無源集線器 的英文怎麼說

中文拼音 [yuánxiàn]
無源集線器 英文
passive hub
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : 名詞1. (水流起頭的地方) source (of a river); fountainhead 2. (來源) source; cause 3. (姓氏) a surname
  • : gatherassemblecollect
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 無源 : [無線電] passive無源電路 passive circuit; passive electric circuit; 無源天線 passive antenna; ref...
  1. Another increasingly important ( actor is to be integrated with analog and digital circuits. for this reason, it is highly advantageous for the microwave components to be fabricated through a commercial cmos process. so we research the microwave transmission lines and apply it into phase shift

    微型硅基微波傳輸是微波、有件及微波成電路的重要構成基礎,本文首先對其工作原理、件模擬、結構參數設計、制備及散射參數測試進行較深入全面的研究,並進一步將微波傳輸理論應用於mems移相,對移相的結構參數、相移特性及可靠性等進行了分析。
  2. Ningbo ekey ruineng electric technology co., ltd. is ningbo ekey holding groups subsidiary company. the head offices main business is embedded software industry and hammer at development the software exploiture and design, network engineering, chip development, ipv6 digital switching equipment, mobile communications, internet phone, intelligent home electric equipment, automobile anti - theft devices, unlimited remote control and power adapter, etc high - tech industri

    寧波易科瑞能電子科技有限公司是寧波易科投資控股有限公司下屬子公司,團公司以嵌入式軟體產業為主營業務,以軟體開發設計,網路工程,晶元研發, ipv6數字交換設備,移動通訊,網路電話,智能家電,汽車防盜限遙控,電適配等高科技產業為重點發展方向,並從事房地產開發,酒店投資管理,國際國內貿易等業務,在投資總規模超過11億人民幣
  3. Many practical factors, such as effects of line fuses protection, disconnected switches, scheduled maintenance, spare electrical source, spare transformers in distribution system, are considered in the assessment arithmetic. in the assessment, it is more practical that low - voltage power system is equivalent to an element on the lateral section of mid - voltage system. especially, the minimal cut - sets are divided into direct cuts and indirect cuts, which makes the effects of elements in cuts on system more legible and exact

    演算法考慮了分支熔斷保護、隔離開關、計劃檢修、備用電、有備用變壓的影響,將低壓系統等效為中壓系統分支饋上的一個等效元件進行評估,使得該方法更符合實際,特別是,將最小割分為直接割和間接割,使割元件的影響更加清晰準確,並以c + +語言編制了計算軟體。
  4. The device can measure reactive parameters in distribution power net which are generally considered to he difficultly measured the paper also introduces the calculating method of the reactive compensation capacity and its optimal location, the design method and realization principle of the series devices, such as the reactive power acquisition device, the reactive power optimized controller and the compensation capacitor operator, is seated in detail through economic and technical comparison, a realistic hardware scheme of reactive power compensation system is proposed

    文章利用電磁感應原理和數字通訊技術結合試驗設計出電自給式高壓信號採裝置,解決了配電網分支功參數不易測量的問題。文章還介紹了系統功補償容量及安裝位置的計算方法,較為具體的講述了功功率採功優化控制以及補償電容操作等一系列裝置的設計方法和製作原理。通過經濟技術比較提出了一整套切實可行的功補償系統硬體製作方案。
  5. To date, most research on cmos rf circuits is focused on cmos rf front - end including some key building blocks such as low - noise amplifier ( lna ), mixer, bandpass filters, voltage control oscillators and power amplifiers. in si rf 1c, inductors need be realized on a silicon substrate along with all of the other devices in a single chip. in fact, the need for high q integrated inductors in rfics is increasing

    通信技術對cmos射頻成電路需求的大背景下,本論文在大量深入調研的基礎上,圍繞射頻成電路中必不可少的、有多種應用的件?硅成電感及其相關的cmos射頻成單元電路,先後在上海冶金所微電子分部工藝上及利用上海市科委的多目標晶元項目( mpw )在錫華晶上華半導體有限公司進行了大量的實驗研究,得到了一些新的結果。
  6. The main new points are : ( 1 ) a novel type of icc shielding layer structure has been first studied by classifying as l - type icc and c - type icc. and conclude that which icc structure is more suitable for ic realizations of i / o pad, inductors, baluns etc. ( 2 ) optimize designs of i / o pad, inductors, baluns by icc structures

    本論文主要的研究工作如下: ( 1 )新型icc分為感性icc屏蔽( l型icc )和容性icc屏蔽( c型icc ) ,根據這樣的分類優化選擇分別適合高頻成電路中常用的連接、 i / opad 、成電感和成巴侖等件的各類新型icc屏蔽工藝結構。
  7. Coplanar waveguides ( cpw ' s ) offer several advantages over conventional microstrips, these include the simplification of the circuit fabrication process, ease of parallel and series insertion of both active and passive components ( without the need for via holes ), and high circuit density. therefore cpw ' s are widely used in microwave and millimeter - wave integrated circuits, optical and high temperature superconductor microwave devices

    與常規的微帶傳輸相比,共面波導具有容易製作,容易實現、有件在微波電路中的串聯和並聯(不需要在基片上穿孔) ,容易提高電路密度等優點,因此共面波導被廣泛應用於微波、毫米波、光學和高溫超導等成電路中。
  8. And the general procedures of these methods are summarized. finally, some practical problems are analyzed using fdtd, which include passive linear resistor element and nonlinear diode element in the microwave circuits and an integrated antenna embedded with an active gunn diode element and a dielectric cavity resonator

    最後,本文通過編程模擬了微波電路中的件電阻和非件二極體,含有有件gunn二極體的有成微帶天以及介質腔諧振等具體實例,來驗證各種方法的可行性和有效性,計算結果與實驗結果吻合。
  9. The integration of wireless acceleration sensor for structural global monitoring, the integration of wireless strain sensor for structural local monitoring, their corresponding network ’ s topological strucuture, the network ’ s communication protocol, saving energy and the network ’ s experiments are studied systemly, the main contents include : 1. for strucutal global monitoring, the electronics components are compared, anlysysed and seleced. on this base, the design modulization method is used for designing and debugging sensing disposal module, micro - processing module, wireless transceiver module and power module, and thus a wireless acceleration sensor node with digital interface is integrated using the above modules

    本文在充分研究傳感技術、信號處理技術、通信技術的基礎上,針對土木工程結構整體性態監測的加速度傳感成、結構局部性態監測的應變傳感成以及相應的傳感網路拓撲結構、網路通信協議、網路能耗處理、網路試驗等問題進行了系統的研究,主要研究內容如下: 1 .針對結構整體性態監測的需要,從設計的小型化、低功耗、低成本、高可靠性角度出發,對相關電子件進行了比較、分析、選擇;在此基礎上,採用模塊化設計方法,對傳感處理模塊、微處理模塊、收發模塊以及能模塊分別設計、調試,進而成了基於數字介面的加速度傳感節點。
分享友人