濕度敏感性 的英文怎麼說

中文拼音 [shīdùmǐngǎnxìng]
濕度敏感性 英文
moisture sensitivity
  • 濕 : Ⅰ形容詞（沾了水的或顯出含水分多的） wet; damp; humid Ⅱ名詞（姓氏） a surname
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 敏 : Ⅰ形容詞（靈敏;敏捷） quick; agile; smart; nimble Ⅱ名詞（姓氏） a surname
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 濕度 : humidity; dampness
  • 敏感性 : sensibility; sensitiveness; susceptibility; susceptiveness敏感性分析 sensitivity analysis; 敏感性...
  • 敏感 : sensitive; susceptible; tactful
  1. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下： 1 ）對翅片管蒸發器結構特點進行分析，選取適當的微元控制體，就干、濕和霜工況下對每個微元分別進行傳熱傳質分析，基於經驗關系式確定霜的有關參數，對于霜工況下的霜生長建立模型，經適當假設，運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型，為系統模擬奠定基礎； 2 ）對蒸發在大擾動下的開、停機過程，運用動態集中參數模型進行分析和計算，為更好地描述製冷系統運行的全過程奠定基礎，同時也為製冷系統實現自動控制提供一定的理論基礎； 3 ）對蒸發器正常運行過程，運用動態分佈參數和參數間定量耦合的觀點來分析和計算，為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性； 4 ）編寫翅片管蒸發器動態特性模擬計算程序，可以計算不同邊界條件和初始條件下的製冷劑熱力參數、空氣溫濕度和霜厚度分佈場，實現對翅片管蒸發器在干、濕和霜工況下的動態模擬。
  2. The humidity sensitive characteristics of these sensors prepared by means of self - assembly have been investigated and the effects of electrode structures, concentration of humi - sensing solution, number of bilayers, materials of the outer layer and inner layer on humidity response were discussed

    測試了不同體系濕敏膜的感濕特性，探討了電極結構、感濕液濃度、離子強度除閂電翻動復合膜層數、最外層材料、最內層材料等因素對濕敏元件響應特性的影響。
  3. According to the analysis and characterization of temperature sensor, humidity sensor and oxygen sensor, a converting circuit for multifunctional combined sensor was designed

    本文通過對溫度傳感器、濕度傳感器以及氧氣濃度傳感器敏感特性的測試及分析，設計並製作了多功能組合傳感器的信號處理電路。
  4. The first one is to study the relationship between soil moisture and precipitation over the shiguanhe river catchment in the summer of 1998 and 1999. the second part is to evaluate the performance of a modified bats land surface model by offline experiments

    第一部分是研究我國史灌河流域土壤濕度和降水的關系；第二部分是改進的bats陸面模式獨立試驗；第三部分是改進的bats模式敏感性試驗。
  5. However, the pavement is easily spoiled by reflective cracking from semi - rigidity base because semi - rigidity base is sensitivity to low temperature and little humidity, so through adverse circumstance and reduplicate vehicle load. the base can have easily rupture by much dryness and low temperature. then these interior fractures will extend to exterior asphalt

    這是因為半剛性基層材料對溫度和濕度反應敏感。在環境和重復交通荷載作用下，基層容易產生干縮和低溫縮裂裂，半剛性基層這些裂縫會擴展到面層，形成反射裂縫。
  6. Herein we employed 3, 4 - polyethylenedioxythiophene ( pedt ) as the polymer material, and tetracyanoquinodimethane ( tcnq ) and tin phthalocyanine ( snpc ) as small molecules. pedt was synthesized using chemical oxidation method. infrared spectrum ( ir ) and scanning electron microscopy ( sem ) were utilized for the characterization of the obtained pedt material and surface morphology of the pedt film

    對于pedt ，本文採用化學氧化法的工藝，探討了工藝對成膜的影響，用掃描電子顯微鏡（ sem ）觀察膜的表面形貌，運用紅外吸收光譜（ ir ）分析驗證了所生成的pedt聚合物，並測量了其電阻隨溫濕度的變化，最後探討了這種材料對兩種氣體的敏感特性。
  7. Moreover, such reservoirs have high temperature, medium - highly hydrophilic, not sensitive to water, acid and alkali, and have good feasibility of waterflooding

    而且該類油藏溫度高，儲層潤濕性為中強親水，對水、酸、堿不敏感，具有較好的注水可行性。
  8. A 0. 85um - or 1. 3um - led - lighted fiber optic humidity sensor based on a film of 40 ~ 100nm in thickness self - assembled on the end face of the fiber can work in the range of 1 ~ 100 % rh with a response time less than 1s. this novel humidity sensor can be used for monitoring human breathing - conditions. organic molecules including congo red, a derivative of copper phthalocyanine and a fullerol were self - assembled with polymers into multilayer thin films, and organic molecules with more than 4 charged groups exhibited satisfactory features for multilayer self - assembling

    聚電解質pdda -聚染料ps - 119體系具有很好的自組裝性，多層復合膜無明確的層狀結構特徵，在宏觀上表現出單層光學塗層的特性，單層膜的厚度在納米量級且與聚電解質水溶液的濃度有關；薄膜具有濕敏特性，在光纖端面上組裝厚度為40 100nm的薄膜，採用0 . 85 m或1 . 3 m的led光源，可以製成光纖濕度傳感器，傳感器的工作區間為0 100 rh ，響應時間1s ，可以用於對人的呼吸監測。
  9. The effect of sensing materials on humidity response of sensors has been investigated. humidity sensor based on na - sam exhibits fast response and small hysteresis, and sensors with high sensitivity, small hysteresis and wide sensing range can be prepared using composite of na - sma and napss

    研究了濕敏材料對元件響應特性的影響，發現na - sma具有響應快，濕滯小的特點，其與napss以一定比例復合，可制得靈敏度高、濕滯小、感濕范圍寬的濕敏元件。
  10. By introducing an example of intelligent humidity and temperature measurement system, the features of humidity sensor capacitor and it s application, and the principle, structure of the measurement system, and its calibration were described

    本文就一個智能型濕、溫度測量儀表系統的實例，介紹了作為濕度傳感器的濕敏電容的特性和應用情況，並簡要介紹了該測量儀表的結構、工作原理和校準的問題
分享友人
分享到 Line

分享到臉書