焊接大樑 的英文怎麼說
中文拼音 [hànjiēdàliáng]
焊接大樑
英文
welded girder-
So the circumjacent welding should be applied at this spot and another join symmetrical to it, all sides of the place at which angle iron join are welded around with the main beam
因此應該在該位置以及與之對稱的另一聯接點處都應採用周邊焊，使角鋼連接處的各邊全部焊接，然後再與大樑周邊焊接。Results showed that the ductility of bolt spjice is much better than welds, weaker splice joints develop larger plastic deformation, slipping between faying surfaces, bearing of bolts to hole surfaces and buckling of splicing plates are all ideal energy dissipation mechanism
試驗結果表明：螺栓拼接節點的延性遠好於樑柱焊縫連接；較弱的拼接節點產生較大的塑性變形；接觸面的滑移、螺栓與孔壁的擠壓和翼緣拼接板的屈曲都具有良好的耗能能力。The conclusion of reappearing analysis is that crane bridge be used as usual because main weld maximum stress of upper cover plate of main beam lower than yield limit though it higher than permissible stress. inner stress of secondary beam was over ultimate strength, and deforming is ultra big. so it was unfit for produce and secondary beam must be changed
再現分析得出的主要結論為：橋架的主樑上蓋板主焊縫的最大應力超過了許用應力，但小於屈服極限，可以繼續投入使用；副梁內部的應力遠遠超過了強度極限，變形特別嚴重，不能滿足生產要求，因此更換新的副梁；端梁內部的應力超過了屈服極限，小於強度極限，在應力較大的位置焊接補強板；投入使用后，要對整個橋架進行定期檢查。But during the 1994 northridge earthquake and 1995 hyogoken - nanbu earthquake, beam - to - column connections experienced a great deal of brittle fracture phenomenon, which indicated that the performance on the damage mechanism of some style joints were rather inadequate
但在1994年northridge和1995年阪神地震中，樑柱連接發生了大量的脆斷現象，顯示出了人們對于鋼框架樑柱栓焊連接節點認識上的不足。分享友人