火花電流 的英文怎麼說

中文拼音 [huǒhuādiànliú]
火花電流 英文
spark current
  • : fire
  • : Ⅰ名詞1 (種子植物的有性繁殖器官) flower; blossom; bloom 2 (可供觀賞的植物) flower 3 (形狀像花...
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • 火花 : spark; spark discharge; spark-over; scintillance; flake; trigatron; cremation; [電工] electric spark
  • 電流 : current; galvanic current; electric current; electricity; current flow電流保護裝置 current protec...
  1. The concept, characteristics and application of high energy beam machining, electrical discharge machining, electrochemical machining and material abscission machining separately discuss

    分別論述了高能束加工、加工、解加工,以及物料切蝕加工的概念、特徵與應用狀況。
  2. Gas burners are ignited by a high-voltage spark in a pilot gas stream or by an electrically heated wire.

    煤氣燒嘴可在引煤氣中用高壓,亦可用熱絲點
  3. Auto classification of dc - electromotor sparks

    機換向的自動分級
  4. Nowadays, the switches which are being studied or applied, such as gas spark gap, thyratron and ignitron, etc, are of different structures, operating principles, advantages and disadvantages, and are applied in various situations and fields

    目前處于試驗中或者投入實際應用的開關元件很多,如間隙、閘管、引燃管等,它們有不同的結構、原理和優缺點,應用在不同的場合和領域。
  5. This paper describes a system for preignition in motorcycle engine using spark plus as a detecting probe, the author carries out researches on a method how the ionic current coins into being

    摘要本文描述了一種直接利用極作為傳感器檢測南方摩托車發動機早燃的方法,作者在文章中詳細分析及討論了離子的產生機理。
  6. In order to examine the south motorcycle engine preignition phenomenon, using the rich burning information of the massive ions which are produced when the air cylinder is burnt, through analyzing the wave form difference between lighting a fire normally and firing early, it can be determined whether preignition occurs or not

    為了檢測南方摩托車發動機早燃現象,利用其氣缸內燃燒時產生大量的離子信號所包含的豐富燃燒信息,對其塞正常點和熾熱點離子顯示的波形進行研究分析,從而確定是否發生早燃。
  7. Inductive resistance current limiter is comprised of series reactor with lower reactance, damping resistor and sparkle gap

    阻型限器由抗值較小的串聯抗器阻尼阻器和間隙等三部分組成。
  8. Electric cables and wires - d. c. spark test method for insulated cores

    纜絕緣線芯直試驗方法
  9. By using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    通過采樣加工放間隙的壓、信號和檢測壓幅值上的高頻信號的強弱,得出反映間隙放狀態的各種時間脈沖,利用計數器分別對其計數,再送給單片機運算處理,輸出控制環節所需的各種放狀態時間百分數。
  10. Abstract : by using a counter and an operation microprocessor, this paper analyses the measuring method and designs an instrument of edm sinking process in discharge state. this instrument takes samples of voltage, current signal and strong and weak of high frequency signals of detecting voltage amplitude, translates them into various time pulses in discharging state. and a counting unit turns these pulses into digital signals, then send them to a microprocessor. finally various discharge time percentages are sent to the control tache

    文摘:通過采樣加工放間隙的壓、信號和檢測壓幅值上的高頻信號的強弱,得出反映間隙放狀態的各種時間脈沖,利用計數器分別對其計數,再送給單片機運算處理,輸出控制環節所需的各種放狀態時間百分數。
  11. Abstract : there are offered many ways how to improve work of a spark plug. but one of the m ost important problems has not been solved yet. this is a thermal mode operation of a spark plug. the ideal spark plug should be instantly heated at the moment of occurrence of a spark and instantly cooled down in expectation of the foll owing electrical pulse. thus it balances between preservation of heat for self ? c leaning from scale and its removal in avoidance self ? ignition. in this article a uthor managed for this time to offer a spark plug with capability “ self ? regula tion ” of heat flux removed from a zone of ignition. essence of the offer is a t ip , which is transparent for heat flux. it is produced from single crystal of sap phire

    文摘:在如何提高塞的工作質量方面有多種方法,但是其中最重要的一個問題還沒有得到解決,那就是塞工作的熱學模型問題.理想的塞應該能在點的瞬間被立刻加熱,並且在接下來的脈沖過程中迅速冷卻,由此在熱量的存儲與散發之間取得平衡,以避免自點.本文力圖展示一種具有自動調節源於點區域熱能力的塞,其技術的關鍵是頂部絕緣體材料,它是由藍寶石單晶製作,而非傳統的氧化鋁陶瓷
  12. A series of multi - pulse experiments are performed at breakdown voltage up to 400kv, peak current up to 30ka with an interval of 5ms, which shows spark gap switch could be obtained good insulation recovery in several milliseconds under the condition of water dielectric pulse power modulator with low load

    在擊穿壓400kv ,峰值30ka ,脈寬40ns的工作參數下,採用吹氣的辦法(氣速度30m / s ) ,使氣體開關多脈沖運行間隔達到5ms ,實驗結果與理論估計相符。
  13. Ac induction motor will govern speed stepless, no brush 、 no spark and long life

    感應機無極調速,無刷、無、長壽命。
  14. Design engineers now selecting pmbldc motors over conventional dc or induction motor drives for the following reasons : 1 ) the absence of brushes results in an essentially maintenance free operation and eliminates the undesirable effects of commutation such as sparks, brush - loss, radio - frequency interference, etc. 2 ) the low inertia of the rotor enhances the quality of the mechanical response of the motor, shortening the acceleration and deceleration time. 3 ) utilizing rare - earth permanent magnet materials with high coercive force results in substantially higher efficiency than their counterpart with brushes of the same size. 4 ) because of the absence of commutation segments, the stator construction is simple

    現在的工程師們更為青睞永磁無刷直動機是因為以下幾點原因: ( 1 )去除了刷的永磁無刷直動機徹底地免除了維護而且消除了我們不希望的由於換向帶來的刷損耗以及無線干擾等等; ( 2 )低轉動慣量的轉子提高了機機械響應的質量,從而縮短了機加速和減速的時間; ( 3 )高矯頑力稀土永磁材料的使用使得同樣尺寸的永磁無刷直動機比傳統的直動機效率高; ( 4 )由於沒有機械換向部分定子的結構簡單了。
  15. Soon marconi ' s own spark - gap transmitters are sending morse - code pulse streams across his lab without wires

    不久,馬可尼自製的發送機,就能以無線的方式在實驗室里傳送摩斯碼脈沖了。
  16. Vacuum switchgear tubes, gas spark gaps and pseudospark tubes are all switches of gas discharge theory, and have the good qualities of high withstanding voltage, high amplitude of current and high power

    真空開關管、開關、偽管都是利用氣體放理論的開關元件,具有高耐壓能力、高峰值、功率大等優點。
  17. Jingyijia was established in 1998, who is professional in manufaturing plastic mould, die - casting products. the workshop is more than 2000 cm2. the moulds was started to be exported to south asia and europe in 2001 using cnc milling machine, electrospark, wire - electrode cutting, etc. technique is unending while no the best in moulds. only by untiring working, reserching and improving, can we design good moulds. we welcome every old and new friend both at home and abroad to visit us and building business relationship

    廈門精藝佳公司成立於98年,百分百開發生產塑膠產品,壓鑄產品,製造各類塑膠壓鑄模具.模具廠使用面積兩千多平方米,多臺大型cnc銑床及,線切割能加工製造, 3 . 5米以下各類模具. 2001年開始模具出口東南亞及歐洲.技術永無止境,模具永遠沒有第一,只有不懈努力,研發,改進才能設計好模具.我們真誠期望國內外朋友,同行蒞廈交指導,為繁榮經濟推動民族工業科學進步和偉大復興作應有貢獻
  18. It throughly solved some long time complicated questions such as high service rate in dc motor, large quantities of maintaining contact type drive controller, high energy consumption of dc locomotive

    徹底解決了直機維修率高、換向及接觸組大、觸頭式司控器維修量大、直機車能耗高等老大難問題。
  19. Experimental results indicate that pulse current causes denser deposit, which leads to the decrease of edm tool wear ratio

    鑄層作為加工極時,脈沖鑄可以降低極損耗率。
  20. On the basis of a lot of experimental data based on the orthogonal test of pulse peak electric current, pulse width and pulse intermission, experimental mathematical models of electric spark forming of several sorts of materials are built up with multiple linear regression analysis

    摘要用正交試驗法對加工中的峰值、脈沖寬度、脈沖間隔進行設計,在大量實驗數據的基礎上,採用最小二乘法建立實用的多種材料的加工實驗數學模型。
分享友人