無控制系統 的英文怎麼說

中文拼音 [kòngzhìtǒng]
無控制系統 英文
non control system
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : 動詞1 (告發;控告) accuse; charge 2 (控制) control; dominate 3 (使容器口兒朝下 讓裏面的液體慢...
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  1. As we all known, the ballistic trajectory is a pilotless missile, which loads rocket engine and control system, these will drop the missile to the target along its ballistic

    眾所周知,彈道導彈是一種人駕駛的飛行器,它裝有火箭發動機和,其目的是把導彈沿一定的彈道送到目標區。
  2. This paper is based on " the remodeled item of the 122mm automatic barbette servo system ". it introduced the controlled project of brushless direct current motor realized by dsp at first. on the base of analyzing and studying the driving wave of the brushless direct current motor thoroughly and fully, it carried on the servo system ' s simulink and presented the concrete software and hardware ' s devise of the whole system in the end

    本論文的撰寫是以「 122mm自行迫榴炮伺服的改型項目」為基礎,首先介紹了dsp實現刷直流電機的方案,在深入、的分析和研究了刷直流電機驅動波形的基礎上,然後進行了伺服的模擬,最後給出了伺服具體的軟硬體設計。
  3. Aiming at the problem that the system of passive interference and photoelectricity counterdevice antagonizes the missile of resisting naval vessel, the paper expatiates main structure, work principle and used foreground speediness reaction capability of servocontrol system of photoelectricity interference applied to capital ship and medium - sized ship

    本文針對艦載源光電干擾對抗反艦導彈的問題,闡述了大中型艦艇光電干擾伺服製表的組成結構、工作原理及應用前景。艦載光電干擾伺服採用機電式穩定平臺結構。
  4. The research and development of flight control system is not dissociable with simulation technology. simulation has become an important tool for successful development of flight control system of unmanned helicopter

    人直升機飛行的研製已和模擬技術密不可分,模擬已成為人直升機飛行研製成功的必要手段。
  5. This dissertation is the result of the research and development of a speed - sonserless field - oriented controller ( foc ) system of induction motor

    本論文的研究目標是感應電機速度傳感器矢量的實現。
  6. The method can eliminate the conventional fuzzy control system ' s steady - state errors and flutters. and, the method of forward feed control is used to reduce the tracing errors during glide slope phase

    在此基礎上,採用帶優化修正函數量化的模糊方法,設計飛機的微波著陸,並進行了閉環模擬。
  7. At present, our country is the largest producer and consumer in the horniness - alloy scopes. but now, this stove depends on import, hip - sinter stove ’ s self - develop and corresponding control system has important apply value

    目前我國是世界上最大的硬質合金生產與消費國,但生產所需的燒結爐仍主要依賴進口,自主研製低壓真空燒結爐及配套的疑具有重要的應用價值。
  8. The aim of this dissertation research is focused on the pre - research defense projects of “ research on longevous service and high reliability of satellite ” of the national tenth - five - year plan. for improving the capability of fault diagnosis for un - presuppose faults, we propose a new fault reconstruction technique which suits to satellite attitude control system and four novel techniques under this frame work is investigated in this dissertation

    本文以國防十五預研項目「衛星長壽命高可靠性技術」為研究背景,為提高目前衛星對故障模式故障的診斷能力,提出了一套適合衛星姿態的故障重構框架體,並研究了四項關鍵技術作為該框架的支撐。
  9. Line no - error nc interpolation techniques used by mc

    平面誤差直線軌跡
  10. Design of flight control appliance used in minitype pilotless aircraft

    小型人飛機的飛行器設計
  11. The paper designed aerodynamic control system of pith and yaw channels and roll angle stabilization system, by using unsteady - state error follow - up control theory and state observation station theory in modern control theory

    本文使用現代理論中的靜差跟蹤理論與狀態觀測器理論,設計了俯仰、偏航兩個通道的氣動力和滾轉角穩定
  12. Firstly, to realize the motor control system, the rudimental principle of the bearingless induction motor is investigated

    本文闡述了軸承異步電動機工作原理,對電機進行了理論分析和模擬研究。
  13. The control system of mould level is crucial to improve the slab quality in the continuous casting process, pid controller is used in the traditional mould level control, and it has some defaults, such as : at the start - up or finishing period of casting or during the changeover of tundish, pid control has a bad effect, its overshoot is large and its transient time is long ; the erosion of the tundish stopper and the submersed nozzles lead to the accuracy of control become bad ; the abrupt falloff of block in the submersed nozzles makes the level acutely fluctuate, and pid control can not overcome the disturbances resulted from the change of casting speed

    結晶器液位是提高連鑄產品質量的關鍵環節,傳的連鑄機液位方法採用常規的pid,存在如下不足:開始、結束澆注和換中間罐澆注時,效果差,超調量大,過渡時間長;塞棒頭和浸入式水口被腐蝕后引起精度差;浸入式水口堵塞物的突然脫落所引起的液位劇烈波動;法克服拉速波動引起的擾動。
  14. Study on flight management and control system for uninhabited combat aerial vehicles

    人戰斗機飛行管理與分析
  15. Use zero water pressure opening of valve core without any medium pressure, suitable for the sewage - draining control system of pipelines, water tank etc. containers and the automatic water falling of a drinker. this valve can be fitted with another more than 60 kinds of valve casings, resulting in a flexible installation

    採用零水壓開啟閥芯,開啟須介質的壓力,適用於管道水箱等其他容器的排污飲水機的自動下水等,該閥另有六十余種閥體與之匹配,安裝靈活。
  16. In this thesis a fuzzy control system used in voltage and reactive power auto regulatory device is designed based on the nine - zone controlling principle. in the fuzzy system, the fuzzy reasoning is mamdani method and the antifuzzy is centroid method. the software matlab is used to calculate the fuzzy system. the fuzzy system divide the voltage - reactive pane into fuzzy zone, in this way the domain - swing between closing domain is eliminated

    論文對電壓功綜合技術進行研究,針對傳九區域分區方法視電壓與功耦合的缺點,結合變電站電壓的實踐經驗,在傳方法上引入模糊,設計了基於模糊的電壓功綜合。模糊推理中採用mamdani型推理,非模糊化採用重心法,設計中使用matlab進行輔助設計和離線計算。
  17. The feasibility and validity of the hardware and software implementation for the reactive power compensate control system is verified

    通過試驗驗證了功補償軟硬體設計方案的可行性和正確性。
  18. As an important part of the project of developing an ecs for mw wtgs, the thesis makes overall theoretic analyses and experimental studies on reactive power compensate control system and yaw control system

    作為單機電氣技術研究的重要組成部分,本文對功補償和偏航展開了比較全面的理論分析和實驗研究。
  19. This new family of dsp ' s enables cost - effective design of intelligent controllers for brushless motors which can fulfill enhanced operations, consisting of fewer system components, lower system cost and increased performances

    利用dsp列晶元進行低成本、高智能刷電機的設計,能夠簡化構成、降低成本、增強性能,同時能夠勝任各種操作要求。
  20. Thispaperhasstudiedonthedatalinkinterfacetechniqueoftacticalcontrolsystem. firstof all, functional requirement and the important role of data link interface in tactical controlsystem is introduced ; secondly, with object oriented method, the characteristic of uav taskcontrol process is analysed, and then uav task control information model is established, anddata link interface standard of tactical control system is designed based on this model, including message format and transmission mechanism ; thirdly, data link control module isdesigned based on embedded linux operating system and has realized conversion betweendata link standard interface and the private interface of uav data link ; and then, combinationreal time corba middleware and its event channel, data link control modular componenttechnology is studied, and realization scheme is put forward ; finally, demostration is madebased on prototype of tactical controlsystem, which verify the validaty of data link interfacestandardandembeddeddatalinkcontrolmodules

    本文對戰術中的數據鏈介面技術進行研究:分析了數據鏈介面在戰術中的功能需求;採用面向對象的方法,分析人機任務問題,建立了人機任務信息模型,並基於該模型設計了數據鏈介面通信協議,包括報文格式和傳輸機;基於嵌入式linux設計了數據鏈介面模塊,實現了數據鏈標準介面與人機數據鏈私有介面之間的相互轉換;結合實時corba中間件及其事件通道,研究了數據鏈介面模塊組件技術,並給出了實現方案;通過戰術原理實驗的演示實驗,驗證了數據鏈介面通信協議和嵌入式數據鏈介面模塊的有效性。
分享友人