煙氣分析 的英文怎麼說

中文拼音 [yānqìfēnxī]
煙氣分析 英文
flue gases analysis
  • 煙 : Ⅰ名詞1 （物質燃燒時產生的氣體） smoke 2 （像煙的東西） mist; vapour 3 （煙草） tobacco 4 （紙煙、...
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 分 : 分Ⅰ名詞1. （成分） component 2. （職責和權利的限度） what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] （料想） judge
  • 析 : Ⅰ動詞1. （分開; 散開） divide; separate 2. （分析） analyse; dissect; resolve Ⅱ名詞（姓氏） a surname
  1. Analysis on reliability of cooling water system in asphalt gas decontaminating for carbon calciner

    焙燒爐瀝青煙氣凈化系統中噴淋冷卻水系統可靠性分析
  2. In the third, this paper makes a survey on components of the exhausted flue gas and waste heat resource, and discusses the possibility and methods of steam generation and air preheating with the waste heat. and then, the analysis on the advantages and disadvantages of heat recovery plants with conventional steel - water heat pipes and inorganic heat - transfer heat pipes is carried out. the paper also gives a valuation about the plan and features of the design of heat recovery

    對余熱源排煙的成分和余熱資源量進行標定，討論余熱回收產生蒸汽或加熱燃燒用空氣的可行性和方法，分析常規余熱回收技術設計、採用普通鋼-水熱管和無機傳熱熱管等傳熱元件的設計余熱回收裝置的優缺點，並對余熱回收設計方案及其特點進行總體評價。
  3. This article aims at the boiler ' s problems in operation : 1 ) under nominal load, the smoke temperature at the outlet of hearth reaches 1200, far more exceeds 1050 the original designed temperature. this will always result in slag inside boiler and the temperature of overheater ' s pipe superheat, so that boiler cannot take nominal load and all these influence boiler ' s nomal operation heavily, 2 ) this article also studied the reason why the assistant oil becoming necessary when coal changes. during the nomal operation, many factors ( makeup of combustor and its disposal, smirch and encrust of water wall, excessive air coefficient, temperature of primary air, coal type and density of coal dust ) can deviate the designed working conditions, then affect the boiler ' s nomal operation

    本文針對該鍋爐在實際運行中存在的問題：在額定負荷下，爐膛出口超溫、低溫段過熱器前煙溫高達936 ，遠遠超過815的設計值；噴燃器四周水冷壁結焦嚴重，過熱器管壁溫度超標，無法帶上額定負荷；甚至有時因燃煤質量的變化，必須投油助燃的嚴重情況進行了分析研究。在實際生產過程中，燃燒器的結構、布置，水冷壁的粘污、結垢，過剩空氣系數、一次風溫、煤種及其濃度變化等許多因素都會偏離鍋爐的設計工況，從而影響爐內的傳熱和燃燒，造成爐膛出口超溫、水冷壁結渣等問題。
  4. Through measuring residual swhirling flow field in the flue duct of a real boiler, and analysing layout features of front and back platen supe - heaters in large - scale tangential firing boilers, the flue gas energy distribution regularity in horizontal flue duct of tangential firing boilers has been studied

    摘要通過對實際鍋爐煙道煙氣殘余旋轉流場的測量及大型切圓燃燒鍋爐前、后屏過熱器的布置特點分析，研究了切圓燃燒鍋爐水平煙道煙氣能量的分佈規律。
  5. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  6. The feasibility on the test of mixing recovered flue gas during water gas production with lpg to be used as gas for domestic use is discussed, the test scheme is described, and the test result is analyzed

    摘要探討了水煤氣回收煙氣摻混lpg作為居民用氣試驗的可行性，闡述了試驗方案，分析了試驗結果。
  7. It is found that the appropriate lowering of the chamber temperature of water gas producer and the thickness of coal bed is favorable to controlling the volume fraction of o2 and co in the recovered flue gas

    通過試驗與分析，發現適當降低水煤氣發生爐爐溫與煤層厚度，有利於控制回收煙氣中o2及co的體積分數。
  8. This paper establishes a platform of computer monitoring system for atrium fire experiment, discusses the testing methods of smoke flow, and analyses the design of hardware circuit, the workout of software and its parameters and functions of the computer acquistion system for atrium fire experiment in detail

    本文探討了火災煙氣的測試方法，建立了中庭火災微機監測系統平臺，並分析了微機檢測系統硬體電路的設計、軟體的編制以及系統的性能參數和功能。
  9. With analyzing of the case study and based on simulating and analyzing quantitatively, this article, considering the goal of the performance - based fire - protection design is protecting occupants from being injured and keeping buildings from being damaged, thought that fire compartmentation of a large building of saling books can be divided according to their saling malls and fire compartmentation in the saling mall can be separated by the fire - proof screen. on the evacuation design, the quantity of safety exits around these buildings and the evacuation width should be increased if possible and the safety exit number, exit width and evacuation distance can be determined according to the simulating results on smoke layer temperature and height, concentration of co2 and co, occupants evacuation time and visibility. on the means of preventing and discharging smoke, the most proper measure should be determined according to their geometrical characteristics and the natural means of discharging smoke is feasible to the large building of saling books. based on analyzing of smoke

    通過對案例分析研究，本文認為大型書城建築性能化防火設計研究的最終目的是保證人員生命安全和保證建築結構安全，在模擬計算和量化分析的基礎上，大型書城的防火分區可以將中庭連通的書城區域劃分為一個區，在書城場地內可以採用防火卷簾進行防火分區劃分;在人員疏散設計中，應盡可能利用書城賣場的空間設計較多的安全出口和增大疏散寬度，其安全出口數量、寬度和疏散距離可以根據人員安全疏散時間和煙氣溫度、沉降高度、 co2濃度、 co濃度、能見度模擬計算結果驗證確定;在防排煙方式的選擇上，應當根據建築物的幾何特點選取最適宜的措施，就大型書城建築而言，採用自然排煙的方式是可行的。
  10. Compressed air compressed air system dynamics characteristics analysis and its application on a tobacco company

    壓縮空氣系統動態特性分析及其在某煙草公司系統優化中的應用
  11. The big diameter punch hole pile foundation engineering in guangdong coastal area was analyzed in detail by the example pile foundation of 1 #, 2 # unit desulphurizing engineering technology building of zhuhai power plant

    摘要以珠海電廠1 # ， 2 #機組煙氣脫硫工程工藝樓樁基為例，對廣東浴海地區大直徑沖孔樁基工程進行了較為詳細地分析，以及對實際施工過程中的理論應用進行了論述。
  12. Analyses the smoke characteristics in the development of fire and obtains its changing curves. according to different fire loads, studies the changing relation between the critical velocity and fire intensity

    摘要分析了地鐵火災煙氣特性隨火災發展過程的變化情況，得到了煙氣特性變化曲線。針對不同的火災荷載，研究了臨界風速隨火災強度的變化關系。
  13. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  14. The analysis on condensation heat transfer of flue gas

    煙氣冷凝換熱過程分析
  15. Ascos analysis of smoke control systems

    煙氣控制系統分析
  16. By studying characteristics, merits and solving problems of the different nozzle and new spray equipment in asphalt gas decontaminating for carbon calciner, the research provides a basis for the industrial design of swirl nozzle

    摘要在闡述瀝青煙氣凈化系統中不同霧化設備及新型霧化設備特性的基礎上，分析了碳素焙燒爐瀝青煙氣凈化系統的霧化冷卻的技術現狀，並指出了存在的問題，為工程設計選擇霧化設備提供了參考。
  17. The calculated results are in agreement with the measured ones, indicating that according to the flow rate and composition of the exhaust gas and the mass and the carbon content of the liquid iron, the carbon content of steel bath can be dynamically determined ; with the aid of thermodynamic equilibrium analysis, the dynamic variation of temperature of the steel bath can be forecasted from the dynamic carbon content and the data from the exhaust gas analysis system

    該模型計算結果與檢測結果吻合較好，這表明：通過煙氣流量、成分及鐵水質量和初始碳含量可動態地確定熔池中的碳含量；以動態確定的碳含量為基礎，結合爐氣分析數據，再經熱力學平衡分析，可預測熔池溫度的動態變化。
  18. Health and safety in welding and allied processes - laboratory method for sampling fume and gases generated by arc welding - part 1 : determination of emission rate and sampling for analysis of particulate fume

    焊接和相關工藝的衛生與安全.電弧焊產生的煙塵和氣體取樣的試驗室方法.第1部分:顆粒煙塵排放率的測定和顆粒煙塵分析用取樣
  19. Verification regulation of flue gas analyzers

    煙氣分析儀檢定規程
  20. Health and safety in welding and allied processes - laboratory method for sampling fume and gases generated by arc welding - determination of emission rate and sampling for analysis of particulate fume

    焊接和有關加工工藝中的健康和安全性.電弧焊接產生的煙塵和氣體的實驗室取樣方法.排放率測定和顆粒煙塵分析的取樣
分享友人
分享到 Line

分享到臉書