無粘滯性 的英文怎麼說

中文拼音 [niánzhìxìng]
無粘滯性 英文
inviscidity
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : 粘動詞(粘附) glue; stick; paste; adhere to; bond
  • : Ⅰ動詞(使停滯; 使不流通) stagnate; block up Ⅱ形容詞(停滯; 不流通) sluggish; slow-moving; stagnant
  • : Ⅰ名詞1 (性格) nature; character; disposition 2 (性能; 性質) property; quality 3 (性別) sex ...
  1. The low - cyclic reversed loading tests of two unbonded partially prestressed concrete frames with different ppr have been carried out. the aseismic behaviors are analyzed and compared, with emphases on failure mechanism, hysteretic property, displacement ductility, energy - dissipation capacity as well as stiffness degeneration, etc. the results show, when designed rationally, the unbonded partially prestressed concrete frames can form beam hinge energy - dissipation machine and total destroy mechanism

    通過兩榀不同預應力度的結部分預應力混凝土扁梁框架結構的低周反復荷載試驗,分析研究了結部分預應力混凝土扁梁框架結構的破壞形態、回特、位移延、耗能能力、承載力及剛度退化等抗震能。
  2. A method is provided to measure the friction parameters of the bed. the maximum friction torque, coulomb friction torque, viscous friction coefficient and moment of inertia can be gotten by fitting the free reduced rate curve of the gimbals and measuring the motor current when the motor begins to rotate

    提出了一種測量轉臺摩擦特的方法,通過對轉臺在外推力作用下的速度衰減曲線的擬合以及電機啟動過程電流和轉速的測量,可以得到最大靜摩擦力矩、庫侖摩擦力矩、摩擦系數及轉動慣量。
  3. The objective of the paper is to analyze the mechanism of the process in inorganic gel preparation and the key parameters for deciding the quality of the products, which include the following parameters : purity montmorillonite, decentralization and viscosity in organic gel

    本文分析了利用膨潤土製備機凝膠的工藝過程機理及為保證產品質量需要控制的關鍵參加,即蒙脫石的提純純度,機凝膠的高分散
  4. Considering the behaviors of unbonded prestressed concrete beams and steel reinforced concrete columns, a kind of nonconforming beam - column element was constructed and the analysis precision was improved. loading and reloading paths were introduced into the constitutive relationship of concrete. it is helpful to the analysis program to trace the full - range mechanical behavior of structures including the descending part and the hysterisis characteristic under cyclic loading

    考慮結預應力混凝土梁、型鋼混凝土柱等結構構件的受力特點,構造非協調樑柱單元,提高了分析精度;混凝土的本構關系中,引入卸載路徑和再加載路徑,使得分析程序可以追蹤包括下降段在內的結構全過程力學行為,以及反復荷載下結構的回特
  5. Low viscous drag and high - speed capability : the low viscous drag of the magnetic fluid, and non - contacting seal configuration of the magnetic fluid feed through assure its extremely smooth operation and its high - speed capabilities

    低阻尼和高速旋轉能力:磁流體極低的阻力和磁流體進行給裝置需接觸密封圈的結構,決定了它的穩定操作和高速轉動。
  6. At the same time, it brings the greater displacement reaction, lower energy - dissipation capacity and badly ductility ability etc. the unbonded partially prestressed concrete flat - beam frame structure has been used in the practice project in our country, but the aseismatic study of this structure is not perfect at present, study on theory is lagged behind the demand of engineering apply. it has important theoretic meaning and applied value to go deep into the examinational study about the prestressed concrete flat - beam frame structures

    近年來國內已經開始在實際工程中採用結部分預應力混凝土扁梁框架結構,但是目前對這種結構形式的抗震研究工作還不完善,理論研究已後於工程應用的需要,因此深入進行扁梁框架結構的研究,在經濟合理的情況下確保該結構的抗震安全具有重要的理論意義和應用價值。
  7. Based on tests of three moment - resisting beam - column connections under low reversed cyclic loading, this paper inquires into the failure pattern, hysteresis loop curves, displacement - restoring capacity, displacement ductility and energy dissipation of the precast prestressed beam - to - column concrete connections with unbonded tendons

    摘要通過三個框架節點在低周反復荷載下的試驗,對結預應力裝配式混凝土框架連接的破壞形態、回曲線、變形恢復能力、位移延、能量耗散等能進行了研究。
  8. Previous research showed that the unbonded prestressed concrete member has the similar ductility to the commom reinforced concrete member, while the energy - dissipating capacity is worse that can be found from the narrow hysteretic characteristic

    以往的研究也表明:結預應力混凝土構件具有與普通鋼筋混凝土構件相近的延,但其耗能能力隨著預應力度的加大而有所降低,表現在回環的捏攏現象越來越明顯。
分享友人