濾波器損耗 的英文怎麼說

中文拼音 [lǜbōqìsǔnhào]
濾波器損耗 英文
filter loss
  • 濾 : 動詞（除去液體雜質） filter; strain
  • 波 : Ⅰ名詞1 （波浪） wave 2 [物理學] （振動傳播的過程） wave 3 （意外變化） an unexpected turn of even...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 耗 : Ⅰ動1 （減損; 消耗） consume; cost 2 [方言] （拖延） waste time; dawdle Ⅱ名詞1 （壞的音信或消息） ...
  • 濾波器 : [電子學] electric filter; （electric） wave filter; filter
  • 損耗 : 1. （損失消耗） loss; wear and tear; deterioration; waste 2. [商業] wastage; spoilage
  1. However, the h - bridge maglev chopper has serious switching losses, so as to have snubber circuit ; there is high emi with the chopper

    然而， h -橋斬波器開關損耗大，需要添加緩沖網路，電磁干擾十分嚴重;對供電電源有反向電流沖擊，容易造成供電電源和濾波電容的損壞。
  2. In active section, in order to meet performance of out put power above 10dbm, the power amplifier module of ka - band is fabricated by using hmc283 to achieve the 14db conversion gain. there are five parts that include of waveguide - to - microstrip ? mixer ? filter ? power amplifier and waveguide - to - microstrip. input signal ' s power is 10dbm, after it pass waveguide - to - microstrip, it ' s frequency is escalate from 30ghz to 35ghz

    該組件由五個部分組成：功率為10dbm信號經過波導? ?微帶過渡，然後混頻，濾波將30ghz提高到35ghz濾除不需要的諧波鏡頻以及三階交調信號，為了彌補混頻濾波的變頻損耗，加一級功率放大器，此放大器採用hittle公司hmc283晶元，此上變頻放大組件完成了上變頻?濾波?放大功能。
  3. The main works are as follows : 1. the paper systematically describes basic concepts and theories that form the foundation for design of general microwave filters. the topics will cover filter transfer function, lowpass prototype filters, frequency transformations, immittance inverters and the passband insertion loss under the influence of the dissipation of filter elements 2

    現總結如下: 1 .對微波濾波器的設計理論進行系統的分析，闡述了微波濾波器的傳輸函數、低通原型、頻率變換、倒置變換器以及元件損耗對帶內插損的影響等方面。
  4. Method of insertion loss measurementsfor passive radio interference filter units

    無源無線電干擾濾波器插入損耗測量方法
  5. High quality epitaxial sto / ybco multilayers can be fabricated due to their similar crystal structure and small lattice parameters mismatch. the filter made from sto / ybco thin films shows high tunable speed, low microwave loss and high power handling capability. so sto / ybco multilayers have attracted much interests for electronically tunable filter in the last decade

    因此，利用高質量sto / ybco外延薄膜研製的濾波器具有響應速度快、微波損耗低、調諧范圍大、承載功率高等優點，是一種極具競爭力的電調濾波器技術方案，也是當前的研究熱點和開發重點。
  6. Because the contact resistance between the metal contacts and the superconducting films has large impact on the performance of superconducting filters, we experimental techniques. after annealing the optimum temperature and, we got the minimum contact resisitivity. we also further studied the interaction between ag and ybco films after annealing at a certain temperature and attempted to give an explanation and discussion

    金屬接觸電極與超導薄膜之間的接觸電阻對超導濾波器的插入損耗有很大影響，因此，本文通過多種實驗方法，系統的研究了ag與ybco超導薄膜之間的接觸電阻問題，得到了最佳退火溫度，並對退火時ag與ybco超導薄膜之間相互作用的機理進行了研究和探討。
  7. Method of insertion - loss measurement for feed - through capacitors and radio - frequency filters

    穿心電容器和射頻濾波器插入損耗的測量方法
  8. People can easily design the hysteresis current control hardware circuit, but the switching frequency is variable which makes us difficult the design the output filter, moreover the output waveform is not good. the space vector modulation techniques, by selecting the zero vector properly, it can reduce the harmonic content of the output voltage, so it has become a popular control method

    滯環電流控制的硬體電路設計簡單，但存在開關頻率不固定，輸出濾波器設計困難，輸出波形質量差，空間矢量控制（ svm ）技術具有較高的電壓利用率，且通過對零矢量的合理控制可以降低諧波含量或降低開關損耗，因此是一種較好的控制方法。
  9. Two models were given to analyze the characteristics of distributed spatial filtering of bend multimode fiber and the multimode fiber amplifier in this paper

    本論文主要工作是提出了用於分析彎曲多模光纖的空間濾波特性的理論模型和存在彎曲損耗時的光纖放大器等效模型。
  10. So the emergence of facts is just for the purpose of solving these problems of power system. as a branch of facts, active power filter ( apf ), a new power and electric equipment, its function is to eliminate load harmonic and compensate system line reactive power, damp system surge of node voltage, decrease power waste of system line

    作為facts的一個重要分支- - - -有源濾波器（ apf ） ，是為了解決系統線路無功功率因數過低以及負載線路諧波過多，從而出現線路損耗大、電源電壓的瞬態波動過陡等一系列相關問題而產生的一種新型電力電子裝置。
  11. Specialties : the range of center frequency it can achieve is bigger than one - piece filter ; at the time it has the features of wide pass - band, low insertion loss and high restraint outside the band

    特點：可實現的中心頻率范圍較單片濾波器寬，通帶寬度范圍大，插入損耗小，帶外抑制高。
  12. The development of filters, resonators and other telecommunication technology required better dielectric materials. the dielectric materials, used as the resonate body, should be high in dielectric constant, low in dielectric loss and a near zero temperature coefficient of dielectric constant in high frequency band, also could be sintered in a relative low temperature so as to reduce production cost, and what ’ s more, the miniaturization and reliability of materials are also the main aspects in the research work of high frequency band dielectric materials

    隨著濾波器、諧振器等器件以及通信技術的發展，人們對電介質材料的要求越來越高，要求作為介質諧振腔的電介質材料在高頻段下具有高介電常數，低介電損耗，接近於零的介電常數溫度系數，還要求高頻電介質材料能夠在較低的燒結溫度下燒成，以降低實際生產的成本，此外，材料的小型化，高可靠性也是高技術高頻介質材料的重要研究方向。
  13. Method of insertion loss measurement for radio frequency filters

    射頻濾波器插入損耗的測量方法。
  14. Electrically, the proposed filter can be modified by adjusting the location of those poles to meet the system specfication

    電性上，本濾波器可輕易調整損耗極點的位置以滿足系統要求。
  15. High - q tuned lc filters will have more insertion loss

    高q值調諧lc濾波器會有更多的插入損耗。
  16. The other is to simulate simple lc filters which call ideal and real inductors model, then we can get the simulating results such as time 、 phase movement and amplitude - frequency specifications are very different mainly due to hysteresis. in all, this paper presents some called real inductors models and provides a design method of real inductor model

    模擬結果表明，調用磁芯電感模型的模擬曲線比調用理想電感的情況滯后、幅值小，反映了磁芯電感元件的電感量、磁滯效應和磁滯損耗都影響濾波器的時移、相移和幅頻特性。
  17. The filter takes the advantages of low cost, small in size, light in weight, etc., and can easily be integrated into microwave and millimeter wave integrated circuits firstly, the ltcc technology was introduced and a test circuit based on the resonate method of microstrip ring was designed to test the performance of ltcc for dielectric constant and loss

    這種濾波器具有體積小，便於集成的特點，也適用於表面貼裝。先是對ltcc工藝及材料做了基本介紹，並採用微帶環諧振法設計了一個ltcc工藝性能測試電路，對ltcc成品的介電常數、損耗和q值進行測試。
分享友人
分享到 Line

分享到臉書