濺射室 的英文怎麼說

中文拼音 [jiànshèshì]
濺射室 英文
sputtering chamber
  • 濺 : 動詞（液體受沖擊向四外射出） splash; spatter
  • 射 : Ⅰ動詞1 （用推力或彈力送出） shoot; fire 2 （液體受到壓力迅速擠出） discharge in a jet 3 （放出） ...
  1. The results are as follows : as the sputtering pressure increases, the atomic ratio of o to ti increase in the films, which is attributed to the fact that the absolute oxygen content increases, as the pressure increases despite the ratio of 62 to ar remains unchangless

    結果發現：在氧氣、氬氣分壓比不變的條件下，薄膜表面o和ti原子比增大，這可能是由於濺射氣壓增大，而氧氣與氬氣比未變，真空室中氧氣的絕對含量增加，參加反應的氧原子數增加的緣故造成的。
  2. The study on low temperature pvd deposited sic film was carried out - m - employing bias assisted magnetron sputtering. furthermore, pvd deposited sic film mainly containing cubic phase was achieved at room temperature for. the first time

    採用偏壓輔助rf濺射法，對低溫物理氣相沉積sic薄膜進行了研究，並首次在室溫下制備出含有? sic構相併以其為主的sic薄膜。
  3. The molecular structure of the sputtered titanium oxide films were investigated by xps and x - ray diffraction. it was found that the ratio of ti / o increases when pressure increases, and there is a optimum ratio of ar / o2 for the sake of obtaining more tio2 on pet surface

    利用x射線衍射法（ x - ray ）對濺射沉積膜的表面物相結構進行了研究，發現在本實驗室條件下濺射生成的膜均是無定型結構。
  4. The processing parameters of preparing plzt electro - optic films were 400 of substrate temperature, 100w of sputtering power, 1 : 6 ratio of oxygen to nitrogen and 650 of annealing. the processing parameters of preparing sno2 film were room temperature of substrate temperature, 200w of sputtering power, 1 : 2 ratio of oxygen to nitrogen and 600 of the annealing temperature

    制備plzt電光薄膜的最佳工藝參數為:襯底溫度400 ，濺射功率100w ，氧氬比為1 : 6 ，退火溫度為650 ;而制備二氧化錫透明電極的最佳工藝參數為:襯底溫度室溫、濺射功率200w 、氧氬比為1 : 2 、退火溫度為600 。
  5. Study of pressure distribution in sputtering chamber of multi - source roll coater

    多靶連續卷繞鍍膜機濺射室布氣均勻性研究
  6. A special clamp for etching optical fiber and depositing pd film on the fiber is designed. designed a encapsulation set of the characteristics that is dampproof, shake and eroding resisted. the experimental set - up for hydrogen sensing includes the light source, gas cell, mass flow controller, stainless steel helical tubing and the detector, etc. the experimental results are also discussed

    本文還設計了一套光纖腐蝕用夾具、光纖封裝加熱夾具和一套光纖濺射鍍膜實驗夾具;設計並製作了一套具有防潮、抗震和抗腐蝕功效的光纖傳感頭封裝裝置;設計了一套由激光器、反應混合氣室、光功率計、質子流量計和流量控制器等組成的氫氣定標實驗裝置並對實驗數據進行了分析與處理。
  7. The high - performance heat - reflective coated glass is also called sunlight control coated glass it is made by coating a number of metal or metal compaound films onto the high - quality float glass or other base glass with the vacuum magnetic control sputtering method, which can effectively control the reflection, transmission and absorption of solar energy, that is to say, this glass allows sufficient natural light to come in for daylighting, and can also reflect major part of sunlight irradiation to reduce the collection of indoor heat and lower down the expenses for ventilation and air conditioning ; furthermore, the transmission, reflection ratio and reflection color are ready for the selection by the users

    高性能熱所射鍍膜玻璃也稱為陽光控制鍍膜玻璃，是在優質浮法玻璃或其他基片上用真空磁控濺射的方法鍍多層金屬或金屬化合物薄膜而成，可有效控制玻璃對太陽能的反射、透過和吸收，也就是說允許足夠的自然光進入室內用於採光，還能把大部分太陽光輻射熱反射掉，減少室內熱量的積聚，降低通風及空調的費用，而且可以根據客戶的需求，靈活選擇透過率，反射率及反射顏色。
  8. The trapped amount of helium depends on the relative helium content in sputtering gas, applied bias and substrate temperature

    實驗研究了薄膜中的氦含量與濺射真空室氣氛中氦的相對含量、基底偏壓及沉積溫度間的關系。
分享友人
分享到 Line

分享到臉書