煅料 的英文怎麼說

中文拼音 [liào]
煅料 英文
calcine
  • 煅 : 動詞1. （中藥製法: 放在火里燒） calcine2. （鍛造） forge
  • 料 : 名詞1 （材料; 原料） material; stuff 2 （喂牲口用的穀物） feed; fodder 3 （料器） glassware 4 （...
  1. For this reason the distributor for the bed directly above the calcination stage should be made of heat-resistive material.

    基此理由，直接位於煅燒段之上的床層分佈板必須用耐熱材料製成。
  2. Clinker burning of special cement with precalciner kiln

    用預分解窯煅燒特種水泥熟料
  3. Study on the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process using kaolinite as raw material showed that impurities introduced by kaolinite mainly increased the liquid amount at high temperature, which can assist sintering of specimen. the experiment results indicated that the samples with lower gahnite content had better sinterability than others. however, if the gahnite content was relative high, the promoting effect on sinterability caused by kaolinite was not significant

    採用天然原料高嶺土二步煅燒合成剛玉?莫來石?鋅鋁尖晶石復相材料研究發現：天然原料中帶入的雜質主要是增加液相量，促進高溫下試樣的燒結；當尖晶石含量較低時，試樣在1300保溫2h時，在1600燒后試樣燒結性能相比之下較好；而當鋅鋁尖晶石含量較高時，天然料對試樣的促燒作用不是非常明顯。
  4. Based on orthogonal designed experiment, the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process showed that the light fired temperature and holding time mostly influenced the apparent porosity of the multiphase materials. further study on the light firing time indicated that at the light firing temperature of 1300 and died fire temperature of 1600 for 3h, the optimal light fired time was about 1h

    二次煅燒及正交實驗合成復相材料研究表明：輕燒溫度和輕燒時間對復相材料的顯氣孔率影響顯著；通過輕燒保溫時間的進一步研究表明：含剛玉、莫來石、鋅鋁尖晶石的復相材料，在輕燒溫度為1300 、終燒條件為1600下保溫3h時，最佳的保溫時間為1小時左右。
  5. The effects of calcinations temperature and holding time on the perovskite phase of synthesized pmn - pt have been studied

    並研究了煅燒溫度及保溫時間對合成材料單相性的影響。
  6. Study of influences of performances of material to induration and circle forming in coal - fired rotary kiln for lime

    原料性能對石灰回轉窯煅燒及結圈影響的研究
  7. Technical features : utilizes advanced second sintering technology, and has world - advanced fully computerized multi - pipe spreading technology, compounding microlite glass to surface of vitrified tile, and organically blend through second high temperature firing, so the product achieves a higher level in strength, luster and surface crystal feeling

    技術特點：採用領先的二次燒結技術和具有國際先進水平的全電腦多管道布料技術，將微晶玻璃復合在陶瓷玻化磚的表面，經二次高溫煅燒有機融合於一體，令產品強度、光澤度與表面晶瑩質感達到另一個高度。
  8. Paper faced gypsum board is mainly made of construction plaster ( calcined with natural gypsum of chemical by product ) and protective paper, mixing with appropriate fiber, modified starch, coagulant agent, vesicant and water

    紙面石膏板是以建築石膏（利用天然石膏或化學副產品石膏煅燒制得）和護面紙為主要原料，摻加適量纖維、改性澱粉、促凝劑、發泡劑和水，經混合、成型、凝固、切斷、烘乾、切邊等工藝製成的輕質建築板材。
  9. Industrial waste containing wolfram acted as mineralizer in the burning of cement clinker

    用含鎢工業廢棄物作礦化劑煅燒水泥熟料
  10. Using burnability index to control the burning temperature of rotary kiln

    用生料易燒性指數控制回轉窯煅燒溫度
  11. Influence of mno2 on the burnability and mineral formation of alite - sulphoaluminate cement clinker

    硫鋁酸鹽水泥熟料煅燒及礦物形成的影響
  12. Paper faced gypsum board is mainly made of construction plaster calcined with natural gypsum or chemical by - product and protective paper, mixing with fiber, modified starch, coagulant agent, vesicant and water. which are mixed, formed, coagulated, cut, dryed and sliced into light construction material. they have advantages of light weight, fire resistance, soundproof, damp proof, heat insulation, easy to operate sawn, nailed or milled an disassemble. it s widely applied in industrial and civil constructions, especially widely used as interior wall, less loading wall, ceiling etc in high buildings

    紙面石膏是以建築石膏利用天然石膏或化學副產品石膏煅燒制得和護面紙為主要原料，摻加適量纖維改性澱粉促凝劑發泡劑和水，經混合成型凝固切斷烘乾切邊等工序製成的輕質建築板材。
  13. In order to obtain the strontium titanate nanocrystalline powers materials with small grain, high purity and homo - geneous grain size distribution, the effect of water, waiter - free acetic acid, gel temperature, heat treat temperature and so on were researched

    為了制備出晶粒小、材料純度高以及粒徑分佈均勻的納米鈦酸鍶粉體材料，研究了用水量、冰醋酸加入量、凝膠溫度和煅燒溫度等工藝參數對制備納米鈦酸鍶粉體材料的影響。
  14. The graphitized cathode block samples have been trial - produced using high quality eca ( electrically calcined anthracite ) rationed petroleum coke and pitch coke and quantitative pitch used as raw materials by the conventional carbon technics concluding moulding, baking, high pressure impregmating, after - baking and graphitization

    摘要選取優質電煅無煙煤，分別配以一定比例的石油焦和瀝青焦作為骨料，與煤瀝青混合后按照模壓成型、焙燒、高壓浸漬、二次焙燒和石墨化等常規炭素製品生產工藝流程制備石墨化陰極材料試樣。
  15. It has to be crushed after firing and the aggregate therefore has sharp corners.

    煅燒后需要進行破碎，因此骨料具有尖銳的稜角。
  16. Railway rolling stock materials - specification for forged and rolled tyres

    鐵路車輛材料.第4部分:煅造和軋制輪箍規范
  17. Experience of burning white cement clinker in precalciner kiln

    預分解窯煅燒白水泥熟料的體會
  18. The nanoparticle titanium dioxide was prepared with tnb as raw material by the sol - gel process, the effects of the alcohol salt concentration the kind of solvent the water volume hydro1yze temperature. the dried ways of the wet gel and the calcined temperature of the dry gel on the specific surface area. particle size

    本文以鈦酸丁酯為前驅體，利用溶膠?凝膠法制備了納米級的tio _ 2粉體材料，通過正交實驗研究了醇鹽的濃度、溶劑的種類、水含量、水解溫度、乾燥條件和煅燒溫度等工藝條件對納米粒子的比表面積、粒徑大小及分佈、晶相組成等性能的影響。
  19. The homogenous precursor of magnesium niobate titanate was prepared under high temperature by adjusting the excess content of mgo after milling

    通過研磨，高溫煅燒等工藝，調節鎂的含量，制得了均勻的先驅體粉料。
  20. The magnesia - alumina spinel is synthesized by using high - quality bauxite and active magnesia as starting materials and calcined at high temperatures. the spinel has high density and low water absorption rate

    本品採用優質鋁礬土與活性氧化鎂合成，經高溫煅燒，體積密度大，吸水率低，是冶金建材行業理想的原料。
分享友人
分享到 Line

分享到臉書