滑移 的英文怎麼說

中文拼音 []
滑移 英文
drift; slippage; glide; slide; slip
  • : Ⅰ形容詞1 (光滑; 滑溜) slippery; smooth 2 (油滑; 狡詐) cunning; crafty; slippery Ⅱ動詞(貼著物...
  • : Ⅰ動詞1. (移動) move; remove; shift 2. (改變; 變動) change; alter Ⅱ名詞(姓氏) a surname
  1. Control of slide of slope angle adn fluid of waste hill

    矸石山矸石流及坡腳滑移控制
  2. When the rock mass of dam abutment is enclosed by faults, joint fissures and bedding planes, it is necessary to carry out holistic anti - slide stability analysis in order to make the abutment withstand potential slide

    摘要當拱? ?肩巖體為斷層、節理裂隙、層面等結構面所圍成,有可能產生滑移時,就應進行整體抗穩定分析。
  3. According to specificities for jointed rock mass, multiple sliding failure of a jointed rock mass is presented, due to accumulation of stress along bedded plane of rock mass and destruction of remnant intact rock bridges between bedded planes and joints

    摘要針對節理化巖體的自身特點,提出沿巖體層面產生的應力集中以及層面與節理之間的殘餘完整巖橋破壞,將可能導致巖體產生復合式滑移破壞。
  4. And rock triaxial serve testing system is used, through model test involving bedded planes and a set of joint normal to the bedded planes in rock mass, multiple sliding failure affected by properties of joints and confining pressure is analysed, the condition triggering multiple sliding failure and characteristics of failure plane are given, under the co - action of inclination of connective joints ( bedded planes ), interlocking conditions of critical joints and confining pressure

    並在室內利用巖石三軸剛性伺服機,通過模型試驗對巖體的層面和一組與層面正交的節理的情況進行模擬研究,分析了結構面性狀和圍壓對復合式滑移破壞的影響,給出了在貫通性結構面(層面)傾角、非貫通性結構面以及圍壓等因素共同作用下,節理化巖體發生復合式滑移破壞的條件以及破壞面特徵。
  5. Furtherly, according to their state in suffering force and their modes of initial motion, the casualty loess landfalls on the house side - slope are classified into two types of tension - sliding loess landfall and collapsed earth cave dwelling

    根據土體受力狀態和起始運動方式,將宅基邊坡傷亡性黃土崩塌劃分為張裂?滑移式黃土崩塌和坍窯兩種類型,總結了其前兆、時空分佈特徵,著重分析了其形成原因。
  6. So this base isolation technique has profound prospects. unfortunately there exist definite difficulties in the calculation because of the nonlinear of the base friction force. now, both the equivalent damping method and the numerical calculatin of the vibration response of the base - isolated buildings are frequently used in the calculation of the seismic response of the base - isolated building. however both of them have certain drawbacks. in this paper, the response of the building with base - isolation system is derived by the method of fourier expansion for the friction force and the earthquake response. at the same time, the sliding vibration character of inertia of a single mass structure and the sliding vibration response of a muti - mass structure are discussed. the stable condition of the sliding base isolation system of a structure is given. in the end, two circes of base fixation and base sliding are analyzed by adopting ansys

    本文利用對摩擦力和地震響應進行付氏級數展開的方法導出了基底具有摩擦隔震系統的地震反應。同時,文中從研究單質點結構的動振動慣性力入手,進而對多質點結構體系動振動反應進行探討,分別給出了結構動隔震的自身穩定條件。最後,本文利用ansys對基礎固定和基礎滑移隔震兩種工況進行了動力模擬模擬分析,進一步證實了基礎滑移隔規律。
  7. The existing theoretical analyses have n ' t refelcted this true mechanism of the force transfering in fixed segment of anchor bar. for the sake of studying the working course from elastic to elastoplasticity slide better, this paper put forward shear stress - displacement curve, and solve the internal force distribution along anchor bar by the basic equntion. at the same time, this paper analysize the difference of columniform fixed segment and the segmeng with anchor slab at the foot of anchor bar

    為了更好的研究錨桿在不同荷載作用下,錨桿的工作狀態從彈性到彈塑性發展的整個過程,本文進行了錨桿受力的模型實驗研究,根據實驗結果提出了剪應力與位的彈塑性本構關系表達式,並根據錨桿受力的基本方程,求解得出了錨桿在不同工作狀態下從彈性到彈塑性滑移的全過程中錨桿的內力分佈。
  8. Variation ratio of dimensional after water rinse, ultimate strength, neps and pile, tearing resistance, bursting strength, joint strength, commissure ' s swerve strength, fabric shift ( slip ), ventilate degree, elasticity ( resilient rate / deformation rate ), anti - water permeability ( hydrostatic pressure ), extension and resilience, abrasive resistance, gets wet the nature, hydroscopicity, stock ' s transverse ductility, fire resistance, antistatic

    水洗尺寸變化率(縮水) ,斷裂強力,起毛起球,撕破強力,彈子頂破強力,脹破強度接縫強力,縫口脫開程度,紗線滑移性能(脫) ,透氣量,彈性(回復率/變形率) ,抗滲水性(靜水壓) ,延伸及回復性,耐磨性,沾水性,吸水性,襪子橫向延伸,阻燃性能,抗靜電。
  9. On critical length of flexural slumping rock layer in layered rocky slope and its influencing factors

    順傾邊坡巖層滑移彎曲臨界長度及其影響因素分析
  10. 5 ) quantitative analysis to the dayi conglomerate in the cenozoic longmenshan foreland basin has been carried out. the results indicate that the dextral strike - slip rate is 1. 02 mm / a, the average sedimentary rate is 0. 143 mm / a, and the average decline rate is 0. 3mm / a

    5 )對新生代前陸盆地大邑礫巖作定量分析,結果表明,大邑礫巖沉積時期,前陸盆地滑移量為1 . 02mm a ,沉積速率為0 . 143mm a ,平均沉降速率為0 . 3mm a 。
  11. Aimed at the flaw of weak anti - slide function in traditional engineering machine, the thesis puts forward a new auto - anti - slide differential gear system controlled by intel 8751 microcontroller, which adopts the fuzzy logic as its control algorism and the best slide ration ( s ) as system ' s control target

    針對傳統工程機械差速系統存在防功能不強的缺陷,提出以intel8751單片機為控制晶元,以最佳滑移率s為控制目標,採用模糊邏輯控制為控制演算法的自動防差速系統。
  12. Mechanical model and basic characteristics of toppling displaced mass

    傾倒滑移變形體的基本特徵及力學模型研究
  13. When ct20 alloy was tensioned at 20k, the main deformation mechanism in equiaxed microstructure was the slip of dislocations, and in bimodal microstructure the slip of dislocations and a small amount of twinning and in lamellar microstructure a large amount of twinning

    Ct20合金20k拉伸變形時,等軸組織主要是位錯的滑移起主導作用,雙態組織除了位錯滑移外還有少量的變形孿晶產生,片狀組織中則能觀察到數量較多的孿晶。
  14. This model has wide - ranging application and simple computing procedure. it avoids the narrow - ranging limitations of slide line method, as well as avoids the complicated computing procedure in the simulation of the gradual breakdown process for the granular structure by fem. its analysis results are identical with those of the practical engineering, this model has engineering application value

    建立了挖掘過程推壓阻力的計算模型,該模型適用面廣、計算較簡便,既避免了滑移線適用面窄的局限性、也避免有限元分析對散體漸近破壞過程模擬的復雜計算過程,計算結果與工程實際吻合,具有工程實用價值。
  15. The inverse kinematics of a space - based manipulator composed of three rigid bodies with prismatic joint are studied in the second chapter, and the jacobean matrix for space manipulator is derived by fully cartesian coordinates. a control method for space manipulator based on the resolved motion rate control concept is proposed

    為此結合系統動量及動量矩守恆關系導出了以完全笛卡爾坐標表示的系統運動jacobi矩陣,並在此基礎上研究了帶滑移鉸空間機械臂的分解運動速度控制方法,給出了計算機數值模擬算例,以此證明了該方法的有效性。
  16. Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.

    粘附滑移流動是一種密集顆粒的急跳式的運動,在壁面處,顆粒的速度稍低於呈桿狀的中心的速度。
  17. The mechanical contribution to this coupling is subject to the hysteresis, metallurgical instability, creep, and slippage at holding clamps.

    引起這種耦合的機械因素是由於滯后、金相不穩定性、蠕變和夾以部分的滑移等效應的影響。
  18. With the amount of ch3sicl2 increased, however, the linear molecule and orbicular organic compounds containing si, o and n element were formed, which resulted decrease of gasification velocity of precursor and purity of si - c - n nano - powders

    而fis樸。柱狀晶在長大過程中與相鄰的ps柞。柱狀晶相互靠近、搭接,限制了玻璃相的滑移,提高了復合材料的高溫強度。
  19. Sliding displacement of beam longitudinal bars in staggered joints is smaller than in ordinary joints, and the beam bar " overstrength in staggered joints is more serious than in ordinary joints when shear force is equal in the two types of joints

    2在節點所受剪力相同的情況下,錯層節點中梁縱筋的粘結滑移比普通節點的要小,梁筋的超強更嚴重。
  20. Torsional microslip at the clamps results in spurious torques which act like pivot friction torques.

    夾緊處扭桿的微小滑移會產生干擾力矩,它的作用和軸頸的摩擦力矩一樣。
分享友人