無軸雙面 的英文怎麼說

中文拼音 [wúzhóushuāngmiàn]
無軸雙面 英文
anaxial dihedron
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 軸 : 軸Ⅰ名詞1. （圓柱形的零件） axle; shaft 2. （對稱部分的直線） axis 3. （圓柱形的纏繞器物） roller; spool Ⅱ量詞（用於纏在軸上的線以及裝裱帶軸子的字畫）
  • 雙 : Ⅰ形容詞1 （兩個） two; twin; both; dual 2 （偶數的） even 3 （加倍的） double; twofold Ⅱ量詞（用...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. In this thesis, studies are focused on as follows : ( 1 ) based on analyzing the general transfer - matrix, the conception of the generalized double layer soil model is proposed, and the transfer - matrix ( r ) of half - infinite elastic mass is introduce - d to the analytic expressions of stress and settlement under the uniform circular, rectangular and strip vertical loads in multi - layered soil ; ( 2 ) according to the analytic expressions of the additional stress and settlement under unifo - rm circular in multi - layered soil, rectangular and strip vertical loads, the programs are develop - ed to resolve and debugged. the results show that the programs are correct ; ( 3 ) through calculating the coefficient of additional stress on the central axis of uniform circ - ular vertical loads, under the corner point of the uniform rectangular vertical loads, and on the central axis of uniform strip vertical loads, and the settlement on the center of uniform circular vertical loads and uniform rectangular loads in double - layered soil, the characters of stress and settlement are discussed ; ( 4 ) a case, as an example, is studied with different calculation methods, such as traditional theory, fem. the results obtained are compared

    本文在已有研究成果的基礎上進一步開展了以下幾方面的研究： （ 1 ）在對層狀地基傳遞矩陣法中的總傳遞矩陣分析的基礎上，提出了廣義雙層地基模型的概念，並把半無限體的傳遞矩陣r引入到多層地基在圓形垂直均布荷載、矩形垂直均布荷載及條形垂直均布荷載作用下附加應力與沉降的解析式中； （ 2 ）根據多層地基在圓形荷載、矩形垂直均布荷載及條形垂直均布荷載作用下附加應力與沉降的解析式，編制了程序，調試通過並驗證了其正確性； （ 3 ）通過對雙層地基圓形垂直均布荷載中心軸線上的附加應力系數和荷載中心沉降，矩形垂直均布荷載角點下的附加應力系數和荷載角點沉降及條形垂直均布荷載中心軸線上的附加應力系數進行的計算，探討了雙層地基中的附加應力與沉降特性； （ 4 ）應用本文的層狀地基體系理論對一個工程實例進行了計算分析，並與傳統的計算方法的計算結果和有限單元方法的計算結果進行了對比分析，結果表明利用層狀地基理論計算更能反映地基中附加應力分佈的實際情況。
  2. There are two different constitution forms for the square tubes with ribs in the test specimens, one consists of two welded channels with stiffening lips ( channel tubes ), stiffening lips ( angle tubes )

    根據無肋、單向設置斜肋和雙向設置斜肋3種截面形式、 2種截面尺寸的18個薄壁鋼管混凝土軸壓短柱試驗結果，比較和分析了各試件的試驗現象、破壞模式及荷載位移曲線等。
  3. Referring to three kinds of plan irregularity, structures individually with four kinds of irregularity as eccentricity in one direction, eccentricities in two directions, re - entrant corner irregularity and diaphragm discontinuity have been analyzed to investigate the relationship between torsion effects and parameters of above irregular structures. the parameters and the schemes for determining the scope of structures with different kind of irregularity considering seismic action in two directions simultaneously are proposed, some conclusions have been get as following : it is indicated by the analysis results that torsion effect has no dependency relation with eccentric torsional angel adopted in code for seismic design for buildings. it is suggested that the eccentric torsional angel should not be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricity in one direction due to irregular mass layout, the relative eccentricity can be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricities in two directions due to irregular mass layout, the ratio of relative eccentricities in two directions and the angel of them can be take as the parameters of torsion effect of structures considering seismic action in two directions simultaneously ; it is indicated by the analysis results that the torsion effect has no dependency relation with re - entrant corner ratio adopted in code for seismic design for buildings as

    所取得的主要結論有：結構的扭轉效應與《抗震規范》所採用的扭轉不規則指標即偏心扭轉角之間的相關性較差，偏心扭轉角不宜作為判斷結構是否計及扭轉效應及需考慮雙向水平地震作用的界定指標；對于樓層間均勻偏心的多層單向偏心結構，建議採用相對偏心距作為需考慮雙向水平地震作用的界定指標，並給出針對不同平面尺寸的界限相對偏心距；對于樓層間均勻偏心的多層雙向偏心結構，建議採用兩個主軸方向的相對偏心距及其夾角作為界定指標，結合單向偏心結構的界定方案進行需考慮雙向水平地震作用的結構范圍界定；凸凹不規則結構的扭轉效應與凸凹比例無正相關關系， 《抗震規范》要求所有平面布置不對稱的凸凹不規則結構計及扭轉效應的規定欠妥當，建議凸凹不規則界限值從30改為15 ，只要求分析採用空間模型比較合適； 《抗震規范》關于有效樓板寬度較小的結構需計及扭轉效應的規定很有必要，樓板局部不連續的結構需採用符合樓板實際剛度的計算模型予以分析，可使用相對偏心距（及其夾角）參照單向（和雙向）偏心結構的界定方案，界定樓板局部不連續結構是否需要計入雙向水平地震作用下的扭轉效應。
分享友人
分享到 Line

分享到臉書