濾波通帶 的英文怎麼說

中文拼音 [tōngdài]
濾波通帶 英文
filter pass band
  • : 動詞(除去液體雜質) filter; strain
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  • : 通量詞(用於動作)
  1. In this paper, the design of a practical sort of high performance biquadrates elliptic active band - pass filters is emphasized, and then the design techniques and how to calculate the resistors and capacitances, how to make computer simulation and tolerance analysis with computer are described in detail

    摘要本文我們重點介紹了一種實用的雙二次型高性能橢圓函數有源器的設計方法,詳細介紹了該器的設計步驟及阻容元件的參數計算,並對設計出的電路用計算機進行模擬模擬和容差分析。
  2. A coplanar waveguide tunable bandpass filter using ferroelectric thin film

    基於共面導傳輸線的鐵電薄膜可調
  3. The simulation and experiments indicate that these two methods are simple, fast and accurate. a new optimal design of interleaves based on cascaded mach - zehnder interferometers is also presented. as compared with the two existing methods ( digital signal processing methods and fourier filters ), the present method is simple and intuitive

    本論文分析了mach - zehnder干涉儀級聯形式之間的關系,提出了平坦化分叉復用器的新型設計方法,與現有兩種方法(應用數字器設計方法以及傅立葉展開法)相比較,本文提出的設計方法直觀、簡單。
  4. Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit

    延遲線振蕩器由寬放大器、可調衰減器和聲表面質量傳感器件構成。延遲線振蕩器輸出信號經后與109mhz的本機晶體振蕩器輸出信號相混頻,過低取其差頻,並經整形後由數字信號處理電路處理。
  5. Thirdly, two kinds of the methods to improve the performance of filter stopband has been discussed. these methods are used to cleared up the influence of the parasitical passband. through the simulation and test result shows that these methods " s performance is expected

    第三,論了2種對器阻抑制進行改善的方法,以消除寄生的影響,過模擬和實際製作器的測試結果。
  6. This paper starts the research of the liquid floated pendulous accelerometer testing system according to the engineering. at first, this paper gives the brief introduction of the history and present status of accelerometer and its testing technology, the working principium and math model of the liquid floated pendu - lous accelerometer, and then, decides the binary width pulse force retrim loop as the design proposal of testing system, researches the transfer function of every part in the system emphasizly, analyses the stability of the whole accelerometer testing system from the angle of control theoretics by the open loop transfer function of system, and designed the correcting net, analyses the basal problems such as resolution, sampling restraint, precision and so on, designs the hardware testing circuits such as preamplification, band - pass filter, alternating amplifier, phase sensitive demodulatorn, pulse - width modulation, frequency scale circuit, moment current generator. finally, using the graphics program language labv - iew which is designed for testing field especially by ni accomplishes the solfware design of testing system, realized the testing functions

    首先對加速度計及其測試技術的發展歷史和現狀,液浮擺式加速度計的工作原理和數學模型等作了簡要的介紹,然後確定了以二元調寬脈沖再平衡測試迴路為設計方案,並從控制理論的角度進行了分析,著重研究了系統中各部分的傳遞函數,利用系統開環傳遞函數分析了系統的穩定性,同時設計了系統的校正網路;分析了二元調寬脈沖再平衡測試迴路的解析度、采樣約束以及測試精度等基本問題,並按照系統分析的結果設計了包括前置放大、、交流放大、相敏解調、脈寬調制、頻標電路以及力矩電流發生器等測試系統各部分硬體電路,驗證了電路的正確性,最後按照測試系統的要求,採用了美國ni公司專為測試領域所開發的虛擬儀器工具? ? labview作為測試軟體開發工具,利用該圖形化編程語言完成了測試系統軟體部分的設計,實現了測試功能。
  7. Abstract the paper gives a circuit of second band active filter ? made of secondary current transmitter, it not only is of the function ? of the voltage filter, but also the current one

    摘要提出一種使用第二代電流傳輸器構成的二階有源器電路,它既可實現電壓功能,也可實現電流功能
  8. A uhf sensor is designed and fabricated, which mostly consists of antenna, uhf amplifier, high pass filter, and broadband wave detector

    過與大華無線電廠合作,研製了超高頻傳感器,其主要由天線、超高頻放大器、高器、寬器等組成。
  9. In this paper, on the basis of absorption of achievements of the research on auditory physiology, an auditory model simulationg the peripheral auditory system and part of the central auditory system is set up. the model is made of the fitlters presenting the characteristics of the basilar membrane for analyzing the voice signals, the half wave rectification modeling the inner hair cells and energy transfer of nerve fiber

    在吸收聽覺生理學研究成果基礎上,建立了一個模擬外圍聽覺系統和部分中樞聖經系統功能的聽覺模型。模型由表徵基底膜的頻率分析的器組、內毛細胞的半整流特性和神經纖維的能量轉換特性組成,該模型可以作為前端處理來提取語音信號的自相關圖譜。
  10. For phonetic signal modulation, if the pass band range of the band pass filter ( bpf ) is 300hz - 3400hz, the anti - noise properties of laser are approximately independent of bias current and parameters of the cavity ; when the pass band range of bpf increases to a certain degree, modulating bias current and parameters of the cavity can improve the anti - noise properties of laser

    對語音調制情況,如器的范圍取為300hz - 3400hz ,則激光器的抗噪聲性能基本不依賴于偏置電流和腔內參數;當器的范圍增大到一定程度,調整偏置電流和腔內參數可以實現半導體激光器的高抗噪聲性能。
  11. The techniques of the barometric height measurement are researched, which is calibrated by gps information and compensated by temperature information. the barometric height measurement channel of high resolution is designed with the help of curve - fitting and digital filtering algorithm

    研究了利用gps校準零點、溫度補償的氣壓高度測量技術,過曲線擬合與數字技術,設計了具有較高解析度的氣壓高度測量道。
  12. An lpf can be simulated by setting the bpf ' s centre frequency to zero

    器的中心頻率設置到0 ,就可以模擬低器。
  13. Bpf band - pass filter

  14. Bpf band pass filter

  15. Under special conditions a bpf may also be used as an lpf or as an hpf

    在特殊條件下,器也可以用作低器或高器。
  16. Butterworth - type and bessel function - type two ways are used for design of bandpass filter for receiver, and with the help of eda simulation tools, the bold plot and the group delay characteristics of the filters designed are compared

    摘要採用巴特沃思型和貝塞爾函數型2種方法進行接收機器設計,藉助eda對該器進行特圖和群延遲特性的比較。
  17. Section ii describes the design approach and implementation of speech module on mcf5249 coldfire core. the speech codec optimizes g. 729a codes and added voice activity detection of g. 729b to save bandwidth ; the implementation of acoustic echo cancellation uses nlms algorithm and it can reduce echo though designing adaptive fir filter and speech detector ; the dtmf and cpt generate signal using two second order digital sinusoidal oscillators and detect signal by picking up the frequency information. but only get the frequency information is not enough in cpt detector, this thesis introduces a method

    其中對語音編解碼器的設計採用優化g . 729a代碼達到設計要求,並在此基礎上加入g . 729b的靜音檢測模塊,以進一步降低網路傳輸寬;對回聲消除器的設計採用nlms演算法,過設計自適應fir器和語音檢測器達到回聲消除目的;對雙音多頻設計,信號發生端採用構造靜態參數表並過二階正弦振蕩器產生信號,信號檢測端提取頻率信息以檢測信號;對呼叫進程音設計,除了類似雙音多頻的信號發生及頻率檢測設計外,還需要檢測信號持續時間,作者設計了一種基於匹配狀態表的方法以檢測信號持續時間。
  18. First, how to conduct sample and quantification of continuous time signal which is prior condition of sdr is explored in detail, and the comparison and analysis of some sample modes are given in which band pass signal sampling theorem is most important. second, multi - sample rate signal processing which is an important basis of sdr is studied. emphasis are put on decimation and interpolation those are the most fundamental process and the realization of decimation and interpolation filter

    在基於中頻采樣的軟體無線電結構框架下,首先詳細探討了軟體無線電的前提條件,即如何對連續時間信號進行采樣量化,比較分析了幾種采樣的方式,其中最為重要的是信號采樣定理;然後探討了軟體無線電的一個重要基礎,即多采樣率信號處理,重點討論其最基本的兩個過程抽取和內插以及抽取器和內插器的實現;接著介紹了結構簡單、適用於一級抽取的cic器和適用於做2倍抽取的半器;再次論文在總結了傳統的調制解調基礎上,結合軟體無線電器件的特點,系統的探討並實現了基於正交思想的am 、 fm 、 ask 、 fsk 、 bpsk 、 qpsk的正交調制解調演算法。
  19. Compare to the normal rectangular waveguide, ridge waveguide has the character of broader bandwidth, smaller dimension, lower equivalent characteristic impedance, etc. because of these merits, it is used more and more widely, such as broadband ridge waveguide filter, broadband direct coupler, diplexer, frequency converter, phase shifter, ridge waveguide slot antenna array, and so on

    與普矩形導相比,脊導具有工作頻寬、尺寸小、等效特性阻抗低等特點。由於脊導本身的特點,使其得到了越來越多的應用,例如寬器、寬定向耦合器、雙工器、變頻器、移相器、脊導縫隙天線陣等等。
  20. After the analysis of power produce character of the typical three - phases unbalance load, the corresponding circuit is adopted. this main circuit is composed of the power filter series and tcr control circuit. secondly the theory of band - pass filter is analyzed in detail, and then a method of implementing butterworth band - pass filter is put forward

    簡要分析了無功補償的基本原理和工作特點,過對典型的三相不平衡負載工作特點的分析,主電路採用電力器與晶閘管控制電抗器相接合的結構;對用於無功檢測的器進行了分析,設計了用於負載電壓、電流信號器,並採用運算放大器加以實現。
分享友人