溶膠層 的英文怎麼說

中文拼音 [róngjiāocéng]
溶膠層 英文
sol layer
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 膠 : Ⅰ名詞1 （某些具有黏性的物質） glue; gum 2 （橡膠） rubber 3 （姓氏） a surname Ⅱ動詞（用膠粘） st...
  • 層 : i 量詞1 （用於重疊、積累的東西 如樓層、階層、地層） storey; tier; stratum 2 （用於可以分項分步的...
  1. Aerosols are present throughout the atmosphere.

    氣溶膠存在於整個大氣層。
  2. In the early 1960s a worldwide aerosol band was discovered in the lower stratosphere at 17-24km.

    在六十年代初期，在17-24公里平流層下部發現世界范圍氣溶膠帶。
  3. The present work indicates the organic nf membranes and the inorganic nf membranes all have shortages, so develop composite nf membranes that have low cost, mechanically strong and thermally / chemically - resistant, easy to cleanout and good performances is a very important task. in this paper, the preparation of inorganic - organic composite nf membranes were presented. this composite comprise a porous sio2 / al2o3 support substrate, the pore diameters of which ranging from 10 to 15 nm, this inorganic support substrate having a polymer membrane which comprises an polyvinyl alcohol ( pva ) or polyamide ( pa ) densely deposited on at least one of the face surfaces thereof, the structural porosity of such pva and pa membrane ranging from 3 to 5 nm

    本論文以開發無機?有機復合納濾膜為出發點，首先在al _ 2o _ 3多孔微濾膜上利用溶膠?凝膠法制備sio _ 2 al _ 2o _ 3無機復合超濾膜作為無機?有機復合納濾膜的基膜；選用聚乙烯醇和聚酰胺為表面功能層材料，分別探討了以羥基丁二酸和磺基水楊酸為混合交聯劑，採用浸塗法制備了聚乙烯醇sio _ 2 ? al _ 2o _ 3復合納濾膜；以均苯二甲酰氯、哌嗪和二胺為單體，採用界面聚合法制備了聚酰胺sio _ 2 ? al _ 2o _ 3復合納濾膜，並對影響膜性能的諸多因素進行系統研究。
  4. The limno2 synthesized by sol - gel method was orthorhombic phase and pmnm space group, with farthing impurity of mn2o3 。 the result of sem showed that the size of flake was about 1 ~ 2 m, the thickness of flake was about 50 ~ 100nm. the highest discharge capacity is 170. 7mah / g

    溶膠凝膠法所得limno2材料的xrd結果顯示，該材料為斜方晶系， pmnm空間群，有極少量mn2o3雜質; sem結果顯示其片層尺寸大約在1 ~ 2 m ，厚度大約為50 ~ 100nm 。
  5. Sulphur, a ubiquitous element in the lower atmosphere was identified from the outset as a predominant component in the stratospheric aerosol.

    在底層大氣中處處存在的元素硫從一開始就被認為是平流層氣溶膠的主要成分。
  6. Status and prospects of the sol - gel coating technology

    溶膠凝膠塗層技術的現狀與展望
  7. Fabrication and super - hydrophobic characteristics of fluororesin silica sol composite coatings

    硅溶膠復合塗層的制備和超疏水性能研究
  8. Effect of complex treatment of zinc - chromium coating by organic silicon sol on the corrosion resistance

    有機硅溶膠復合處理的鋅鉻膜塗層
  9. To investigate the space / time distributions and occurrence and evolution of such events, the diffusion pattern over deserts, turbulent transfer features in sandstorm weather, the particle size distribution, mass concentration and its distribution, optic properties, chemical composition and physical factors responsible for the initiation of raising sands, we made integrative observation and sounding of sandstorms deep in the large - scale desert area, including tengri, badanjilin and maowusu, with the items consisting of micrometeorological measurement, 3d wind observation, data from kb - 120 and anderson samplers of mass concentrations of sands with their spectrum, the distribution of aerodynamic particle sizes from the aps3310a, retrieval of aerosols " optic depth from sunphotometer data, assay of the chemical composition by means of neutron activiation analysis ( naa ) and integrated study of all related factors for causing sandstorm to occur, based on the observations of all kinds

    利用所取資料，系統分析了不同強度沙塵天氣條件下沙塵氣溶膠質量濃度和質量濃度譜、粒子譜分佈、光學厚度、化學組分等特徵；綜合分析了影響沙塵起動的諸物理因子在沙塵起動中的作用；用沙塵輸送模式對一次沙塵暴天氣造成的泥雨過程的形成機制進行了模擬。歷史氣象資料統計分析表明，沙塵暴有其高發期（ 4 、 5月）和高發時段（ 14 - 20時） ， 14時到20時之間發生的沙塵暴約占沙塵暴總次數的66 。揚沙和沙塵暴天氣條件下，湍流動量通量和湍流感熱通量都是重要的湍流交換，沙塵暴發生前近地層的超絕熱不穩定對沙塵暴天氣有加強作用。
  10. In this paper, the history, basic process and characteristic of the sol - gel theory and technology are first introduced in brief. then it presents the newly research progresses and the applications of the sol - gel method in preparing bulk, fiber, coatings and films, powder and complex materials. then the kind of sio2 - zro2 gel bulk glass - ceramic is prepared by using sol - gel method and the water - exchanging method

    本文首先簡要介紹了溶膠?凝膠理論和技術的歷史背景、基本工藝過程及特點，並著重評述了溶膠?凝膠技術在制備塊狀、纖維、薄膜與塗層、粉末和復合材料方面的最新研究進展及其應用；採用溶膠?凝膠法與水置換法制備了尺寸較大的sio _ 2 - zro _ 2系玻璃-陶瓷，採用分步水解法制備了摻釹sio _ 2 - al _ 2o _ 3激光玻璃-陶瓷。
  11. The doped material performed well electrochemical property for cycling. the initial discharge capacity of doped material was 165mah / g. after 80 cycles, the capacity loss was about 20 %

    使用溶膠凝膠法對層狀limno2進行2 % al3 +的摻雜改性，初始放電容量可達165mah / g ， 80次循環后衰減約20 % 。
  12. The structural characterization of v _ 2o _ 5 compounds were measured bymeans of differential thermoanalysis ( dta ) and thermogravimetry ( tg ), scanning electron microscopy ( sem ), and x - ray diffraction ( xrd ). the testsreveale that materials which were prepared by sol - gel ( inorganic sol gel andmelting - coling ) showed that the amorphous structure, and the interlayer spacingenlarge a lot than that of crystalline v _ 2o _ 5

    採用熱重與差熱（ tg - dta ） ，掃描電子顯微鏡（ sem ） ， x射線衍射（ xrd ）等測試手段對材料的結構性能進行表徵，結果顯示兩種溶膠-凝膠法（無機溶膠凝膠法和熔融淬冷法）制備的v _ 2o _ 5材料均為無定型結構，其層面間距均比晶體v _ 2o _ 5成倍增大。
  13. Xrd measurements showed that tio2 in the composites was anatase nano - crystallite with 5 - 10 nm size. sem images showed that some of the tio2 nano - crystallites coated on the surface of the mmt and some of them plugged into the gap between flakes of mmt. combining xrd result with sem images, it was clearly that the mmt and tio2 nanocrystallites formed a netlike nanocomposite structure

    用改性的溶膠凝膠法制備了一種mmt tio _ 2復合電流變顆粒， xrd ， sem分析證實tio _ 2是以納米晶的形式沉積于mmt的片層結構之間及顆粒表面，形成了一種網狀包覆的納米復合結構。
  14. Results show that the empty and porous balls of tio2 were grown on the surface of fine tourmaline particles dispersing in the tio2 film based on the copper net, under the effect of the nature electric field of fine tourmaline particles

    用溶膠?凝膠技術在紫銅網表面成功生長電氣石tio _ 2復合薄膜，該復合膜中電氣石微粒表面形成了tio _ 2空心球簇結構和tio _ 2層狀微粒簇結構。
  15. In this paper, tio2 films as ecological self - clean glass material prepared by magnetron sputtering method were discussed in the following aspects : the preparation technology of tio2 films by magnetron sputtering method, the control of the surface microstructure, the effect of the surface microstructure on the photocatalytic activity and the optical performance of tio2 films. sem was used to observe the surface topography. xrd was used to explore the crystal form, and crystal size

    為了解決以往溶膠?凝膠法制備的tio _ 2薄膜膜層質量不好的缺點，本論文對磁控濺射法在玻璃表面制備tio _ 2薄膜作為生態自潔凈玻璃材料進行了一系列探索與應用基礎研究，包括tio _ 2薄膜的磁控濺射法制備工藝、表面微觀結構的控制、表面微觀結構對tio _ 2薄膜光催化性能、透光性影響等。
  16. Two series of catalysts were preparated by co - deposition and sol - gel methods each. and each serie of catalysts was analysed by xrd spectrums, and was preparated to be air electrode with the optioned compoundings and manufacturing process. the cathode polarization curves were elementarily studied

    實驗還利用共沉澱和溶膠凝膠法合成了兩類催化劑，分析了其xrd譜圖，利用優化過的配方和工藝制備了空氣電極，初步研究了其極化曲線，並對其中最好的催化層進行了sem觀察。
  17. A new improved method of fiber tip fabrication was put forward, which is a coating technique of sol - gel tio2 film on the surface of the fiber tip for improve its anti - pollution capacity

    提出了傳感頭製作的改進方案，即採用溶膠-凝膠法在光纖尖上鍍一層tio _ 2膜來提高光纖尖的抗污染能力。
  18. In the experiments, two series of catalysts were synthesized by co - deposition and sol - gel methods each. the composition of both waterproof and gas diffusion layer and catalysis layer were optimized by the orthogonal test. meanwhile, quasi - steady cathode polarization curves, x - ray diffraction ( xrd ), scanning electronic microscope ( sem ) were used to analyst the relationship between the microstructure and the performance of air electrode

    實驗採用共沉澱法和溶膠凝膠法合成了兩類催化劑;對防水透氣層和催化層進行了正交試驗優化;同時，還採用測準穩態極化曲線， x射線衍射（ xrd ） 、掃描電子顯微鏡（ sem ）等分析測試手段，對空氣擴散電極催化材料、空氣擴散電極界面結構與性能的關系等作了較深入的研究。
  19. It ' s indicated that the zeta potential and total interaction energy of the colloidal particles are both at a maximum when the nitric acid concentration is 0. 22mol / l for the alumina sols with a mol ratio of 1 : 50 between asb and h2o,

    結果表明，膠體顆粒的雙電層厚度隨硝酸的濃度的增加不斷減小，對異丁醇鋁與水的摩爾比為1 ： 50系溶膠，硝酸濃度為0 . 22mol l時膠體顆粒的zeta電位和作用位能最大。
  20. It was demonstrated that in june and december, as far as the daily averaged rates were concerned, whether the aerosol concentration is the heat source or the cold one depends on the aerosol density. however, the relation bears nonlinear features. in the diurnal range, the effects of the aerosol radiative forcing on the atmospheric stability depend on the vertical distribution and density of the aerosol

    結果表明，從氣候角度而言，氣溶膠濃度的差別使得即使是在6月份，氣溶膠層既可以是冷源也可以是熱源從天氣尺度而言，氣溶膠的垂直分佈和濃度對層結穩定度有著重要影響，並由此從物理上指出了沙塵暴天氣過程中輻射效應所起的重要作用。
分享友人
分享到 Line

分享到臉書