潤濕處理 的英文怎麼說

中文拼音 [rùnshīchǔlǐ]
潤濕處理 英文
moist curing
  • 潤 : Ⅰ形容詞（細膩光滑; 滋潤） moist; smooth; sleek Ⅱ動詞1 （加油或水 使不幹枯） moisten; lubricate 2 ...
  • 濕 : Ⅰ形容詞（沾了水的或顯出含水分多的） wet; damp; humid Ⅱ名詞（姓氏） a surname
  • 處 : 處名詞1 （地方） place 2 （方面; 某一點） part; point 3 （機關或機關里一個部門） department; offi...
  • 理 : Ⅰ名詞1 （物質組織的條紋） texture; grain （in wood skin etc ） 2 （道理;事理） reason; logic; tru...
  • 潤濕 : madefaction; [物理學] wetting潤濕劑 wetting agent; wetting-out agent; syndets
  1. In order to modify wool fabrics properties, low - temperature oxygen plasma is used to treat wool fabric

    摘要為了改善羊毛織物的氈縮、潤濕等性能，採用低溫氧等離子體對羊毛織物進行改性處理。
  2. For accumulating heat from piping and making as even the temperatures in various spaces betwiin pipes an possible, gravel foundation is first laid, mortar is mixed fully by mixing ratio of 1 : 2, the floor is finished level and then perfect curig in damp condition is carried out

    為保證管路間蓄熱和溫度均勻應鋪下砂礫層后進行配比為1 ： 2的灰漿完成處理，不僅要保證地板水平，還要在濕潤狀態下自然乾燥，使得到徹底的養護，人為的養護會導致地板雛裂，應予以注意。
  3. Low frequency micro - vibration causes the micro - fluid to produce uniform dispersion and injection which carried out a hydrophobization treatment on the inner wall of micro - nozzle, thus eliminated the spontaneous flowing of micro - fluid inside the micro - nozzle due to wet ting effect so as to let the micro - injection be provided with a digitalized and volume controllable character

    壓電陶瓷低頻微振動使得微流體產生均勻的離散和噴射；對微噴嘴內壁進行疏水化處理，從而消除微流體由於濕潤作用在微噴嘴內部的自發性流動，使得微噴射具有數字化量可控的特徵。
  4. Abstract : in this paper, the adherent properties of pet fabric treated by corona - discharge were studied through esca and wettability, the application of two mechanisms in terms of weak boundary layer and chemical structure on fabric surface was discussed

    文摘:本文通過光電子能譜和表面潤濕實驗來研究經電暈放電處理后的滌綸織物的表面性能，探討了弱界面層和化學結構兩種理論在粘合中的應用。
  5. The productive technology of active carclazyte produced by activating bentotite was introduced emphatically. the treatment method of acidic waste water produced in wet process was also described

    主要介紹了膨潤土活化生產活性白土的生產工藝及濕法工藝中產生的酸性廢水的處理方法。
  6. It is found that ito surface roughness decreased after oxygen plasma treatment, which can improve its wetting performance and consequently improve the film performance

    經氧等離子體處理后， ito薄膜的表面粗糙度減小，平整度提高，提高了ito薄膜表面的潤濕性能，改善了有機物在其表面的成膜性能。
  7. The maximal power outputs of 37. 0 mw / cm2 and 30. 0 mw / cm2 for the p - and n - type laminated materials respectively at the temperature difference 490 have been experimentally obtained, which are about 2. 5 and 3. 0 times those of - fesi2. chemical analyses show that the interface failure between the bridge alloy and the semiconductor bi2te3 results mainly from the eutectic mixtures with low melting point and brittle compounds formed during welding and long time annealing at 190. it is found that the electrical properties of a laminated structure are mainly controlled by the wettability of the bridge alloy on the semiconductor surface

    發現： 1 ）疊層材料具有明顯優于均質材料的熱電性能，在490溫差下， p -型和n -型疊層材料的最大輸出功率分別達到37 . 0和30 . 0 （ mw / cm ~ 2 ） ，是同類型均質- fesi _ 2的2 . 5和3倍； 2 ）在焊接過程和190長時間退火處理過程中，焊接過渡層合金和基體半導體（特別是bi _ 2te _ 3 ）之間存在明顯的元素相互擴散，從而在過渡層中形成一些低熔點共晶體和脆性化合物，這是導致疊層材料破壞的主要原因； 3 ）焊接過渡層合金與半導體基體之間的潤濕性是影響界面層電性能的主要因素。
  8. The mwd value of this method was bigger than the routine methods one, and the mwd index of fw and slow wetting ( sw ) treatment were agreed significantly to the > 0. 25mm size percentage given by wet sieving in the routine methods

    團聚體快速濕潤（ fw ） 、慢速濕潤（ sw ）和預濕后擾動（ ws ）三種處理之間存在顯著差異。 fw處理與sw處理呈極顯著相關關系，而與ws處理不相關。
  9. Our herbal base lies in the southeast of gansu, where is the natural joint of many highlands and mountains. special geographical features, fertile soil and moist weather make super quality natural herbs abound, such ax artificially planted radix angelicae sinensis, rhiozma gastrodiae, radix glycyrrhizae, radix scutellariae, herba ephedrae, rhizoma polygonati, gerba epimedii, semen armeniacae amarum

    藥材基地地處甘肅東南部，位於青藏高原、黃土高原橫斷山脈和秦嶺的交匯地，地理位置特殊，氣候高寒陰濕，這里土地肥沃，氣候濕潤，盛產各種優質中藥材，家種藥材以當歸、白條黨參、紅芪、黃芪等為主，野生藥材主要品種有柴胡、赤芍、防風、天麻、甘草、淫羊藿、黃苓、麻黃、黃精、杏仁、鹿銜草等，俗有「藥鄉」之美稱。
  10. Wetting between reinforcement sicp and the molten metal is often poor when it is blow 1000 ' c ; 2. during the processing, many phases of the interfacial reaction products have negative influence on the properties of the produced composites

    Sic顆粒增強復合材料中界面反應生成的有害雜質相較多，對復合材料的性能的影響較大。可以通過添加mg 、 li等活潑的合金元素，對增強體顆粒進行表面預處理來改善潤濕性。
  11. 5. the relation between wetting property and leafing property was established, the recognization for the metallic pigment leafing property theory was deepened, and the new methods to improve leafing property were put forward. the results provide the new trains of thought for surface treatment of bronze powder

    西安理工大學碩士學位論文（ 5 ）確定了銅金粉潤濕性和漂浮性之間的對應關系，深化了對銅金粉漂浮機理的認識，並提出了具體改善銅金粉漂浮性能的新方法，為國產銅金粉表面處理提供了新的思路。
  12. Combined with special wettability properties, a - c films may have greater potential applications. in present thesis, a series of a - c films were prepared by magnetron sputtering technique on substrates as si ( 100 ) and glass, and the deposited processes were controlled to adjust the morphology of the surfaces of a - c films. to further obtain the desired wettability, surface chemistry compound of the lotus - like surfaces were plasma modified by optimized processes

    本文採用磁控濺射系統在普通玻璃和單晶硅上獲得了具有不同表面形貌特徵的非晶碳薄膜，此外利用等離子體表面處理系統，通過改進工藝方法，優化工藝條件，對非晶碳薄膜表面化學組成進行調控，獲得了潤濕性能從超親水到超疏水范圍變化的表面。
  13. Treating delicate garments ( i. e. wool ) the wet area has to be blown dry

    如是處理精緻衣物（如羊毛） ，濕潤區需風干后再乾洗。
  14. To settle the wetting quality between carbon fibers and copper matrix, several solutions were used to treat with the surface of carbon fibers

    為解決碳纖維與基體間的潤濕性問題，本研究採用多種鍍液對碳纖維進行表面鍍銅處理。
分享友人
分享到 Line

分享到臉書