無旋向量 的英文怎麼說

中文拼音 [xuánxiàngliáng]
無旋向量 英文
irrotational vector
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : 旋Ⅰ動詞1 (旋轉) whirl 2 (用車床切削或用刀子轉著圈地削) turn sth on a lathe; lathe; pare Ⅱ名詞...
  • : 量動1. (度量) measure 2. (估量) estimate; size up
  1. These results indicate that the magnetic field should have upper stability when the particle beam is low polarized while the requirement of the stability of the magnetic field can be lowered when the particle beam is high polarized in the experiment of producing the polarization of the particle beam. and the complementariness can be used as a negative feedback to stabilize the polarization of particle

    這一結果表明,在產生離子束極化的實驗中,在離子束低度極化的前期階段,磁場應具有較高的穩定性,而在離子束極化度較高的後期階段,磁場的穩定性要求可以放鬆;自的縱規漲落和橫規漲落的互補性有可能用來做成穩定離子極化的負反饋。
  2. At the same time, on the basis of above results, the stability problem of the polarization of particle self - spin is discussed in irregular magnetic field of accelerator. the discovery that the low degree polarization system is very sensitive to the irregular magnetic field while the high degree polarization system is very stable is found. the irregular fluctuation of the vertical ponderance is complementary to that of the horizontal ponderance due to the self - spin conservation

    同時,在此基礎上,利用su ( 2 )代數動力學方程研究了加速器中帶自離子的極化對磁場的含時規擾動的穩定性問題,發現:低度極化的系統對磁場規擾動十分敏感,而高度極化的系統對磁場規擾動十分穩定;自守恆導致自的縱規漲落和橫規漲落存在著互補性。
  3. The results indicate that : the high positioned air inflow do good to heat transfer in rotator disk ; different size of radial outflow have small effects on flow and heat transfer ; the heat transfer near rotating disk increases as rotating reynold number increases or non - dimensional mass flow rate increases

    結果表明,高位軸進氣對轉盤換熱有利;不同的徑出口大小對盤腔內的流動換熱影響不大;隨轉雷諾數和綱質增加,轉盤盤面的換熱效果增強。
  4. By comparing the results with relative experiment data, it is shown that rng k - is more exactly than the other turbulent model. 2 ) the influences of axial inflow position, radial outflow size, rotating reynold number, non - dimensional mass flowrate and axial inflow angle on the flow and heat transfer characteristics were numerically investigated for a typical rotator - stator cavity with axial inflow, radial inflow and radial outflow. the correlations for average nusselt number vs rotating reynold number or non - dimensional mass flowrate were established

    ( 2 )針對一典型的徑、軸進氣,徑出氣的轉-靜盤腔結構,系統研究軸進氣位置、徑出口大小、轉雷諾數、綱質和軸垂直預進氣等對盤腔內流動和換熱的影響,整理出轉-靜盤腔內轉盤平均努謝爾數與轉雷諾數綱質之間的準則關聯式。
  5. The true dimensions of a divine creativity would be unendurable for any one consciousness of whatever import , and so that splendor is infinitely dimensionalized ( most intensely throughout ) , worlds spiraling outward with each " " moment " " of a cosmic breath ; with the separation of worlds a necessity ; and with individual and mass comprehension always growing at such a rate that all that is multiplies itself at microseconds , building both pasts and futures and other time scales you do not recognize

    一個神聖的創造的真正維度對任何一個論何種意義的意識而言,都是法忍受的,這種壯麗是限維度化的(強烈到遍布一切) ,這同樣是意識法忍受的,這些世界隨著宇宙呼吸的每一『瞬間』外盤;因為它們相互分離是一種需要;因為個人和大眾的內涵總是以如此的速率增長,以致於一切全有每一微秒都在增殖它自身,建構過去和未來,以及你們並不知曉的其他時間度。
  6. Based on the review, the fluid flow and heat transfer in the curved circular and rectangular pipes have been researched by employing perturbation method and numerical simulation with a physical model under the rotational orthogonal curvilinear coordinate in a rotating curvilinear pipe with multi - parameters. we firstly analyzed the fully developed fluid flow and heat transfer, mixed convection heat transfer, the development of flow and heat transfer in the inlet in different cross section ( circular, elliptical, annular and rectangular crossection ). the variations of the secondary flow, axial velocity, distribution of temperature, the friction force on the wall, the ratio of friction factor as well as the nusselt number with different dimensionless parameters had been examined in detailed

    本文在總結和分析了一個世紀以來有關曲線管道流動和換熱特性的研究成果的基礎上,以轉正交曲線坐標系統下的多參數轉螺管道中的對流傳熱為物理模型,通過攝動方法和有限體積法,首次對各種截面(圓截面、橢圓截面、環形截面、矩形截面)轉曲線管道內充分發展流動的流動結構和傳熱特性(包括耦合對流傳熱特性)以及轉曲線管道開口段發展流動的流動結構和換熱特性進行了系統的數值模擬和理論分析,詳細討論了各種綱參數對管道內軸速度分佈、二次流結構、溫度分佈、壁面摩擦力、摩擦系數比以及管道nusselt數的影響,獲得了若干創新性成果。
  7. Current nod external nomal method can accurately solve the initial clearance of contact curved surface. the accurate analysis of load distribution, longitudinal load dispersion and contact patterns to spiral bevel gears has been deduced, and that the variation of the contact center of loaded spiral bevel gears and the contact center of non - loaded spiral bevel gears has been analysed

    當前節點外法矢法可以精確計算接觸曲面的初始間隙,本文用這一方法對螺錐齒輪齒間載荷分配、齒載荷分佈以及接觸區形狀進行了精確分析,而且分析了加載情況下螺錐齒輪齒面接觸中心點軌跡與載下螺錐齒輪接觸軌跡的變化。
  8. In present dissertation, dynamical process of transition from the vortex state to the core state with lower energy and no angular excitation after removing the external rotating perturbation which makes the vortex state formed in bec is discussed firstly

    論文首先討論外界轉的微擾使bec產生渦,之後被撤掉,渦低、角動激發的核心態躍遷的動力學過程。
  9. In this paper, a new way of real - time damage detection method was proposed according to the high speed working situation of the composite flywheels for energy storage, and a suit of equipment was developed to test the composite samples with piezoelectric disc built - in, the response waves before and after the damage occurred were recorded to the computer. on the base of traditional spectrum analysis of signal recorded, the wavelet analysis was introduced and the program in matlab language was made. with the wavelet packet decomposition of the signal, the relations between the change of response signals and damage characters were gotten, a database for damage recognition was created

    本文結合儲能復合材料飛輪高速轉的工作特點,提出了一種在線檢測飛輪轉子損傷的方法,自主設計一套實驗裝置對模擬各種損傷的的試樣進行了測試,試樣損傷前後的響應信號被採集后存入計算機中;在對採集信號進行傳統的頻譜分析的基礎上,引入了先進的小波分析理論,利用matlab語言編寫程序,對信號進行小波分解,得到了信號變化和損傷特徵之間的關系,建立了一個識別飛輪損傷的數據庫;小波包分解得到信號對比圖和特徵,可以有效判定材料內部有損傷和損傷的程度,結合頻譜分析等,可一定程度上判定損傷的類型,為儲能飛輪的安全運轉和智能化運作提供了決策依據。
  10. This instrument hopes to control the step - motor regularly, and collects the datum of the distance between the laser sensor and the wall simultaneously, then calculates area according to the theory of triangle, finally sums up all the area and makes the output

    本系統前通道信號由激光傳感器提供,後通道信號發給步進電機、傳感器,由於是轉式測,必須控制激光發射信號的通斷和步進電機的步距角,否則測出的值是法計算的。
  11. The main contributions of this work are included as follows : ( 1 ) numerical tests of the outside axial and helical flows were carried out respectively. the velocities and pressure profiles and shear distributions have been obtained and they were compared due to the different flow field. it is concluded that when no particles are deposited, the helical flow would lower the pressure on membrane surface to some little extent but not markedly

    ( 1 )對外軸流和外切流兩種方式下膜器環隙內流場進行變參數數值實驗,作出流場及切應力的分佈規律,分析顆粒沉積時層流條件下流動結構對過濾通的影響,認為:採用外流的方式將對膜面壓力有削弱作用,但並不明顯。
  12. First, the direction of fringe variation in the interference images is different with different intake duct, but in the same intake duct, the direction is the same. second, different intake duct has different rules to flow variation. third, the infinite width of interference fringe is visual, high precision, and easy to qualitative analysis, but the finite width of interference fringe is easy to judge the direction of fringe variation and to further detailed analysis

    實驗結果表明,氣道不同,條紋的變化方不同,但同一氣道在不同的流下,條紋的變化方是一致的;不同形狀的氣道對流的敏感程度不同,對氣體流的擴散作用影響也有很大的差異;用限寬條紋法得到的圖像直觀,靈敏度大,易於做定性的分析對比,而有限寬條紋法可以進行流體在運動方的判別,更有利於詳細的分析研究。
分享友人