熄弧電壓 的英文怎麼說
中文拼音 [xīhúdiànyā]
熄弧電壓
英文
blowout voltage-
According to the quickly adjustable characteristic of the peterson coil grounding system, this dissertation proposes a new control strategy. when the system is in operation, the strategy can limit the series resonance over - voltage by using the off - resonance method. when fault occurs, the strategy can conveniently suppressing arc by rapidly adjusting the inductance value of the peterson coil to the point, which the resonance with grounding capacitance of the power network is occurred
依據可控硅控制消弧線圈接地系統的快速可控性，一改傳統的電網正常運行時調節消弧線圈接近於全補償的預調諧方法，提出正常運行時採用脫諧方法抑制串聯諧振過電壓；故障時立即調節消弧線圈電感量達到與對地電容諧振，以利熄弧的新型調節原理和方法。Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead
通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點，發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下，通過調節焊接迴路中的電感量和電源電壓，可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行，並且熄弧時間最短時，短路過渡頻率最高，在這種情況下，飛濺小，焊道成型好，焊接過程穩定It is a very high advancement to the development from two - pressure arc - quenching chamber and single - pressure arc - quenching chamber to the self - energy arc - quenching chamber now for arc - quenching theory of sf6 cb make use of the arc blocking effect, namely arc - self - energy, to increase sf6 gas pressure in the arc - quenching chamber and get the efficient blasting effect to extinguish the arc when the arc current is zero
Sf _ 6斷路器從雙壓式、單壓式發展到如今的自能式是斷路器滅弧原理的一個重大飛躍。自能式sf _ 6斷路器利用電弧阻塞效應即利用電弧本身的能量使滅弧室內sf _ 6氣體的壓力升高，在電弧過零時產生有效的氣吹而熄滅電弧。After the neutral point is grounded through perterson coil, it can decrease the capacitor current through fault point and the over - voltage caused by the grounding fault, which is advantage for the extinguishments of electric arc
中性點經消弧線圈接地后，有效減小了流過故障點的電容電流，減小了弧光接地過電壓，有利於電弧熄滅。After the neutral point is grounded through peterson coil, it can decrease the capacitor current through fault point and the over - voltage caused by the grounding fault, which is advantage for the extinguishments of electric arc
中性點經消弧線圈接地后，有效地減小了流過故障點的電容電流，減小了弧光接地過電壓，有利於電弧熄滅。The blasting circuit breaker and the studied self - extinguishing circuit breaker that are in the same voltage level are compared. it proves that the arc energy can be used to help build the pressure of the expansion chamber and extinguishing the arc in order to lessen the driven energy
並且對同等級下壓氣式斷路器和自能式斷路器進行了比較，表明本文所研究的自能式斷路器是可以利用電弧能量熄滅電弧本身達到減小操作功的目的。分享友人