激光聚變腔 的英文怎麼說

中文拼音 [jīguāngjùbiànqiāng]
激光聚變腔 英文
laser fusion cavity
  • 激 : Ⅰ動詞1 （水因受到阻礙或震蕩而向上涌） swash; surge; dash 2 （冷水突然刺激身體使得病） fall ill fr...
  • 光 : Ⅰ名詞1 （照耀在物體上、使人能看見物體的一種物質） light; ray 2 （景物） scenery 3 （光彩; 榮譽） ...
  • 聚 : 動詞（聚集; 聚積） assemble; gather; get together
  • 腔 : 名詞1. （動物體內空的部分） cavity; chamber 2. （話） speech 3. （樂曲的調子） tune; pitch 4. （說話的腔調） accent; tone
  • 激光 : [物理學] laser 激光靶 laser target; 激光報警器 laser avoidance device; 激光玻璃纖維 laser fibre; ...
  1. Under the incentive of the civil - market demanding such as laser material processing and the military - market demanding such as a new generation of laser weapon candidate and icf, diode - pumped solid laser ( dpsl ) develops rapidly worldwide. as an important application, diode - pumped intracavity - frequency - doubled laser is attached much importance in recent years, but there still remain many problems unresolved completely. in this paper, i have given some abecedarian study results on some of these problems theoretically and experimentally

    因工業激光材料加工等民用市場的需求以及慣性約束聚變和作為新一代激光武器候選器件等軍方需求的推動，國際上高功率二極體泵浦固體激光器（ dpsl ）的研究進展迅速，作為dpsl的一個重要應用，內腔倍頻一直得到大家的重視，但仍有許多未徹底解決的問題和理論上的不完備之處，本論文擬對其中的一些問題作一初步的理論和實驗研究。
  2. To reduce the marking distortion, using the vertical 2 - dimension galvanometer distributing and f field lens focalize, the distance of the second galvanometer to the machining plane is the focus f. to avoid too hign temperature to distroy the resonance cavity because of too long marking time, cooling system and self - protector is used in the design

    為減少打標畸變，採用垂直二維振鏡分佈， f物鏡聚焦，將激光束經第二個振鏡反射後到加工平面的距離為焦距f ，為了避免打標時間過長，溫度過高破壞諧振腔，在設計中加上冷卻系統和自我保護裝置。
  3. Laser fusion cavity

    激光聚變腔
  4. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  5. Based on the rate - equation theory of four - level system, the expressions of threshold pump power, output power and slope efficiency are given. the influence of space distribution of pump light ( the position of focusing point, dimension of pumping light and divergence angle ) to the output characteristics are also discussed. then, by investigating the effects of thermal effect of laser crystal on the size of laser cavity mode, we obtain the mode - matching principle of high power laser diode end - pumped solid - state lasers

    其中，在泵浦光的空間分佈變量中我們分別考慮了泵浦光聚焦后的腰斑大小、聚焦腰斑在增益介質中的位置以及泵浦光在介質中發散角的影響；然後我們研究了在高泵浦功率下激光晶體因吸收泵浦光而產生的熱效應所導致的熱透鏡效應以及熱致衍射損耗，通過分析它們對振蕩激光腔模尺寸的影響，得到了高功率半導體激光二極體端面泵浦固體激光器模式匹配的要求，為高功率連續單頻nd ： yvo _ 4激光器的優化設計提供了理論依據。
分享友人
分享到 Line

分享到臉書