濕配料 的英文怎麼說
中文拼音 [shīpèiliào]
濕配料
英文
wet batch-
On the base of the analysis on the advanced technology of hard ferrite in foreign country, the main procedures of preparing hard ferrite pre - sintering material are determined as follows : first, the ferrite oxides coming from the main cold rolling line and strontium carbonate are conveyed to storage tank by gas power and weighed automatically according to the demands of constituent composition. and then they are mixed and grinded by using method of wet treatment. finally the mixtures is transported to the devices of storage by transporting pump
在分析國外先進的永磁鐵氧體生產工藝的基礎上，確定了生產高檔永磁鐵氧體預燒料的主要過程：首先，利用攀鋼冷軋鐵紅為主要原料，將氧化鐵紅及碳酸鍶採用氣力輸送至貯料料倉，經自動稱量裝置，按工藝配方稱量後分別由氧化鐵紅及碳酸鍶發送罐氣力輸送進入預混攪拌筒加水攪拌，然後再送入混磨機濕法混磨；最後，混合物經輸送泵輸送至料漿存儲裝置，經定量進料泵定量輸送至回轉窯進行濕法預燒，預燒料經緩冷至室溫后，再球磨。Simultaneously cross - linked and quaternized 4 - vp - co - nbuma was also investigated as humidity sensing materials and showed good linearity, high sensitivity, good high stability at high humidity and high temperature, and durability to organic solvent, etc. sensors based on 4vp - co - buma ( vp / buma = l / l ) with crosslinking and quaternization reaction of 17 hours exhibited a change of three orders of magnitude ( 104 ~ 107 ) in impedance over the range of 95 % rh ~ 30 % rh, showing high sensitivity, and little hysteresis was observed
元件具有響應線性度好，靈敏度高，濕滯小、高溫高濕穩定性好、耐無水乙醇有機溶劑性能好等優點。其中，交聯季胺化17小時配料比為1 1共聚物濕敏元件，在33 rh 95 rh濕度范圍內，阻抗變化達3個數量級（ 10 ~ 7 - 10 ~ 4 ） ，響應靈敏度高，幾乎無濕滯。The study on salc includes : 1 ) the study on the harmonization between aeration rate and melts thickly rate ; 2 ) the study and application of the new multi - function composite additive ( nmca ) ; 3 ) the study on the durability of salc ; 4 ) the designation of the structure of new multi - functional unbearing compound wall and fast equipment mold, etc. the results show : the additive can improve the harmonization of the workability and mechanics characteristic of salc to a certain extent ; improve the volume stability of salc under different environment by enhancing the resistance to the freeze and thaw, dry and wet circle and drying shrinkage
在salc的研究方面，主要包括發氣速度和稠化速度的協調性研究、新型多功能復合外加劑的研製、耐久性能的研究以及新型多功能非承重復合墻體結構及其澆注成型的快速組裝模具設計等內容；結果表明：科學合理的引入輔助外加劑在一定程度上使salc材料的工作性及相應物理力學性能得以最佳匹配，增強了salc材料對凍融循環、干濕循環及乾燥收縮的抵抗能力，使salc在不同的環境下均具有較好的體積穩定性。The interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity
研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大Abstract : the interface behavior between essence and ethylene - vinyl acetate copolymer pallets was studied so that necessary data were obtained to guide the preparation of fragrant masterbatch. the adsorption type and wettability between essence and the copolymer pallets were analysed by measurements of fourier transform infrared spectrum, surface tension, contact angle and specific surface area. the technical factors affecting absorptivity such as the charge ratio, temperature, pressure and stirring speed were studied by series of adsorption experiments. the results showed that the adsorption of essence on the surface of ethylene - vinyl acetate copolymer pallets is physical in nature. essence couldn ' t moisten the surface of ethylene - vinyl acetate copolymer pallets absolutely, but it could be soaked into the surface of the pallets partly. adsorptivity could be increased by enhancing the temperature, pressure and stirring speed, but the extension of adsorption time had little influence on adsorptivity
文摘:研究了香精與乙烯/醋酸乙烯共聚物粒子之間的界面行為，以便為香型母粒的制備提供必要的理論依據.利用傅立葉變換紅外光譜、表面張力、接觸角及比表面面積等測定手段，分析了香精與載體之間的吸附類型和潤濕作用.並通過一系列吸附實驗，討論了配料比、溫度、壓力、攪拌等工藝條件對吸附量的影響.結果表明，香精在乙烯/醋酸乙烯共聚物粒子表面的吸附為物理吸附；香精無法完全潤濕載體粒子表面，但可以對其形成部分浸潤；提高溫度、壓力、攪拌速度可以增加吸附量，而延長吸附時間對增加吸附量貢獻不大The improvement of steel crucible model shape of wet strike method, the layout of electrical and thermal insulation layer, the preparation and tamp of linings, firing and sintering are introduced
主要介紹濕法築爐鋼坩堝模形狀的改進，絕緣層和絕熱層的輔設，爐襯材料的配製和打結、烘爐與燒結。This paper deals with high fluid concrete in which high strength ceramsite made from shale was used as coarse aggregate. effects of cement content, water - cement ratio, sand percentage, mineral admixture, grading and pretreatment of lightweight aggregate on compressive strength and workability of high fluid structural lightweight aggregate concrete have been studied. the rules of water absorption of high strength lightweight aggregate under different pressure and effects on uniformity of high fluid structural lightweight aggregate concrete have been studied too
本文採用高強頁巖陶粒，摻加高效減水劑配製大流動性結構輕集料混凝土，討論了水泥用量、水灰比、砂率、礦物摻料及輕集料的級配和預濕方式對大流動性結構輕集料混凝土強度和工作性的影響；系統研究了高強陶粒在常壓和壓力下的吸水規律；研究了影響大流動性結構輕集料混凝土勻質性的因素，提出了解決大流動性結構輕集料混凝土分層離析的具體措施。Experiment showed that the network with 6 nodes in each hidden layer has the best - forecast ability. the bp network was developed by training, b )
將反演得到的氣象站點相對濕度資料，拓展為模式網格點的濕度資料，從而與數值預報模式相匹配。The stove as common type wind heater, matching with various material on dry equipment. extensively used on rice, seed, fertilize, fruit, dehydroulic vegetable, fragrant mushroom, edible tree fungi, tremella, tea, cigarette leaves on agriculture products, food, pharmacy, raw material in chemical industry, light and heavy industry product on heat up moisture for clean, also for various construction heat up and storehouse moisture clean on etc
該爐為通用性熱風加熱裝置，與各種物料的乾燥設備配套使用，廣泛用於糧食、種子、飼料、果品、脫水蔬菜、香菇、木耳、銀耳、茶葉、煙葉等農產品、食品、醫藥藥品、華工原料、輕重工業產品的加熱除濕，還可用於各種設施的加熱以及庫房除濕等。The working condition of nylon shaft liner is determined by many factors, for example : the different formula, shaping technique, the design of shaft liner, installation method, loading features, running speed, lubricant condition, the working environment of shaft liner temperature, humidity and the influence of impurity, abrasion when working etc. so, when designing shaft liner, it is necessary to take consideration of all conditions
鑄型尼軸套的許用工作情況是由很多因素決定的，例如不同配方和成型工藝所制得的材料物理機械性能，軸套的設計裝配方法，負載特點，運轉速度，潤滑情況，軸套的工作環境溫度濕度雜質的影響，工作時的摩擦條件，對磨材料的性能等。因此，在設計軸套時，應綜合考慮各個方面的因素。The experts confirmed that the nh2c and nh15a high permeability material and ferrite cores have adapted well with the improvement of the electrons which would be smaller, thinner and lighter. the same time the cores assume so many advantages such as high flux density, high curie temperature, high frequency, low - loss etc. the technical indicators of the cores have been the nation - lead position in the same species
由行業專家組成的鑒定委員會一致認為，上述兩項產品採用濕法制粉工藝，通過配方設計多組元添加燒結條件控制等工藝改進，控制了材料的微結構和性能，產品批量生產的一致性好，成品率高，性能處于國內領先水平。分享友人