瀝青乳化試驗 的英文怎麼說

中文拼音 [qīnghuàshìyàn]
瀝青乳化試驗 英文
emulsion test for asphalt
  • : Ⅰ動 (液體滴落) drop; drip; trickle Ⅱ名詞(液體的點滴) drop; drip; trickle
  • : Ⅰ形容詞1 (藍色或綠色) blue or green 2 (黑色) black : 青布 black cloth; 青牛 black ox3 (年輕...
  • : Ⅰ動詞(生殖) give birth to Ⅱ名詞1 (乳房) breast2 (奶汁) milk 3 (像奶汁的東西) any milk lik...
  • : 名詞(古代占卜用的器具) astrolabe
  • : 動詞1. (察看; 查考) examine; check; test 2. (產生預期的效果) prove effective; produce the expected result
  • 瀝青 : pitch; asphalt; bitumen; mineral resin; dacholeum; goudron; chian; pez; peucine; pitchblende
  • 試驗 : trial; experiment; test
  1. Abstract : in this paper, a new metallurgical energy resource has been introduced which includes two fuels : pitch - water slurry ( pws ) and bitumen emulsion fuel ( bef ). a laboratory test of the pws and bef containing 65 % ?

    文摘:介紹了兩種最新研究開發的漿體燃料:硬水漿和燃料;並報道了這兩種新型燃料的實室規模燃燒和性能結果。
  2. The result indicates that in the case of constant content of asphalt, marshall stability, compression strength, rupture strength, compression modulus and rupture modulus of cement emulsified asphalt concrete would increase along with the increase in cement content ; in the case of constant content of cement, these index values would decrease along with the increase in asphalt content ; while with the increase of coarse aggregate, rupture strength and rupture modulus of the concrete would increase conspicuously, yet compression strength and compression modulus would have a little change

    結果表明:在含量不變時,隨著水泥用量的增加水泥混凝土的馬歇爾穩定度、抗壓強度、抗折強度、抗壓回彈模量、抗折回彈模量隨之增加;在水泥用量不變時,隨著用量的增加相應的力學指標呈降低趨勢;礦料級配中粗集料含量增加后,混合料的抗折強度和抗折回彈模量有明顯增加,但抗壓強度和抗壓回彈模量變不大。
  3. Standard test method for determining the viscosity of emulsified asphalts using a rotational paddle viscometer

    用輪槳式粘度計測定粘度的標準方法
  4. Standard test method for distillation of emulsified asphalt

    餾出物的標準方法
  5. Standard test method for oversized particles in emulsified asphalts sieve test

    中篩上粒子的標準方法
  6. Methods of test for petroleum and its products - determination of fines mixing time of cationic bitumen emulsions

    石油及其產品的方法.陽離子劑的細料混合時間的測定
  7. A new modifier for asphalt waterproof material

    聚合物改性稀漿封層的研究
  8. Negative pressure blockage and biological blockage are two main forms of blockage for the special structure of zippered plastic pipes, so two treatments were made here : ( i ) nonwoven fabrics glued by neoprene and ( ii ) nonwoven fabrics glued by neoprene with a layer of asphalt emulsion applied outside

    由於拉鏈式塑料管的獨特構造(拉鏈式滲水孔口) ,所以它的堵塞主要應是負壓堵塞和生物堵塞,為此設2個處理:氯汀膠粘無紡布和氯汀膠粘無紡布並外塗一層進行研究。
  9. Testing of bituminous binders ; evaporation test, testing of bonding emulsion

    粘接劑的檢.蒸發.粘接
  10. Research on emulsified asphalt test methods and concerned contents

    方法及相關內容的研究
  11. Methods of test for petroleum and its products - bitumen and bituminous binders - determination of the ph value of bitumen emulsions

    汽油及其產物的方法.粘合劑.液的ph值的測定
  12. Methods of test for petroleum and its products - bitumen and bituminous binders - determination of settling tendency of bitumen emulsions

    汽油及其產物的方法.粘合劑.測定液的凝固時間
  13. Methods of test for petroleum and its products - bitumen and bituminous binders - determination of penetration power of bitumen emulsions

    汽油及其產物的方法.粘合劑.液的滲透率的測定
  14. Methods of test for petroleum and its products - bitumen and bituminous binders - determination of mixing stability with cement of bitumen emulsions

    汽油及其產物的方法.粘合劑.液混凝土混的混合穩定性的測定
  15. Methods of test for petroleum and its products - bitumen and bituminous binders - determination of efflux time of bitumen emulsions by the efflux viscometer method

    汽油及其產物的方法.粘合劑.利用射流粘度計測定液的射流時間
  16. Methods of test for petroleum and its products - petroleum products - bitumen and bituminous binders - recovery of binder from bitumen emulsions by evaporation

    石油及其產品的方法.石油產品.粘合劑.用蒸發方法從液中回收粘合劑
  17. Methods of test for petroleum and its products - determination of breaking value of cationic bitumen emulsions, mineral filler method

    石油及其產品的方法.用礦物填充法測定陽離子劑的斷裂值
  18. This text primarily discussed the test method that adapt to the specification and ability of cement - emulsified asphalt concrete, it recommended the test method and adding in proper order that the fit admixtrue corrects mstthus test furtherly, then, it brought up the best match of cement - emulsified asphalt concrete through the test, and explained the influence of heat stability with earlier period strength when adding a certain rate of cement into emulsified asphalt concrete, finally studied fisrt the strength of that material to become the principle with technique economy analysis

    本文主要是先討論了適合水泥混凝土材料性能特點的實方法,推薦了合適混合料進一步修正馬歇爾實的測方法及加料順序,然後,通過該實提出了水泥的最佳配合比,並說明了在混合料中加入一定比例水泥后對混合料高溫穩定性和早期強度的影響,同時對一段舊路進行補強,摸索了該用材料施工路面的過程及方法,最後初步探討了該材料的強度形成機理和技術經濟分析。
  19. Standard test methods for emulsified bitumens used as protective coatings

    用作防護覆層的的標準方法
  20. Standard test method for determining demulsibility of emulsified asphalt

    測定性的標準方法
分享友人