激光應用 的英文怎麼說

中文拼音 [guāngyīngyòng]
激光應用 英文
laser action
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : Ⅰ名詞1 (照耀在物體上、使人能看見物體的一種物質) light; ray 2 (景物) scenery 3 (光彩; 榮譽) ...
  • : 應動詞1 (回答) answer; respond to; echo 2 (滿足要求) comply with; grant 3 (順應; 適應) suit...
  • : Ⅰ動詞1 (使用) use; employ; apply 2 (多用於否定: 需要) need 3 (敬辭: 吃; 喝) eat; drink Ⅱ名...
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. Under the incentive of the civil - market demanding such as laser material processing and the military - market demanding such as a new generation of laser weapon candidate and icf, diode - pumped solid laser ( dpsl ) develops rapidly worldwide. as an important application, diode - pumped intracavity - frequency - doubled laser is attached much importance in recent years, but there still remain many problems unresolved completely. in this paper, i have given some abecedarian study results on some of these problems theoretically and experimentally

    因工業材料加工等民市場的需求以及慣性約束聚變和作為新一代武器候選器件等軍方需求的推動,國際上高功率二極體泵浦固體器( dpsl )的研究進展迅速,作為dpsl的一個重要,內腔倍頻一直得到大家的重視,但仍有許多未徹底解決的問題和理論上的不完備之處,本論文擬對其中的一些問題作一初步的理論和實驗研究。
  2. Laser marking is a kind of technique using heat effect of laser to ablate meterials on object surface so as to leave over permanent press

    打標是利的熱效燒蝕掉物體表面材料從而留下永久標記的技術。
  3. 5. using these mathematic models discussed in the paper, the homemade excimer laser aberration correction system has been manufactured with cooperation of su zhou 66 vision tech co., ltd. now the system has been applied to clinical practice. clinical results showed that : the excimer laser aberration correction system can remarkably improve visual performance when treating ametropia ; the system can

    5 .根據論文中的關鍵模型,與有關單位合作,研製出了準分子人眼像差矯正系統,該系統目前已投入臨床;臨床報告表明,系統在矯正屈不正時效果顯著且安全,在像差矯正時有效、安全。
  4. If the velocity of atoms is near to zero, the light for ces will tend to confine the atoms near to nodes and antinodes. the stability depends on the magnitude of the negative slope of the light force, the depth of the potential well and the momentum diffusion coefficient. it is important to select the parameters, e. g

    如果通過冷卻能使原子速度降至很小甚至為零,壓力的作將使原子被較穩定地囚禁于駐波場的節點和反節點處,其穩定程度取決于該處壓力曲線負斜率的大小、對勢能的勢阱深度以及動量擴散系數的大小,因此,如何在實驗中合理選擇強度、失諧量等顯得尤為關鍵。
  5. Application of cr : lisaf laser to study of light spectrum of tissue autogenous fluorescence

    在組織自體熒譜研究中的
  6. Laser diode or flash lamp pumped solid state lasers with different wavelength and different operating styles. wavelength tunable laser sources with tial2 o3 laser and optical parametric oscillator laser application machines with laser display, laser material procession

    各種波長及各種運轉方式的二極體及閃燈泵浦的固體器;採鈦寶石及學參量振蕩器的波長可調諧的源;激光應用整機。
  7. The experimental data are in good agreement with the calculated results of the model by analysis of the data of the laser pulse of different energy induced the laser plasma shock front by acoustics means. in addition, the calculated results of the model are in good agreement with the experimental data by optics means

    同時設計聲學方法對水中不同能量的脈沖下產生的等離子體沖擊波波前傳播過程進行測試及數據分析,對學陰影方法探測的等離子體沖擊波近場波前傳播數據進行詳細分析,結果表明新模型計算結果與實驗測量值一致。
  8. However, in the pulse application fields, the output pulse energy from single mode fiber lasers or amplifiers is limited by amplified spontaneous emission ( ase ), nonlinear effect and facet damage

    在脈沖激光應用領域中,這類小芯徑纖放大器和器的輸出脈沖能量受限於自發輻射放大、非線性效以及纖的端面損傷。
  9. The x - ray is isotropic measured by pin detector, the hard x - ray ( > 30kev ) production become smaller with the reduction of the incident laser intensity, when the intensity is lower than 101 ? w / cm2, there is no hard x - ray generation

    這是第一次實驗測量紫外飛秒輻照固體靶產生的硬x -射線連續譜,為研究把紫外激光應用於慣性約束聚變「快點火」的可能性提供了實驗數據。
  10. Since the introduction of high - power short - pluse lasers well, there has developed a strong interest in the high - density high - temperature plasmas produced by the interaction of intense laser light with matter

    自從高能短脈沖被很好地以來,人們對在物質上所產生的高密度熱等離子體表現出了強烈的興趣。
  11. The tests of e - o applications by our flux ktp has been realized, the results showed : optical waveguides fabricated by using an ion - exchange process, which have an exchange - ion concentration depth profile and refractive - index profile, is close to a complementary error - function distribution, optical homogeneity and device thermal stability is much better. amplitude modulation switch formed by our flux ktp has the contrast ratio of 150 : 1 and insert loss is 2. 5 % at 1064 nm. high quality optical pulse with 1 ns width was cut successfully by using an e - o modulator from a laser pulse with 50 ns width, this modulator had run for three years, and the crystal did n ' t blackened, it showed our low conductivity flux ktp can endure high modulation voltage for a very long time

    Ktp晶體的電試驗表明:離子交換法製作的電波導,其離子交換濃度、折射率變化符合餘弦誤差函數,學均勻性以及器件的溫度穩定性較好;製作的強度調制電開關,消比為150 : 1 ,對1064nm的插入損耗為2 . 5 ;製作的電調制器脈沖整形試驗,從脈沖寬度50ns的脈沖削出脈寬1ns的高質量脈沖,該電開關經過長達三年多的使,沒有出現晶體變黑現象,說明本實驗的低電導率ktp晶體能夠耐受長時間的調制電壓。
  12. In this paper, we study inversionless lasing of frequency up - conversion in an open v - type system with incoherent pump. making theoretical analysis and numerical calculation by density - matrix equations of motion, we derive the conditions for the onset of lwi and discuss the effects of the parameters of the system, the detuning of driving field and probe field on the gain, and discuss nonlinear effect in the frequency up - conversion regime. we also give stability and transient analysis

    本論文研究了具有非相干泵浦的開放v型系統頻率上轉換無粒子數反轉,利密度矩陣運動方程,通過理論分析和數值計算,得出該系統產生無粒子數反轉的條件,討論系統各參數的變化和驅動場與探測場的失諧對增益、色散和粒子數差的影響,還討論了頻率上轉換區域的非線性效,分析了增益的穩定性及系統的瞬態演化過程。
  13. The results of e - o tests showed that ktp crystals by our flux technique is an attractive material for various e - o applications, especially used in a high - repetition - rate and high responsible laser system

    試驗結果表明,本實驗的熔劑法ktp晶體是一種非常吸引人的電材料,特別是適合於高重復頻率、高響速度等系統。
  14. Realization of high - power laser coupling is an important and of unique value in high - power laser application

    摘要實現高功率纖耦合對高功率激光應用有著重要的作
  15. With nanjing electronic information, electromechanical integration, and precision machinery, new home appliances, spare parts processing, and numerically controlled machine tools and cnc systems, motor vehicles and accessories, die manufacturing and shipbuilding industries, and special transmission equipment, aerospace, high - performance intelligent instrumentation and sensors, laser application, machinery manufacturing, and other pillar industries in the rapid development of nanjing bearings, fasteners, springs and other important infrastructure components consumption will be a great space for growth. for a considerable period of time will remain the most potential domestic consumer market

    隨著南京電子信息機電一體化及精密機械新型家電零部件加工數控機床和數控系統汽車及汽車配件模具製造業造船工業特種傳輸設備航空航天高性能智能化儀器儀表及傳感器激光應用機械製造等支柱產業的快速發展,南京軸承緊固件彈簧等重要基礎元件消費量還將有巨大的增長空間,在今後相當一段時間內仍將是國內最具潛力消費市場!
  16. Polarizers, one of the most important optical modulators, are widely used in modem laser action technique, optical information processing, image - forming system, etc. the function of polarizers is to transform non - polarized light into polarized one, which is the preparation for further modulation

    學調制器件中的重要器件?偏器,在激光應用技術、信息處理,以及成像系統中有著廣泛的。偏器件的作是將非線偏振變為線偏振,為信息的進一步調製做準備。
  17. The physical model and its significance of the biological effect of he - ne laser producing the chinese pine seeds

    油松種子生物效的物理模型及其意義
  18. With the development of ld pumping and fiber manufacturing technology, all kinds of fiber laser come into use. its application field is expanded from fiber communication to other more fields

    領域也已從目前最為成熟的纖通訊網路方面迅速地向其他更為廣闊的激光應用領域擴展。
  19. With the sustaining development of modern optics, especially the emergence of laser, polarizers are becoming more and more widely used. noteworthily, laser - polarizing prisms suitable for laser use emerge

    隨著現代學的不斷發展,尤其是出現以後,偏器件的越來越廣泛,特別值得注意的是適激光應用特點的棱鏡運而生。
  20. Laser ranging was one of the first applications of laser technology

    測距技術是人類最早的激光應用技術之一。
分享友人