無電抗負載 的英文怎麼說

中文拼音 [wúdiànkàngfùzǎi]
無電抗負載 英文
non reactive load
  • 無 : 無Ⅰ動詞（沒有） not have; there is not; be without Ⅱ名詞1 （沒有） nothing; nil 2 （姓氏） a surn...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 抗 : Ⅰ動詞1 （抵抗; 抵擋） resist; combat; fight 2 （拒絕; 抗拒） refuse; defy 3 （對等） contend with...
  • 負 : Ⅰ名詞1 （負擔） burden; load 2 （虧損） loss 3 （失敗） defeat Ⅱ動詞1 [書面語] （背） carry on th...
  • 載 : 載Ⅰ名詞（年） year : 一年半載 six to twelve months; six months to a year; 三年五載 three to five ...
  • 負載 : [電學] load
  1. The exportation resistance of a device work device with what link after loading the resistance s the certain connections for should satisfying, in order to prevent mount to load the appearance produce the obvious influence. with each other connect to say to electronics equipments, for example after signal connect the enlarger, ex - class to connect class, only behind first - degree importation resistance before larger than first - degree exportation resistance 5 - 10 times are above, can think the resistance to match good ; connect the box come saying, electronics tube the machine should choose to use with for the enlarger its output to carry the mark to call the resistance the box for, but transistor enlarger then have noing this restrict, can take officing why resistance of equal or approximate box

    一件器材的輸出阻抗和所連接的負載阻抗之間所應滿足的某種關系，以免接上負載后對器材本身的工作狀態產生明顯的影響。對電子設備互連來說，例如信號源連放大器，前級連后級，只要后一級的輸入阻抗大於前一級的輸出阻抗5 - 10倍以上，就可認為阻抗匹配良好對于放大器連接音箱來說，電子管機應選用與其輸出端標稱阻抗相等或接近的音箱，而晶體管放大器則無此限制，可以接任何阻抗的音箱。
  2. The power angle characteristics are acquired and compared with the unsaturated curves. it is concluded that the stability limit of the power angle is less than 90 degree. reactive power regulating curves are calculated and compared with those curves when saturation effect is not considered, the result is that u type curves are deviated to the right

    通過對同步發電機各種運行曲線的計算，在已有文獻的基礎上更進一步分析了鐵磁材料飽和以及磁場畸變對同步發電機運行特性和參數的影響；求出了空載特性曲線和零功率負載特性曲線，在不同的電樞電流下計算得到的波梯電抗不同；求出了功角特性曲線，與不計飽和時的功角特性曲線相比較，功角穩定極限小於90 ；求出無功調節曲線，與不計飽和時相比較， u型曲線向右偏移。
  3. After the analysis of power produce character of the typical three - phases unbalance load, the corresponding circuit is adopted. this main circuit is composed of the power filter series and tcr control circuit. secondly the theory of band - pass filter is analyzed in detail, and then a method of implementing butterworth band - pass filter is put forward

    簡要分析了無功補償的基本原理和工作特點，通過對典型的三相不平衡負載工作特點的分析，主電路採用電力濾波器與晶閘管控制電抗器相接合的結構；對用於無功檢測的帶通濾波器進行了分析，設計了用於負載電壓、電流信號濾波的帶通濾波器，並採用運算放大器加以實現。
  4. This paper put forward the realization method of a kind of multi - function general use inverter system which added other functions based on the independent sine wave inverter, it not only can be used as independent inverter power supply but can be used as an in - support mode ups which realize synchronous with the phase of power grid voltage and realize to switch with power grid mutually, it also can realize three phase ac output by the combination of three synchronous inverters, experiment proved it in this way has a stronger ability of resisting three phase unbalance load

    本文提出了一種基於獨立正弦波逆變器的功能之上復合其他功能而成的多功能通用逆變電源系統的實現方法，此系統不僅可以作為獨立逆變電源使用，還可以與電網電壓的相位同步，作為后備式正弦波ups使用，在逆變電源和電網的相互切換時能做到對負載無影響，同時還可以由三臺逆變器進行組合自同步實現三相對稱交流輸出，實驗證明這種方式具有較強的抗三相不平衡負載的能力。
分享友人
分享到 Line

分享到臉書