutions

    含水土壤的率相容性試驗的標準試驗方
  19. The pp / gpp / eg electrically conductive nanocomposites with ? c of 6 wt %, which was much lower than that of corresponding electrically conductive composites ( 11 wt % ) prepared via conventional melt - mixing, were firstly achieved via solution intercalation

    首次採用插層成功制備了pp gpp eg納米復合材料,其_ c值為6wt ,明顯低於常規熔體混合制得相應復合材料的_ c值( 11wt ) 。
分享友人