無限厚層 的英文怎麼說

中文拼音 [xiànhòucéng]
無限厚層 英文
infinitely thick layer
  • : 無Ⅰ動詞(沒有) not have; there is not; be without Ⅱ名詞1 (沒有) nothing; nil 2 (姓氏) a surn...
  • : Ⅰ名詞(指定的范圍; 限度) limit; bounds Ⅱ動詞(指定范圍, 不許超過) set a limit; limit; restrict
  • : i 量詞1 (用於重疊、積累的東西 如樓層、階層、地層) storey; tier; stratum 2 (用於可以分項分步的...
  • 無限 : infinite; limitless; boundless; immeasurable; unlimited
  1. The subregion with pure dielectric layers is analyzed by mol and the fast fourier transform ( fft ) is introduced to reduce the computing time, while the subregion with conductors is analyzed by fdfd to take advantage fully the superiorities of these two methods

    通過在純介質區域使用直線法,導體所在區域使用有差分法分別進行求解,充分發揮兩種方法各自的優越性。由於在純介質區域中使用了直線法求解,因此該演算法具有計算時間與介質關的突出優越性。
  2. Because of the limitation of thin silicon film epitaxial technology, it is difficult to grow thin silicon film epitaxial of thickness less than 2 m for a long time, which makes the series resistance large

    但長期以來,由於薄硅外延生長技術的制,法生長出優質的度小於2 m的薄硅外延,使硅肖特基二極體的串聯電阻法降的更低,制了其截止頻率的提高。
  3. Moisture, the voids and the density of the pavement are expected for many operators in the road department. in order to promote the application of gpr to detect pavement quality as quickly as possible, in this paper some research works were zone. the mainly research results includes the following aspects : ( 1 ) since the dielectric constants of pavement medium have important influence on radar detection results, dielectric properties of pavement layers materials are analyzed for the design of practical gpr system and field application

    目前探地雷達在公路上的應用還主要局於路面結構度的檢測,對路基路面物理力學指標的損檢測被廣大公路工作者寄予望,這一技術的應用還有很多的工作要做,為了使其早日應用於實際,實現探地雷達對路面含水量、空隙率和壓實度的快速損檢測,本文具體做了以下的一些工作: ( 1 )鑒于介電常數對探地雷達檢測的重要影響,對路面結構材料的介電特性進行深入分析,為路用探地雷達的實際應用測量提供理論依據。
  4. The content of the dissertation is as follow : ( 1 ) an eddy current testing model of multi - layered metal structure was presented in the light of the work of luquire and others

    論文的主要內容和研究成果如下: 1 )本文參照luquire 、 uzal和雷銀照等人的多度渦流檢測的數學模型,推導了一個半大空間內的三度電渦流檢測數學模型。
  5. 2. the complex stiffness corresponding to three bearing conditions of semi - infinite elastic subgrade, finite elastic soil layer and end bearing at the pile bottom are theoretically investigated, and analytical expression of the complex stiffness corresponding to finite elastic soil layer bearing condition is obtained. the special influence of bearing conditions on dynamic response at pile head is then discussed

    2 、對剛性支承、有度土支承和半空間支承三種樁底部支承情況下樁底支承復剛度和樁周土底分佈支承復剛度的解析表達及其特性進行了推導論證,通過假定樁底土為與樁等截面的土柱推導求得有支承條件下樁底支承復剛度的解析解,並據此分析了不同底部支承邊界對樁頂響應的影響。
  6. At first, an analytical solution to one dimension consolidation of half - infinite homogeneous structural soft clay ground is derived, then analytical solution to one dimension consolidation of finite thickness homogeneous structural soft clay ground are given. in the meantime numerical solution to one dimension consolidation of layered structural soft clay ground is derived. furthermore, the calculation method of the consolidation degree of sand drains ground is given under the condition of instant loading, where soil structure characteristic is taken into the formula account

    建立了結構性軟土地基固結沉降的基本理論,獲得了半結構性軟土地基一維固結計算解析解,有度結構性軟土地基一維固結計算解析解,成結構性軟土地基的一維固結數值解以及考慮土結構性影響的砂井地基固結度計算方法。
  7. Compared with green light - emitting device, blue oled has many problems such as brightness, efficiency, stability, and color saturation, in this study we investgaited the blue oleds systemically : 1 ) double heterosturcture oled was charaterized. due to the introducing of electron transport layer alq3 and hole - blocking layer balq3, the energy matching was more reasonable and the carrier injecting was more effective in the double - layer device. the maximum efficiency and luminance of this device attained to 1. 90 lm / w and 10, 000 cd / m2, respectively

    其次,由於一直以來藍光oled器件的研究處于相對落後的狀態,其發光亮度、效率、穩定性和色純度都法綠光器件相比,所以本論文在以下幾個方面對藍光器件的性能進行了系統的研究: 1 )研究了雙異質型藍光oled器件,由於本研究引入了空穴阻擋,使得載流子的復合和激子的擴散被定在發光內,器件的發光效率達到了1 . 90lm / w ,最大亮度達到了10000cd / m2 ,比傳統結構器件的效率和亮度提高了約一個數量級; 2 )制備了結構為ito / npb / balq3 / alq3 / mg : ag的oled器件,研究發現,當改變各有機度時,器件的電致發光光譜發生了從綠光到藍光的移動。
  8. In chapter three, the momentum integral equations and their solutions of two - phase fluids in boundary layer are given and the no - disturbance solutions on the surface of vane are required. leading into the disturbance factor of no - dimension and thickness coefficient ks in boundary layer, the numerical method of finite approximation is used to calculate the boundary layer

    第三章給出了固液兩相流泵的邊界動量積分方程及其解的一般表達式,並得到葉片表面的擾動解;引入了量綱擾動因子及邊界度系數k _ ,給出了用於邊界計算的有次逼近的計算方法。
  9. Firstly, based on n - s equation, the momentum differential equation ( contained centrifugal force ) is derived by simplification in boundary layer and then integrates the differential equation over the thickness of the boundary layer, the momentum integral equation is deduced. the dimensionless centrifugal factor is introduced, then the solution of the momentum integral equation is obtained. the dimensionless group is introduced to determined separation of boundary layer

    本文首先根據粘性流體力學的一般方程,通過在邊界內進行量級比較,在所定的范圍內得到了含有離心力的邊界動量微分方程並給出其滿足的邊界條件,然後對該微分方程在邊界內積分得到離心泵葉輪邊界動量積分方程,在求解過程中引入了量綱離心因子,並作了相應合理的假設,得出積分方程解的一般表達式,並引入以邊界動量損失度為主要特徵量的量綱參數對邊界分離進行評價。
  10. In this paper, finite element software ansys is used to simulate the thermal conductivity and pressureless infiltration technique is used to produce aluminum infiltrated silicon carbide composite with high volume fraction of sic. the influence of interfacial thickness and temperature on thermal conductivity and cte have been investigated and analysed

    本文採用有元軟體ansys對鋁滲碳化硅復合材料的有效熱導率進行了數值模擬,用壓浸滲法制備了高體積分數的鋁滲碳化硅復合材料,研究了界面度和溫度等對鋁滲碳化硅復合材料的熱導率和熱膨脹系數的影響,並進行了分析。
分享友人