煅燒過度的 的英文怎麼說

中文拼音 [shāoguòdùde]
煅燒過度的 英文
hard-burned
  • 煅 : 動詞1. （中藥製法: 放在火里燒） calcine2. （鍛造） forge
  • 燒 : Ⅰ動詞1 （使東西著火） burn 2 （加熱或接觸某些化學藥品、放射性物質等使物體起變化） cook; bake; hea...
  • 過 : 過Ⅰ動詞[口語] （超越） go beyond the limit; undue; excessiveⅡ名詞（姓氏） a surname
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 的 : 4次方是 The fourth power of 2 is direction
  • 過度 : excessive; over; undue; ana-; hyper-
  1. Based on orthogonal designed experiment, the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process showed that the light fired temperature and holding time mostly influenced the apparent porosity of the multiphase materials. further study on the light firing time indicated that at the light firing temperature of 1300 and died fire temperature of 1600 for 3h, the optimal light fired time was about 1h

    二次煅燒及正交實驗合成復相材料研究表明：輕燒溫度和輕燒時間對復相材料的顯氣孔率影響顯著；通過輕燒保溫時間的進一步研究表明：含剛玉、莫來石、鋅鋁尖晶石的復相材料，在輕燒溫度為1300 、終燒條件為1600下保溫3h時，最佳的保溫時間為1小時左右。
  2. Yig and ce : yig precursors were prepared via coprecipitation. by means of improving homogeneity and decreasing synthesis temperature, harmful yfeo3 phase was restrained, the oxidation of ce3 + was under control, and pure phase yig and ce : yig ( x = 0. 2 ) were obtained

    採用共沉澱法合成yig及ce ： yig前驅體，通過提高組分均勻性、降低煅燒溫度等手段，有效地抑制了yfeo _ 3雜相的生成和ce ~ （ 3 + ）離子的氧化，合成了單相yig和ce ： yig 。
  3. The nanoparticle titanium dioxide was prepared with tnb as raw material by the sol - gel process, the effects of the alcohol salt concentration the kind of solvent the water volume hydro1yze temperature. the dried ways of the wet gel and the calcined temperature of the dry gel on the specific surface area. particle size

    本文以鈦酸丁酯為前驅體，利用溶膠?凝膠法制備了納米級的tio _ 2粉體材料，通過正交實驗研究了醇鹽的濃度、溶劑的種類、水含量、水解溫度、乾燥條件和煅燒溫度等工藝條件對納米粒子的比表面積、粒徑大小及分佈、晶相組成等性能的影響。
  4. Ceramic grain filters ard made of refined pottery clays added with certain modifiers, and processed of grinding, mixing, shaping and high temperature sintering. they do not contain any substances that harmful to people or environment. they are hard and rough in surface, porous inside the structure, and have the advantages of high mechanical strength, large specific surface area and porosity. when used in water treatment, they behave a activated surface property, a great amount of pollutant entrapment, less water head loss in the filter bed, lower consumption of back - flush water, stable in chemical and gbiologic property, and long service life, ceramic grain filters is a new and efficient filter material to increase the water yield, upgrade the water quality, and save chemicals and energy

    陶粒濾料是以精製陶土為主要原料，摻加適量改性劑，經粉碎，混練，成型和高溫煅燒而製成的，不含任何對人體和環境有害的物質.其表面堅硬，粗糙，內部疏鬆，多孔，具有機械強度高，比表面積大，孔隙率大的特性.用於水處理中，具有表面性狀好，截污能力強，過濾水頭損失小，反沖洗耗水量低，化學穩定性和生物學穩定性好，使用壽命長的特點.陶粒濾料是一種能增加水產量，提高出水質量，節省藥劑和能耗的新型高效過濾材料
  5. In this paper, co3o4 nano - particles were prepared by homogeneous precipitation method, technical conditions and kinetics were studied, the main contents and results are as follows : co ( no3 ) 2 6h2o was used as raw materials, and co ( nh2 ) 2 was used as precipitator, co3o4 nano - particles were prepared by homogeneous precipitation. the influences of concentration, molar ratio of reactants, reaction temperature and time, dryness temperature and time, and calcining temperature and time on particle size were investigated

    本文採用均勻沉澱法制備納米co _ 3o _ 4粉體材料，研究了制備工藝條件、沉澱反應和前驅體熱分解過程的動力學，主要研究內容及結果如下：以硝酸鈷為原料，尿素為沉澱劑，採用均勻沉澱法制備納米co _ 3o _ 4 ，考察了硝酸鈷濃度、反應物摩爾比、反應溫度和時間、乾燥溫度和時間、煅燒溫度和時間等條件對產物粒徑的影響。
  6. The influence of preparing conditions on aluminum titanate composing was inquired. by analyzing element content of alumina and titania source, arranging a stoichiometric dosage, and keeping the chemical homogeneity from sol to mixed ti - al oxide precursor, a high activity powder was prepared. after calcining the precursor powder at 1250 for 2h, aluminum titanate phase is formed

    本試驗通過準確測定起始物的ti 、 al含量，嚴格化學配比，採取適當措施將微尺度上的組成均勻性從溶膠一直保持到混合鋁鈦氧化物前驅體的生成，使該粉體具有高活性，將其在1250煅燒2h ，已合成出以鈦酸鋁為主晶相的產物，比文獻報道的鈦酸鋁相的最低生成溫度降低了50 。
  7. And the value drop to the lowest at ph = 0. 8. as the increase of heat treatment temperature, the pore size distribution peak of sio2 microspheres is very narrow, meanwhile the specific surface area is the smallest before 160 c. the polymer template is removed at 350 c, so the pore structure of sio2 particles has a big change which involve the increase of specific surface area and the broaden of pore size distribution peak. with the continuous raise of temperature the sio2 network will shrink little, as a result the average pore size will decrease, but the specific surface area has no obvious change

    結果發現：二氧化硅膠體顆粒均勻分佈於脲醛聚合物網路中，煅燒去除有機模板后微球表面變粗糙，而粒徑沒有明顯變化； ph值較小時，復合微球中聚合物含量較大，而ph值較大時，得到復合微球結構鬆散，因此熱處理后的二氧化硅微球孔容及平均孔徑都較大，而在ph = 0 . 8時，得到最小值；武漢理工大學碩士學位論文隨著熱處理溫度的變化，小於160時，空分佈較窄，而比表面積較小，在350時，由於有機模板的去除，微球孔結構發生突變，比表面積明顯增大，而孔徑分佈變寬，溫度繼續升高時，二氧化硅網路發生收縮，平均孔徑變小而比表面積由於有機炭化物的完全去除沒有太大變化;微球中的微孔在熱處理過程中處于平衡狀態，分佈沒有太大變化。
  8. The relation between addition content of calcined kaolin, aluminium powders and aluminum sulfate in concrete and compressive strength, slump constant, 30min slump and permeability altitude were studied, and according to the experiment results, the component percent contents of crack - resistant and water - repellent admixture in cement were determined as following : calcined kaolin 6 %, aluminum sulfate 4 % and aluminium powders 0. 005 %

    通過對煅燒高嶺土、鋁粉、硫酸鋁在混凝土中摻量對其抗壓強度、初始武漢理工大學碩士學位論文坍落度、 3omin坍落度保留值及透水高度的影響，確定了配製抗裂防水外加劑的各組成成分以其占水泥質量的百分比分別為:鍛燒高嶺土6 % ，硫酸鋁4 % ，鋁粉為0 . 005 % 。
  9. Reaction of limestone calcination and sulfuration under o _ ( 2 ) / co _ ( 2 ) atmosphere were experimented on a bench scale fluidized bed facility and analyzed by thermodynamic analysis. limestone samples were analyzed by press mercury apparatus and scanning electron microscope. mechanism for limestone calcination and sulfuration under o _ ( 2 ) / co _ ( 2 ) atmosphere was raised and discussed

    熱力學角度和小型流化床試驗臺上研究了空氣和o _ 2 / co _ 2氣氛下的石灰石煅燒分解與硫化反應特性，並對煅燒過程和硫化反應過程中的石灰石樣品結合壓汞儀和掃描電鏡進行了微觀分析，得出了o _ 2 / co _ 2氣氛下石灰石煅燒與硫化反應特浙江大學博士學位論文點，探討了02 / co :氣氛下石灰石的硫化反應機理。
  10. The power prepared was examined by many kinds of analytic measures, like as xrd, xps, tem, sem and x rays fluorescence, etc. the sol - gel method was used to synthesize dy - doped titanium oxide, the impact of elements such as solvent ' s quantities, temperature, ph value, calcination temperature on the course of sol - gel is studied, and the quantities of mixed rare earth is also studied on the influence about the structure of phase, thus established the best technology parameter

    本文對摻雜稀土元素鏑的氧化鈦和氧化鋯超微陶瓷粉末的制備的工藝過程進行了研究，並用xps 、 xrd 、 tem 、 sem和x射線熒光等多種測試手段對制得的粉末進行了分析。用溶膠-凝膠法合成氧化鏑/氧化鈦的陶瓷粉末，研究了溶劑量，溫度， ph值，煅燒溫度等對溶膠-凝膠過程的影響，以及摻雜稀土量對相結構的影響，從而確立了最佳的工藝參數。
  11. This thesis focuses on the study of the layered lithium nickel - based oxides as catho de materials lithium - ion batteries, the main aspects follow : 1 study on the synthesis and properties of linixco1 - xo2 by the sol - gel method compared with solid - state method, sol - gel method enjoys the advantage of lower calcining temperature and small uniform particle size of products. after the xrd measurement, it was shown that the single - phase layered compound can be prepared in sintering temperature of 750 for 6 ~ 8 hours. the sintering temperature, the properties and the amounts of doping materials can all affect the product ' s phase, and its structure ( lattice parameter, crystal phase distance )

    本論文的研究工作主要集中在作為鋰離子電池正極材料的層狀鋰鎳基氧化物上，包括以下幾個方面： 1溶膠凝膠法（ sol - gel ）合成lini _ xco _ （ 1 - x ） o _ 2的研究與固相合成法相比，溶膠凝膠法合成lini _ xco _ （ 1 - x ） o _ 2煅燒溫度低，產物顆粒均勻一致，經過xrd的測試過后，結果表明750下燒結6 8小時，即可得到單相產物；燒結溫度，摻雜劑的種類及摻雜劑量均對產物物相的形成產生影響，並對產物的結構產生影響。
  12. It was found that the decompose efficiency to solution associated with the number of films layer ; calcine temperature and ph value. some analyses have been performed. tio _ 2 films were also synthesized by reactive sputtering and chemical vapor deposition

    通過溶膠凝膠法制備了tio _ 2薄膜對其進行光催化反應實驗，發現膜層厚度、薄膜煅燒溫度和溶液ph值對降解效率都有直接的影響，並對結果進行分析。
  13. The configuration and microstructure of production, the effect of heating temperature and chemistry match ratio on reaction and production, the effect of calcining temperature and time on the changes of production crystal were studied by xrd, tem, dta and microscope

    本文通過xrd 、 tem 、差熱分析、金相顯微鏡等手段對所制備材料的結構、組織形貌、點火溫度和化學配比對反應現象和反應產物的影響、煅燒溫度和煅燒時間對產物晶型轉變的影響等方面進行了分析研究。
分享友人
分享到 Line

分享到臉書