滿載電流 的英文怎麼說

中文拼音 [mǎnzǎidiànliú]
滿載電流 英文
full load current
  • 滿 : Ⅰ形容詞1 （全部充實; 達到容量的極點） full; filled; packed 2 （滿足） satisfied; contented; conte...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 滿載 : 1 （運輸工具裝滿了東西） loaded to capacity; fully loaded; laden with; fully laden; overall loadi...
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. Engine load simulated control system was consisted of two unattached parts of work resistance simulated control subsystem and electric bow wave dynamometer control subsystem. with the mathematic models of engine load simulation controller, which transferred the work resistance ' s change to engine load change immediately, the system can met the need of the simulation control system

    發動機負荷模擬加載控制系統包括彼此獨立的作業阻力模擬控制子系統和電渦流測功機控制子系統兩部分，應用發動機負荷模擬控制器數學模型，使作業阻力的變化及時轉換為發動機負荷的變化，能夠滿足模擬系統的控制要求。
  2. It looks upon water resistant as load, simulate every instance of locomotive running and check its every parameter automatically, then collect and dispose these data of parameters, calculate the power of simulating running of locomotive, which is based on the current, and voltage of host dynamotor. afterward, it can be judged from the working state of locomotive. through experiment and adjust each parameter, it can provide important warrant to the components of locomotive whether they can work normally and credibly

    即以水阻作為負載，模擬機車運行，對機車的主發電動機的電流、電壓和柴油機的轉速等參數進行檢測，並對檢測結果進行處理，計算出模擬機車運行時的功率，並以此為依據，對機車的工作狀念進行判斷，通過水阻試驗，調整有關參數，使機車運行時能發揮所要求的功率和滿足規定的工作特性。
  3. In the positioning servo - system, which generally is configured by the d. c. pulse width modulator ( pwm ) velocity governing system and position servo - loop, the parameter perturbance of pwm velocity loop really exist by reason of such as the load behavior ; power voltage supply ; operating setting value, etc. 1, 2 ， and it cannot be ignored. by using the identification technique to form the mathematical model of the system, authors have confirmed the facts. therefore, to design the discrete sliding mode controller ( dsmc ) of the positioning servo - system, the perturbed parameters value bounds of the pwm velocity loop, which is as the controlled plant of position servo - loop, should be accounted. consequently, the design principle of dsmc for accounting system with parameter perturbance is proposed by the authors. the proposed method can ensure the stability of system with parameter perturbance and the behavior of non - overshoot, fast precise positioning. in order to reveal the effects of the design method, the comparative research work is done by the authors. also, it has been tested in an industrial experiment, the results proved it is satisfactory

    由直流脈寬調速系統（ pwm ）和位置環構成的定位系統中，速度環的參數隨負載特性；電網電壓；給定工況而攝動是不容忽視的.作者通過系統辨識建模也證實了這一事實1 ， 2 .因此在設計位置環的離散滑模控制時，必須針對速度環（即位置環的控制對象）的參數攝動范圍採用「對象參數攝動離散滑模控制器的設計方法」 ，以確保系統在參數攝動時的穩定性和快速、無超調、準確定位的優良動態品質.為剖析該設計方法的控制效果，本文作了對比性研究，並將該設計方法用於工業試驗中，取得了滿意的結果
  4. The typical ground current ( quiescent current ) is 1ma at full load, 60 a with no load and, and less than 1 a in shutdown mode

    在滿負載條件下，靜態電流為1ma ;在空載情況下，靜態電流為60 a ;在關斷情況下，靜態電流小於1 a 。
  5. ( 4 ) the experiment of asymmetrical half bridge converter design and the result of it base of the above analysis, the dc / dc converter is designed, it is proved that asymmetrical half bridge can realize zero voltage switching when it satisfies the condition of load current and deadtime by the experiment

    （ 4 ）不對稱半橋的實驗電路設計及實驗結果基於前面的分析，設計了一個不對稱半橋dc dc變換器的實驗電路，進行了實驗研究，實驗結果證實了在滿足死區和負載電流兩個條件時，不對稱半橋可以實現零電壓開關。
  6. When ordering overload relays, specify horsepower, voltage and full load current per motor nameplate

    訂購過載繼電器時，請註明每臺電機的功率馬力、電壓和滿載電流。
  7. With the “ skip ” modulation technique, quiescent current are reduced to a minimized value of 1ma with full load, 60ua with no load, and less than 0. 01ua in shutdown mode

    在典型情況下，晶元滿載時的靜態電流為1ma ，空載時的靜態電流僅為60ua ，關斷電流小於0 . 01ua 。
  8. Due to the complexity of the structure and control of cycloconverter - type three - phase hf link inverter for soft - switching based on phase - shift - controlled full - bridge mode, a simple and optimized vvvf control strategy is proposed. this control strategy includes : produced pwm by space voltage vector ( svm ) and equivalent carrier frequency fe = 1 / te are introduced into the pdm control of the cycloconverter ; softened equivalent pwm wave is generated at the notches of hf voltage pulses ; the harmonious control between regulating pulse width by phase - shifted angle and regulating voltage of equivalent pwm is to minimize the harmonics content of output voltage of the inverter

    西安理工大學博士學位論文針對這種前級移相全橋軟開關周波變流型三相高頻鏈逆變器結構和控制的復雜性，提出了一種實現簡單而整體優化的vvvf控制策略:將空間電壓矢量產生p姍的方法svm和等效載波頻率fe = 1 / te引入到周波變流器的pdm控制;按高頻電壓脈沖前後沿軟化等效p翎波;用移相調節高頻脈沖寬度和等效p姍調壓協調控制逆變器輸出電壓，在滿足輸出電壓條件下使諧波最小。
  9. The inverted pwm changing electric current the technique is applied in the prototype model. the prototype model was tested and operated on spot, power factor could reach beyond 0. 95, the effect of following modulating voltage was better, the curve of factor of modulated voltage of exchanging systems changed following load rate was linear, the output of wave form was a flat and steady sinusoidal wave

    樣機採用了逆變式pwm變流技術，對其進行了現場測試與試運行，測試結果是電網側的功率因數可達0 . 95以上，跟蹤調壓效果良好，變流系統輸出調壓系數（ k ）隨負載率（ p ）的變化曲線基本滿足直線關系，輸出波形呈平滑穩定的正弦波。
  10. Though standard cast resin dry - type transformers can meet the demands of most consumers. we still have to proceed special designing of transformers for special application field and operating conditions, such as single phase transformers, regulating transformers with onload tap changer, double voltage transformers, isolating transformers, rectifying transformers, earthing transformers and transformers with special tapping arrangement, which we are supplying to consumers all over the country

    雖然標準的樹脂絕緣乾式變壓器已能滿足大多數用戶的要求，但是對于某些特殊的應用領域與使用條件仍需我們進行特殊設計。諸如單相有載調壓雙電壓變換隔離整流接地以及有特殊出線排列的變壓器，我公司在不斷地提供給各地的用戶。
  11. The power electric chest supplies different kinds of ac and dc power, whose quality meet the needs of technic capability and insure that the aircraft can accomplish missions favourably in minitances

    電源電子箱為機載武器系統用電設備提供不同種類的交、直流供電。電源電子箱的供電質量滿足規定技術性能的要求，保證了飛機可以順利完成戰斗任務。
  12. Repetitive control is used to reduce voltage distortion under abrupt load variation or nonlinear loads and attain good quality of the voltage waveform ; current loop is designed to quicken the dynamic response and strengthen the ability of the inverter control

    重復控制可以抑制逆變電源在負載變化嚴重（空載加到滿載）或者非線性負載條件下的輸出電壓畸變，保證輸出波形的質量；電流環用以改善輸出波形的動態響應特性，提高逆變控制的能力。
  13. Then it demonstrated that layer 3 mpls vpn has high security, the ability of overloading multi - service, function of routing and can realize central management and configuration. it has mature and credible technology and is the most appropriate ip vpn technology for the development of telecom service provider. on the basis, it analyzed the security of mpls vpn and the characteristic of qos, and proved the high security of layer 3 mpls vpn, then by combing with technology of differ service and te ( transfer engineering ), it proved layer 3 mpls vpn can provide qos of low delay and high reliability to satisfy the need of telecom network

    論文首先討論了ipvpn的隧道技術及標志交換技術，尤其結合當前最新的技術詳細討論了標志交換中的三層mpls （多協議標簽交換） vpn技術和各類二層mplsvpn技術，論證了三層mplsvpn具有高安全性、多業務的承載能力、路由功能，可以實現集中管理和配置，技術上成熟可靠，是當前最適合電信運營商發展的ipvpn技術;在此基礎上全面探討了mplsvpn的安全及qos特性，說明了三層mplsvpn具有很高的安全性能，同時通過結合differservice技術及流量工程技術， mplsvpn能夠提供低時延、高可靠的qos保障能力，滿足電信網路運行的需要;並且根據當前最新的雙平面組網技術和iptn技術跟蹤分析了mplsvpn當前的最新發展趨勢和動向。
  14. Simulation comparisons verify the superior performance of the tri - state pwm technology. experimental results indicate that the current - controlled tri - state pwm switching power amplifier based on sample - hold strategy has high frequency bandwidth and fast dynamic response in a wide load range, which can well meet the demands of high - speed magnetic bearing

    模擬結果驗證了電流三態調制技術的優越性能；實驗表明本文研製的基於采樣-保持策略電流三態調制開關功放具有結構簡單、效率高、紋波小、電流動態響應快、頻帶寬、受負載影響小等優點，能很好地滿足高速磁軸承的要求。
  15. They can dynamically change the distribution of electric field, carriers and current densities in pcss, caused output current to delay and also strengthen the local electric field enough to satisfy qualification of domain, and then cause avalanche. the time of delay is determined by the time of attaining the qualification of domain

    非線性光電導開關的時間延遲效應則是由於半絕緣gaas材料中的el2深能級中心動態地改變開關中的電場、載流子濃度引起的；延遲時間的長短主要由滿足成疇所需條件的時間決定。
  16. Lastly the nonlinearity of armature reaction of the dc motor is considered, a variable structure controller is designed based on the feedback linearization method, moreover, a robust controller is designed which can restrain the uncertainty bought by the load disturbance and the nonlinearity of armature reaction simultaneously

    最後，針對直流電機速度控制系統存在電樞反應非線性，設計了基於反饋線性化的變結構魯棒控制器和一種能同時滿足抑制負載擾動和電樞反應非線性引起的不確定的魯棒控制器。
  17. 26arms max at any input voltage and rated, dc output rated load

    當輸入交流電壓為額定值的下限時，輸出滿載，最大輸入交流電流0 . 26a 。
  18. 1arms max at any input voltage and rated, dc output rated load

    當輸入交流電壓為額定值的下限時，輸出電壓負載滿載，最大輸入交流電流1a 。
分享友人
分享到 Line

分享到臉書