煅燒溫度 的英文怎麼說

中文拼音 [shāowēn]
煅燒溫度 英文
burning temperature
  • : 動詞1. (中藥製法: 放在火里燒) calcine2. (鍛造) forge
  • : Ⅰ動詞1 (使東西著火) burn 2 (加熱或接觸某些化學藥品、放射性物質等使物體起變化) cook; bake; hea...
  • : Ⅰ形容詞(不冷不熱) warm; lukewarm; hot; gentle; mild Ⅱ名詞1 (溫度) temperature 2 (瘟) acute ...
  • : 度動詞[書面語] (推測; 估計) surmise; estimate
  • 溫度 : [物理學] temperature
  1. The effects of calcinations temperature and holding time on the perovskite phase of synthesized pmn - pt have been studied

    並研究了煅燒溫度及保時間對合成材料單相性的影響。
  2. Yig and ce : yig precursors were prepared via coprecipitation. by means of improving homogeneity and decreasing synthesis temperature, harmful yfeo3 phase was restrained, the oxidation of ce3 + was under control, and pure phase yig and ce : yig ( x = 0. 2 ) were obtained

    採用共沉澱法合成yig及ce : yig前驅體,通過提高組分均勻性、降低煅燒溫度等手段,有效地抑制了yfeo _ 3雜相的生成和ce ~ ( 3 + )離子的氧化,合成了單相yig和ce : yig 。
  3. Using burnability index to control the burning temperature of rotary kiln

    用生料易性指數控制回轉窯煅燒溫度
  4. In order to obtain the strontium titanate nanocrystalline powers materials with small grain, high purity and homo - geneous grain size distribution, the effect of water, waiter - free acetic acid, gel temperature, heat treat temperature and so on were researched

    為了制備出晶粒小、材料純高以及粒徑分佈均勻的納米鈦酸鍶粉體材料,研究了用水量、冰醋酸加入量、凝膠煅燒溫度等工藝參數對制備納米鈦酸鍶粉體材料的影響。
  5. Influences of temperature on the structure of kaolinite and its electric insulation properties

    煅燒溫度對高嶺石結構及電絕緣性能的影響
  6. The nanoparticle titanium dioxide was prepared with tnb as raw material by the sol - gel process, the effects of the alcohol salt concentration the kind of solvent the water volume hydro1yze temperature. the dried ways of the wet gel and the calcined temperature of the dry gel on the specific surface area. particle size

    本文以鈦酸丁酯為前驅體,利用溶膠?凝膠法制備了納米級的tio _ 2粉體材料,通過正交實驗研究了醇鹽的濃、溶劑的種類、水含量、水解、乾燥條件和煅燒溫度等工藝條件對納米粒子的比表面積、粒徑大小及分佈、晶相組成等性能的影響。
  7. The influences of the calcination temperature and time, the concentration ratio of deionized distilled water to c - v _ 2o _ 5 and the agitation time on the synthesis of a - v _ 2o _ 5 were studied by orthogonal array design and the interactions between the parameters were considered. so the optimum experimental factors were obtained. lithium rechargeable battery positive electrodes based on these optimum conditions could lead to experimental cells with large discharge specific capacity and good cycling performance

    用正交實驗研究了煅燒溫度時間、去離子水與晶態v _ 2o _ 5 ( c - v _ 2o _ 5 )的濃比和陳化時間對合成a - v _ 2o _ 5的影響,討論了這些參數間的交互作用,並獲得了最優試驗參數,以該最優試驗參數所制備的a - v _ 2o _ 5為可充鋰電池正極的實驗電池,具有較大的放電比容量和較好的循環壽命。
  8. In this paper, co3o4 nano - particles were prepared by homogeneous precipitation method, technical conditions and kinetics were studied, the main contents and results are as follows : co ( no3 ) 2 6h2o was used as raw materials, and co ( nh2 ) 2 was used as precipitator, co3o4 nano - particles were prepared by homogeneous precipitation. the influences of concentration, molar ratio of reactants, reaction temperature and time, dryness temperature and time, and calcining temperature and time on particle size were investigated

    本文採用均勻沉澱法制備納米co _ 3o _ 4粉體材料,研究了制備工藝條件、沉澱反應和前驅體熱分解過程的動力學,主要研究內容及結果如下:以硝酸鈷為原料,尿素為沉澱劑,採用均勻沉澱法制備納米co _ 3o _ 4 ,考察了硝酸鈷濃、反應物摩爾比、反應和時間、乾燥和時間、煅燒溫度和時間等條件對產物粒徑的影響。
  9. The na2fepo4f cathode materials for sodium ion battery were prepared by solid state reaction and the influence of synthesizing temperature and morphology on the electrochemical performance of na2fepo4f powders in sodium ion batteries were systematically studied. the results indicate that na2fepo4f synthesized at 750 exhibited good electrochemical performance, whose first specific discharge capacity is 60mah / g, after 20 times cycling, the average specific discharge capacity is 51. 1mah / g

    首先採用固相法制備了氟磷酸亞鐵鈉粉體,研究了不同煅燒溫度對合成材料顯微結構和電化學性能的影響,結果表明750下合成材料體現出較好的電化學性能,首次放電容量為60mah / g ,循環20次后,容量下降為51 . 1mah / g 。
  10. Abstract : in this paper, the preparation of the catalysts for the oxidation of fluorene to fluoreone is studied. the influences of the dipping time, calcining temperature, calcining time and the air quantity during the calcination are discussed

    文摘:研究了用工業芴氣相氧化制取芴酮的催化劑製作條件,考察了浸漬時間、煅燒溫度時間和空氣量對催化劑製作的影響
  11. Particle size distributing and the composing of crystal phase were discussed by the orthogonalizing design. the experiments showed that the most suitable process conditions should controlled as follows : process temperature was about 30c ; the ratio of tnb " water and solvent was l : 4 : l 0 : the calcined temperature was about 600 " c. such transition metal ions as fe3 +

    實驗表明,合適的反應條件是:以醋酸為負催化劑,水解應控制在30左右,鈦酸丁酯與水量、溶劑量的配比應為1 : 4 : 10 。另外得到比較單一的銳鈦型tio _ 2煅燒溫度應控制在600左右。
  12. Compared with 3 %, the temperature of polymorphic transition between anatase and rutile of 8 % which is the molar quantities of mixed rare earth is a little lower. the calcination temperature is a main reason which influences the structure of phase

    摻入鏑的含量8時,銳鈦礦相向金紅石相的轉變與3相比有所降低,所以煅燒溫度是影響產物結構的主要原因。
  13. Polycrystalline structure of waste slag in aluminum factory at different calcining temperature

    鋁廠污泥在不同煅燒溫度的晶相結構研究
  14. A summary of mgo ' s burning temperature and the relationship with miniature swelling performance

    氧化鎂煅燒溫度與其微膨脹性能關系的綜評
  15. If the sintering temperature was lower than the reaction temperature, phase separation will develop

    煅燒溫度低於反應物的固相反應時,只能導致前驅物分相。
  16. Based on the dta / tg and tem patterns, we chosed 450 c as the lowest temperature and 2 hours as the shortest time for calcining

    根據dta tg和tem分析結果,我們選定凝膠的最低煅燒溫度為450 ,最低時間為2小時。
  17. Considering energy conservation and effects of calcined kaolin on the strength of cement, it was optimum method to produce calcined kaolin by calcining it at 980 c for 0. 5h and then cooling it suddenly

    結合高嶺土對水泥強的影響,考慮到節約能源,以採用980恆0 . 5h然後快速冷卻的方法作為最佳煅燒溫度與時間。
  18. The results show that the shrinkage of cement paste can be compensated by the new mgo - based expansive materials well, only if the burning temperature and burning time of expansive material are controlled and the dosage of expansive material in cement is suitable according to the hydration temperature and with fly ash or not

    結果表明,根據一定條件下(如養護、摻加粉煤灰等)水泥漿體的收縮特性來調整膨脹材料的煅燒溫度時間,控制合理的摻加量,新型鎂質膨脹材料可以有效地補償水泥漿體的收縮。
  19. The power prepared was examined by many kinds of analytic measures, like as xrd, xps, tem, sem and x rays fluorescence, etc. the sol - gel method was used to synthesize dy - doped titanium oxide, the impact of elements such as solvent ' s quantities, temperature, ph value, calcination temperature on the course of sol - gel is studied, and the quantities of mixed rare earth is also studied on the influence about the structure of phase, thus established the best technology parameter

    本文對摻雜稀土元素鏑的氧化鈦和氧化鋯超微陶瓷粉末的制備的工藝過程進行了研究,並用xps 、 xrd 、 tem 、 sem和x射線熒光等多種測試手段對制得的粉末進行了分析。用溶膠-凝膠法合成氧化鏑/氧化鈦的陶瓷粉末,研究了溶劑量,, ph值,煅燒溫度等對溶膠-凝膠過程的影響,以及摻雜稀土量對相結構的影響,從而確立了最佳的工藝參數。
  20. This thesis focuses on the study of the layered lithium nickel - based oxides as catho de materials lithium - ion batteries, the main aspects follow : 1 study on the synthesis and properties of linixco1 - xo2 by the sol - gel method compared with solid - state method, sol - gel method enjoys the advantage of lower calcining temperature and small uniform particle size of products. after the xrd measurement, it was shown that the single - phase layered compound can be prepared in sintering temperature of 750 for 6 ~ 8 hours. the sintering temperature, the properties and the amounts of doping materials can all affect the product ' s phase, and its structure ( lattice parameter, crystal phase distance )

    本論文的研究工作主要集中在作為鋰離子電池正極材料的層狀鋰鎳基氧化物上,包括以下幾個方面: 1溶膠凝膠法( sol - gel )合成lini _ xco _ ( 1 - x ) o _ 2的研究與固相合成法相比,溶膠凝膠法合成lini _ xco _ ( 1 - x ) o _ 2煅燒溫度低,產物顆粒均勻一致,經過xrd的測試過后,結果表明750下結6 8小時,即可得到單相產物;,摻雜劑的種類及摻雜劑量均對產物物相的形成產生影響,並對產物的結構產生影響。
分享友人