溶解溫度 的英文怎麼說

中文拼音 [róngjiěwēndù]
溶解溫度 英文
digestion temperature
  • 溶 : 動詞（溶化; 溶解） dissolve
  • 解 : 解動詞（解送） send under guard
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 溶解 : dissolve; dissolution; solution; lysis; solvus; resolution; decomposition; resolving; solving; fu...
  • 溫度 : [物理學] temperature
  1. The method of obtaining high concentration of na2feo4 solution by quick electrolysis mainly contains four aspects : adoption of either a diaphragm or an ionic membrane electrolytic cell in which a thin anodic cell lying between the two cathodes, ( 2 ) using an iron anode that has larger specific surface area, ( 3 ) keeping suitable concentration of naoh in the anodic cell, adoption of lower current density and higher electrolyzing speed. the practical technique parameters follow a s below : the naoh solution of 14 - 16mol / l, the temperature of 303 - 308k, the surface anodic current density of 300a / m2, the unit electrolyzing speed of efficiency larger than 6. 0a / l

    快速電解獲取高濃度na _ 2feo _ 4溶液的方法，主要包括四個方面：採用兩陰極室夾一厚度較小的陽極室的隔膜（或離子膜）電解槽；使用比表面積較大的鐵網陽極；保持陽極室中有適宜濃度的濃naoh溶液；採用較低的電流密度和較高的電解速度。具體工藝參數是： 14 16mol / lnaoh溶液、溫度303 308k 、表觀陽極電流密度300a m ~ 2 、有效單位電解速度6 . 0a / l 。
  2. Swelling test, dsc and tg were used to determine the solubility parameter, glass - transition temperatures and thermolysis temperatures of polycondensates

    使用溶脹試驗、 dsc 、 tg對其溶度參數、玻璃化轉變溫度、熱分解溫度等參數進行了測定。
  3. The company is ready to supply various kinds of water soluble pva fiber whose linear density ranges from 1. 1 dtex to 2. 5 dtex, whose length is from 35mm to 50 mm, and whose dissolving temperature in water is not higher than 93

    我公司可根據客戶需要，提供纖度1 . 12 . 5dtex長度3550mm的各種水溶性聚乙烯醇纖維，水中溶解溫度93 。
  4. Besides, scan rate and cycle period also affect the result ; co - deposition of dualistic oxide is a focus of research, as an element in the same group, ir is selected. deposition rate of composition is decreased by the adding of ir composition, and when the proportion of ir exceeded 50 %, composition procession can be ceased. but cooperation of ir and ru oxide can highly increase the specific capacitance of active material ; annealing treatment under a certain temperature can help to change the hydrate ru composition into mixture state ru oxide, accordingly increase the stabilization of active material

    研究表明:電解液的配製過程中，氯化釕濃度、溶液ph值、陳化時間、溶液溫度對電鍍效果均有影響，其中溶液ph值是最主要的影響因素;在儀器的使用條件探索中，理論結合實驗確定了本電鍍液體系循環伏安電勢窗的理想范圍，並發現循環伏安掃描速度和掃描周期對電鍍結果也有較大影響;混合氧化物的共沉澱是目前研究熱點，在此選用與釕同一族的銥作為共沉澱元素，銥的加入會阻礙氧化物的沉積速度，銥的比例超過50 %會使沉積作用停止，但是二元氧化物的協同作用使沉積的活性物質比容量大大提高;一定溫度下退火后處理作用會使水合釕化物轉變成混合價態的氧化釕，從而提高活性物質的穩定性。
  5. Upper critical solution temperature, ucst

    最高臨界共溶溶解溫度
  6. Lower critical solution temperature, lcst

    最低臨界共溶溶解溫度
  7. Upper criticalsolution temperatures

    上臨界溶解溫度
  8. Surface active agents - determination of krafft point and solubility of ionic surface active agents

    表面活性劑.測定離子表面活性劑的臨界溶解溫度克拉夫特點和溶解度
  9. In normal operating configuration and as long as there is solids inside the reactor, the reactor temperature must never exceed the solubility temperature

    正常操作時，只要反應器里有固相，反應器的溫度就不能超過溶解溫度。
  10. Calculate the distibution of the melting temperature of the oligonucleotide probe sets that affymetrix uses for its microarrays

    計算用於微陣列的基因表達譜、和基因分型研究技術平臺使用的、低聚核苷酸探針裝置的溶解溫度分佈。
  11. Determine the relationship between the measured variability of gene expression in one or more data sets and the variation of the melting temperature within a probe set

    確定在一個或多個資料組的基因表達變化和探針裝置內部溶解溫度變化之間的關系。
  12. The maximum set point reference for the reactor temperature is a couple of degrees below the solubility temperature related to the last density measurement of the product in the reactor from the labs

    反應器溫度的最高設定點參考值為比反應器中產品在化驗室的最近密度測量值對應的溶解溫度低幾度。
  13. The nano - material precursors of metal alkoxides and theirs complexes are prepared by anodic dissolution of metal in non - aqueous media with a small quantity of ion - conductive additive and acetylacetonate under 3 0 - 40

    在無水醇體系中加入少量的導電鹽及乙酰丙酮，採用金屬陽極溶解法，控制電解溫度在30 - 40 ，電合成nio及zno的前驅體-金屬醇鹽的配合物。
  14. The nanoparticle titanium dioxide was prepared with tnb as raw material by the sol - gel process, the effects of the alcohol salt concentration the kind of solvent the water volume hydro1yze temperature. the dried ways of the wet gel and the calcined temperature of the dry gel on the specific surface area. particle size

    本文以鈦酸丁酯為前驅體，利用溶膠?凝膠法制備了納米級的tio _ 2粉體材料，通過正交實驗研究了醇鹽的濃度、溶劑的種類、水含量、水解溫度、乾燥條件和煅燒溫度等工藝條件對納米粒子的比表面積、粒徑大小及分佈、晶相組成等性能的影響。
  15. We apply the system to the ultra - fine grain steel welding, the simulated mean grain size in cghaz agreed well with the corresponding independent experimental data. in this paper, three factors influencing the grain growth, the steep temperature gradient in haz. the grain boundary liquid and the precipitates particle, were studied specially using mc technique

    研究表明溫度梯度造成的「熱釘扎」現象和晶界液化現象都對靠近熔合線附近的晶粒長大有明顯的阻礙作用，對最終的晶粒大小分佈有重要的影響：而800mpa超細晶粒鑰中的tin粒子山于溶解溫度高，抑制奧氏體晶粒長大的效果十分顯著。
  16. Abstract : a new simulating method is established for the calcul ation of the hardness profile of high - carbon - concentration deep - carburization, on the basis of analyzing this process and taking into account the influence o f carbide solution and dissolution, carbon - concentration and temperature on the diffusion behavior, and the influence of the environment factor on carbon trans fer through the gas - solid interface

    文摘:在對高濃度深層滲碳的特點進行分析的基礎上，考慮到碳化物的析出與溶解、溫度及碳濃度對擴散行為的影響，氣氛環境對相界面碳傳遞過程的影響，淬火烈度對滲碳層冷卻效果的影響，提出了一種新的模擬高濃度深層滲碳滲層硬度分佈的方法。
  17. 8 - 1. 2g / min, and collection efficiency achieve 8 - 10 % under these parameters. through the study on the dispersion process of the nanoparticle tio2 in water, the author finds out that whisk time, dispersant types, dispersant concentration, dispersing time, ph value, temperature and electrolyte concentration have significant influence on dispersing effects. through contrastive and orthogonal experiments, the author obtains that composite dispersants have better results than single dispersants

    研究表明，液料等離子噴塗制備的納米tio :顆粒平均粒徑為10 ~ 50nln ，其晶型以銳欽礦為主，且隨著電弧功率的增大，銳欽礦含量減少;在本次實驗工藝參數下，收集速率為0 . 8一1 . 29 / min ，收集效率為8一10 % o通過對納米ti02顆粒在水介質中的分散性研究，發現機械攪拌時間、分散劑種類及濃度、分散時間、 ph值、溶液溫度和電解質濃度對納米tio :顆粒的分散穩定性有很大的影響。
  18. Particle size distributing and the composing of crystal phase were discussed by the orthogonalizing design. the experiments showed that the most suitable process conditions should controlled as follows : process temperature was about 30c ; the ratio of tnb " water and solvent was l : 4 : l 0 : the calcined temperature was about 600 " c. such transition metal ions as fe3 +

    實驗表明，合適的反應條件是：以醋酸為負催化劑，水解溫度應控制在30左右，鈦酸丁酯與水量、溶劑量的配比應為1 ： 4 ： 10 。另外得到比較單一的銳鈦型tio _ 2煅燒溫度應控制在600左右。
  19. The method of catalyzed electrochemical dissolution has the advantages : dissolving quickly and thoroughly, working at the environmental temperature, no hydrofluoric acid ( hf ) and low acidity ( hno3 ), etc. it can be widely applied in dissolution of pu02 and mixed oxide spent fuel element, the leaching of plutonium - contami

    該法具有溶解速度快、溶解徹底、常溫、無氟（ hf入低酸（ hn 。 ）下溶解等優點。雌能用於puo和混合氧化物乏燃料耕的娜、懷污染廢物的浸取等，也可用於含釬標準樣品的分折定值。
  20. A resolution is put forward to eliminate the influence caused by three factors, i. e. solution temperature, high inner impedance of glass electrode and deviation of electrode

    針對影響測量準確性的三個因素：溶液溫度、玻璃電極高內阻和電極偏差，提出了解決辦法。
分享友人
分享到 Line

分享到臉書