濃噴霧液 的英文怎麼說
中文拼音 [nóngpēnwùyè]
濃噴霧液
英文
spray concentrate-
With gelatin liquor as adhesive and wheat meal as granulation material, the effects on spray granule ' s strength of fluidizing gas velocity, bed temperature, nozzle air pressure and adhesive concentration were studied experimentally in a batch conical fluidized bed spray particle generator
本文在一間歇錐形流化床噴霧造粒器中，以食用小麥澱粉為原料，以明膠的水溶液為粘結劑，實驗研究了流化氣速、床層溫度、噴嘴霧化空氣壓力、粘結劑濃度對噴霧造粒顆粒強度的影響。As to the simulation, three - dimensional n - s equations and two - phase flow model, in which the liquid toluene spray as discrete particles was considered, were employed to describe the turbulent combustion processes in the combustion chamber. the mass and energy transfer between the two phases were calculated by the droplet evaporation model, and the arrehnius model was used to obtain the gas chemical reaction rate. the details of 3d flow field, the distributions of temperature and compounds were obtained by solving the equations
數值模擬方面，應用三維湍流n - s方程以及顆粒軌道模型描述了激光器燃燒室內部的噴霧兩相燃燒流動過程，兩相之間的質量、能量交換由液滴蒸發模型計算，氣相化學反應速率由arrhnius公式計算，通過耦合求解氣液兩相模型方程，模擬了燃燒室三維流場，得到了燃燒室內的溫度和組分濃度分佈。In this paper, urea particles and oil - vegetable seeds as initial particles are used to study granulation process in a vibrated fluidized bed, where the initial particles grow in a layered manner by spraying melt urea solution on them and reached the required granule size
本文以尿素或油菜籽顆粒為晶種，以不同濃度的尿素溶液為噴霧料漿，對振動流化床噴霧造粒特性進行了實驗研究。實驗在晶種上噴塗尿素熔融液或不同濃度的尿素溶液，使其以層式機理長大。Lukang ? gel of proper density in water based system can adhesion and suspension powder materiel ( such as pigment, medicine and talcum powder etc. ), stabilize suspension liquid, prevent suspended material sediment and harden, make suspension liquid even, bright - colored, convenience, easy spraying, and unaffected by outside force and time
適當濃度的綠康凝膠在水性體系中可粘合、懸浮粉狀物料（如：顏料、藥物、滑石粉等） ，穩定懸浮液，防止已懸浮物質的沉澱積合、硬化，使懸浮液質地均勻，色澤艷麗，使用方便，噴霧更加容易，且不受外力、時間影響。The effects of particle type, liquid spraying rate, liquid concentration, fluidizing gas velocity, vibrated intensity, nozzle position and atomization air pressure on the growth of particles have been analyzed and discussed
著重研究了晶種類別、料液流量、料液濃度、流化氣速、振動強度、噴嘴高度、霧化氣壓力等因素對顆粒成長的影響。分享友人