煉油器 的英文怎麼說

中文拼音 [liànyóuqì]
煉油器 英文
oil refiner
  • 煉 : 動1. （用加熱等辦法使物質純凈或堅韌） refine; smelt; work 2. （燒） temper with fire 3. （使詞句精美簡潔） polish
  • 油 : Ⅰ名詞1 （脂肪; 油脂） oil; fat; grease 2 （姓氏） a surname Ⅱ動詞1 （用桐油、油漆等塗抹） apply t...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 煉油 : oil refining; extract oil by heat; rendering
  1. Plate heat exchangers for general refinery service

    一般煉油設備用平板式熱交換器
  2. Features : long head that shares about a third of the total length ; a concave forehead ; flat chin stretching to the front ; the spermaceti case containing high fat content is located in the prolapsed occipital bone. besides making candles and ointments, this fat is good ingredient for making precision instrument lubricants

    頭部特別長，約占身體長度的三分之一，額部下方凹入，平扁的上頷由此向前伸出，頭頂之外枕骨下垂構成鯨油器，內藏大量油脂，這種油脂除可製成臘燭和油膏之外，更可提煉成維護精密儀器的潤滑劑。
  3. Application results show the proposed method can deal with mges effectively and provide useful suggestion on instruments checking. thus the number of instruments that must be checked is minimized, the maintenance effort and expense are reduced. 4

    敘述了顯著誤差選擇刪除演算法在煉油工業的實際應用情況，說明了該演算法對帶有顯著誤差變量的處理的有效性，並為檢修工作提供了合理建議，使得必須檢修的傳感器數目最少，減小了檢修的工作量和檢修費用。
  4. The equipment made by us of titanium, stainless steel, aluminum or plastics, mainly include column condenser ( heat exchanger ) ; coil hear exchanger ; membrane evaporator ; constant boil tower ; reactor ; pressure filter, storage tank ; blower, centrifuge and ta series corrosion - resist titanium pump, as well as variety of metal constructional member. they are widely applied in the industries of petrochmical engineering, smelt, pharmacy, chlorinate alkali, salt preparation, as well as electric chemical plant

    我廠生產鈦材，不銹鋼等各種材質的化工設備，主要有風機，離心機，鈦泵，鈦閥，列管式冷凝器（換熱器） ；盤管式換熱器；薄膜蒸發器；塔器；反應器；貯存容器；面向石油化工，冶煉，制藥，氯堿，制鹽食品，造紙，環保等化學工業領域及電化行業。
  5. Abstract : heat exchanger network for one oil refinery has been improved by process energy integration technology. energy savings of new scheme is 57 % against original design and number of units decrease by 2

    文摘:用過程能量組合方法對某煉油廠的換熱網路進行改造，新方案比原系統節能57 % ，並減少了兩臺換熱器
  6. Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  7. The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %

    分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上
  8. Using fcc flow - reaction mathematical model and boundary condition developed in paper ( i ) and the operational constants in commercial fcc riser, the hydrodynamics of catalysts and the distribution of concentration of catalytic cracking products, as well as the temperature of two - phase along the riser are simulated and predicted

    運用已經建立的催化裂化反應的數學模型和模型邊界條件及求解方法，結合煉油廠工業提升管的實際操作參數，模擬預測了催化裂化提升管反應器內催化劑顆粒的流場特徵和原料油反應產物的濃度及氣粒兩相平均溫度的沿程分佈特徵。
  9. Abstract : the in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    文摘:針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  10. The in servie tubular heaters built early in refineries and chemical plans have low thermal load and low heat efficiency, therefore measures for technical reform are offered, including ( 1 ) enlarging the surface area of convection tubes to increase the thermal load of rhe convection section ; ( 2 ) increasign the heat interchanging area of radiant tubes ; ( 3 ) changing the height of the chimney ; ( 4 ) using new burner with forced air supply to increase calorific capacityu ; ( 5 ) adding air preheater between the convection section and chimney to enhence the temperature of the air entering the furnace ; ( 6 ) adopting high temperature radiant coating to improve the effect of radiant heat interchanging

    針對早期建造的煉油廠和化工廠在役管式加熱爐熱負荷和熱效率低的狀況，提出了若干技術改造措施包括，增大對流管表面積以增大對流段的熱負荷；增加輻射管的換熱面積；修正煙囪高度；換用新型燃燒器，變自然通風為強制供風，以增大燃燒器的發熱量，減小過剩空氣系數，節省燃料2 % 3 % ；在對流段和煙囪之間增設空氣預熱器以提高空氣入爐溫度；採用高溫輻射塗料增強輻射換熱效果，從而增加熱源對爐壁的輻射傳熱量和爐管的傳熱量等。
  11. A specimen of pshe has been worked in reforming plant of lanzhou petroleum processing & amp; chemical complex for 3 years, and which has been proved to be excellent

    板殼式換熱器樣機在蘭州煉油化工總廠重整裝置上使用3年，效果良好。
  12. Petroleum and natural gas industries - fired heaters for general refinery service

    石油和天然氣工業.一般熔煉廠用火加熱器
  13. The use of thermochromic materials in lecture demonstrations has been discussed, and thermochromic paper is available commercially. the enthalpy of the systym will also change, and the more of a h, the evidenter of the change of the colour

    熱變色材料不但在工業機械如煉油裝置中做示溫材料而且在家用取暖器、空調機等中作示溫標志，也用於防偽標志等方面。
  14. And their improved catalytic activity can be effectively used at lower temperatures and higher production rates. as a result, significantly higher productivity and longer catalyst lifetime have been successfully demonstrated in many installations. we adopt comprehensive stratagem and competitive technology to develop our company

    D006mtbe催化樹脂適用於上述煉油型和化工型的各類反應器，在床層反應溫度30 - 60異丁烯含量15 - 50醇烯比0 . 95 - 1 . 05和空速2 - 5 h的工藝條件下，均有著優良的催化性能和較長的使用壽命。
  15. Abstract : the objective, characteristic and application of the nonlinear control strategy are introduced. how to apply and implement the function of the controller, how to start and stop the control strategy and trouble shooting is discussed. result of commissioning show that the application of nonlinear level control strategy in rfcc of qianguo oil refinery was successful

    文摘:簡要介紹了非線性液位控制策略的目的、特性、應用，並著重介紹非線性液位控制系統實施過程和控制器功能，控制器的投運和控制器的故障處理，由投用效果看出非線性液位控制系統在前郭煉油廠重油催化裂化裝置得到了很成功的應用。
  16. Jiangyin petroleum machinery plant is engaged in the development, design and manufacture of oil refining, chemical and power equipment as well as, class pressure vessel products

    江陰市石油機械廠專業從事煉油、化工、電力等設備和一、二類壓力容器產品的開發設計製造。
分享友人
分享到 Line

分享到臉書