激光感光計 的英文怎麼說

中文拼音 [guānggǎnguāng]
激光感光計 英文
laser sensitometer
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
  • : Ⅰ動詞1 (覺得) feel; sense 2 (懷有謝意) be grateful; be obliged; appreciate 3 (感動) move; t...
  • : Ⅰ動詞1 (計算) count; compute; calculate; number 2 (設想; 打算) plan; plot Ⅱ名詞1 (測量或計算...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  • 感光 : [攝影學] sensitization; photoreception; photosensitive; sensitive; sensitometric感光玻璃 photosen...
  1. Fourthly, this paper standardizes the linear of the inductance sensor and analyzes its error. then we discuss the angle error of the laser sensor and the datum plane error of the mechanism. finally, the paper gives some advice to improve the mechanism

    第四,此外,本文還對電器進行了線性校正及誤差分析,討論了器傾角誤差,並對機械設中的定位結構進行了誤差分析,提出了改進的措施。
  2. Standard practice for cone penetrometer technology characterization of petroleum contaminated sites with nitrogen laser - induced fluorescence

    帶有氮應熒的石油污染位點的錐形透度技術特性的標準操作規程
  3. Based on information from laser radar sensor, a real - time obstacle avoidance algorithm and the strategy of breaking away from dead state are also designed

    根據雷達傳器信息設了基於柵格的實時避障演算法和解鎖策略。
  4. In the experimental system apd transferred laser pulse to weak electrical current. after two - level amplification we got a voltage pulse that had a enough amplitude to be applied, the timing point was discriminated by the constant - fraction timing discriminator circuit. timing circuits transferred the pulse flight time to digital signal accurately

    實驗系統採用apd作為電傳器,將脈沖信號轉變為微弱電流脈沖,經過兩級放大后,信號變為幅度較大的電壓脈沖,經過時點鑒別電路分別確定時起點和終點后,由時電路來精確測量兩個時間點之間的時間間隔。
  5. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd : yag器的發展狀況、主要特性及其應用,從四能級速率方程出發,推導了ld泵浦nd : yag器的閾值、輸出功率和斜效率的表達式,並簡述了器的工作原理、結構型式和倍頻方法;其次,以空間相關的速率方程為基礎,提出了ld端面泵浦nd : yag器的設方法,給出了一定泵浦耦合方式下,振蕩模尺寸、最佳輸出耦合率、泵浦模尺寸、泵浦焦斑位置等參數的選取依據,以此為依據,設了自聚焦透鏡耦合小功率ld泵浦nd : yag器和透鏡組耦合高功率ld泵浦nd : yag器,對器的輸出功率和功率穩定性等特性進行了實驗研究;再次,在帶尾纖輸出的高功率ld泵浦nd : yag腔內插入一隻空液晶盒,觀察到了器以單縱模運轉;最後,根據泵浦焦斑端面位置對輸出功率的影響規律,提出了ld端面泵浦nd : yag位移傳新方法,並進行了理論和實驗研究,研究結果表明:當晶體內泵浦平均斑半徑遠小於振西安理工大學碩士學位論文蕩束腰半徑時,輸出功率的自然指數與泵浦焦斑的縱向位置成高斯變化規律,測量范圍和靈敏度依賴于泵浦功率,隨著泵浦功率的增加,測量范圍擴大,靈敏度提高,當端面泵浦功率為7 . 24w (最大輸出功率為1 . 926w )時,位移傳器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  6. Abstract : in this paper, the design of the sense organ of the silicon miniature inertial meter is presented. the approving structure of the sense organ is fulfilled by the fabrication techniques of laser processing and chemical etching, laser fibre optic vibration is used to test the vibration characteristic of the suspensi on beams

    文摘:設了硅微型慣性加速度的敏頭並應用加工和化學蝕刻相結合的工藝方法製造得到了滿意的結構,應用纖測振儀檢測了懸臂梁振動特性。
  7. In this paper, the design of the sense organ of the silicon miniature inertial meter is presented. the approving structure of the sense organ is fulfilled by the fabrication techniques of laser processing and chemical etching, laser fibre optic vibration is used to test the vibration characteristic of the suspensi on beams

    了硅微型慣性加速度的敏頭並應用加工和化學蝕刻相結合的工藝方法製造得到了滿意的結構,應用纖測振儀檢測了懸臂梁振動特性。
  8. Decign for 2d acceleration laser sensor

    二維加速度器的設
  9. This product adopts oem pressure transducer with stainless steel isolation diaphragm as signal measure element and automatic testing by the computer. using laser adjustment resistant technology carries on temperature compensation to zero point and sensibility in width temperature scope

    該產品採用帶不銹鋼隔離膜片的oem壓力傳器作為信號測量元件並經過算機自動測試,用調阻工藝進行了寬溫度范圍的零點和靈敏度溫度補償。
  10. Abstract : the construction of the liquid angular sensor in the laser beacon is designed, the work principle and magnify circuit are analysed

    文摘:對基準信標儀中所採用的液體擺角傳器的結構進行設,分析其工作原理、放大電路。
  11. By the line s - h sensor mentioned in chapter 3, measurements have been made to a beam path heated by hf laser. by a high speed interferometer, tomographic measurement was made on a air column heated by electric powered wire

    用第三章設的線陣s - h傳器對hf加熱路進行了測量研究,在此基礎上,用高速干涉儀對電熱絲加熱的空氣柱進行了模擬層析測量研究。
  12. 2 : propose a who1e blueprint of the 3 - - d 0ptical multi - - sensors profilometry system. implement the most important parts of hardware and software subsystems of the system, it can profi le some rigid and soft objects

    2 :提出多個線結構器的三維腳形測量系統設方案,完成了對於三維鞋楦和腳型三維面形測量的硬體和軟體系統的實現。
  13. This paper investigates the system, which is composed of multip1e laser stripe sensors, to profile foot and shoe moda1. at the same time, the paper proposes the technique of calibrating by single sensor and mul t iple sensors, regi strat ing and merging of 3 - - d range data, des igning the hardware and software

    本文研究了採用多個線結構器的三維腳形測量系統,提出了系統校準模塊的設,研究了多傳器校準方法,多傳器數據的配準和融合以及三維建模。
  14. Then the two 2d lrf based obstacle detection system was carefully designed and consequently the algorithm based on multi - sensor data fusion was presented

    接下來作者設了採用兩個2d測距雷達的alv障礙檢測系統,並提出了基於多傳器數據融合的障礙檢測方法。
  15. 2. the design thought of annular fan beam sensor structure is presented, and array laser sensor of 15x5 fan beams structure was developed. the sensor ' s measurement sensitivity distribution and spatial resolution are analyzed and calculated

    提出了環形扇束傳器結構的設思想,並研製了15 5扇束結構的陣列式器,以及對其測量靈敏度分佈和空間解析度等性能指標進行了分析算。
  16. The some fire control system is an advanced multi - senor short range air defense system, which integrated both x and ka bands searching and tracking radars, laser range finder, combined the control computer of subsystem with the master computer, and applied the technology of data fusion

    摘要某火控系統集兩個頻率波段的搜索雷達、跟蹤雷達和電視跟蹤器、測距機於一體,分系統控制處理算機與系統主算機相結合,採用了數據融合技術,是一部多傳器集成的現代化防空系統,具有搜索性能好、反應時間快、抗干擾能力強、自動化程度高、使用性能好等特點。
  17. The total structure and working principle of the intelligentized photoelectricity fire control system which is made of the aiming telescope, image sensor, laser ranging engine, code device, decoding computer, display device etc were presented

    摘要介紹了瞄準望遠鏡、圖像傳器、測距機、編碼器、解算算機、圖文信息顯示裝置等組成的智能電火控系統的總體結構和工作原理。
  18. The thesis survey the realized power supplies schemes at the nation and aboard widely. designed and realized two types of power supplies for eoct, which is power supplies on special coil and power supplies on laser source

    並在調研和本課題組原有技術的基礎上,設、完善並實現了特製線圈供能和供能兩種混合式電電流互器的設方案和整體結構。
  19. Due to the advantages such as short response time, easy operation, and convenient to comprehend the wavefront modes, the hartmann wavefront sensor ( h - wfs ) is widely utilized nowadays in real - time adaptive optics system, turbulence statistical characterization, optical components test, light quality evaluation, laser atmosphere communication, the wavefront correction of ultrahigh power laser pulses, as well as human eye aberrations measurement. the detection accuracy is important to the performance of the whole optical system. considerable efforts have been performed in the investigation of h - wfs wavefront detection techniques in past years

    哈特曼波前傳器具有實時探測,易操作,可以直觀顯示波前畸變分佈等優點,被廣泛地用作自適應學系統的波前信息探測和波前畸變補償,大氣湍流統特性表徵,學元件檢測,束質量評價,超強脈沖波前整形,大氣通信以及人眼象差測量等各個領域之中,其探測精度的高低對整個學系統的工作性能有著極其重要的影響。
  20. So, a new criterion about the area calculation of the house appears. according to that, the area of the house equal to the sum of the practical area and the area of the wall section. the latter can be calculated on the criterion easily

    測量儀的測量房屋套內面積的設想是通過步進電機驅動測距傳器旋轉每一步距角,對距離數據進行每步採集保存,轉滿一周后對相鄰距離值構成的三角形面積進行算求和而得到面積。
分享友人