熔化溫度 的英文怎麼說

中文拼音 [rónghuàwēndù]
熔化溫度 英文
fusing temperature
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 熔化 : melt; smelt; meltdown; fusion; fusation; diatexis; eliquation; run; melting; smelting
  • 溫度 : [物理學] temperature
  1. The imported transparent glaze fired at lower temperature was analysed semi - quantitatively by adopting emission spectroscope. the stripping of lead and cadmium from this transparent glaze fired at lower temperature in ceramic product was determined by atomic absorption spectroscope. the effect of chemical composition on the stripping of lead and cadmium was analysed. upon the author s opinion, the overproof lead stripping from the imported transparent glaze fired at lower temperature can only be settled by adopting lead - free glaze instead of adopting low - lead prescription. the author succeeded in developing an excellent lead - free transparent glaze fired at the lower temperature of 1000 1050. the success is based on an inquiry into the feasibility of using such new agents of fusion as li2o and sro in replacement of pbo ; and on a study of the effects of the contents of sio2 ， al2o3 ， b2o3and other metallic oxides on such performances of glaze as coefficient of linear expansion, fusion temperature and transparency. it is also based on an analysis of coefficient of linear expansion of blank and glaze on an analysis of coefficient of linear expansion of blank and glaze on their correlation ; and on a study of technology for preparing glaze

    採用發射光譜儀對進口低溫透明釉進行半定量分析，並用原子吸收光譜儀測定其陶瓷製品的鉛、鎘的溶出量，分析化學成分對鉛、鎘溶出量的影響.結果表明，進口低溫透明釉採用低鉛配方不能解決鉛溶出量的超標問題，只有採用無鉛釉才能解決.探討用氧化鋰和氧化鍶等新型熔劑完全代替氧化鉛的工藝，研究釉料中氧化硅、氧化鋁、氧化硼和各種金屬氧化物的含量，對釉的線膨脹系數、熔融溫度和透明度等性能的影響.分析坯料、釉料的線膨脹系數及其相互關系和釉料制備的工藝，研製出優質的1000 1050低溫無鉛透明釉
  2. Sodium tellurite glasses are considered as potential candidates for non - linear optical applications because of high refractive index values and wide infrared transmittance. on the other hand, because the glasses have relatively low melting temperature and low viscosity after melting, they are often chosen to study the melting, evaporation and solidification of glasses in low gravity

    另一方面，由於這類玻璃的熔融溫度較低，在溫度較高時會揮發產生氣體，熔融后熔體的粘度較低，玻璃形成能力強，因此被用來研究微重力下玻璃的熔化和氣化，和微重力對玻璃析晶能力的影響。
  3. The molecular dynamics simulation method has been used to study the relation between the melting temperature and the cohesive energy of pb nanofilms

    摘要本文利用分子動力學方法研究了鉛納米薄膜的熔化溫度與結合能的關系。
  4. It is found that the relation between the melting temperature and the cohesive energy of bulk materials can be used to nanomaterials, but the coefficient depends on the height of nanofilms

    研究表明，塊體材料熔化溫度與結合能的關系式在納米薄膜體系仍然成立，但比例系數是一個依賴于薄膜厚度的參量。
  5. The technological capabilities of electronic solders were presented through analysis the action of solders in the soldering process, which includes temperature of melting or solidifying, anti - oxidation capability, wetability and overflow capability

    摘要通過分析焊料在釬焊過程中的行為，提出了電子焊料的工藝性能主要包括熔化固化溫度、抗氧化性、潤濕性和漫流性。
  6. Increase melt and mould temperature, and injection speed

    具和熔化溫度以及注塑速度
  7. Reduce melt temperature or shorten overall cycle

    降低熔化溫度和縮短周期
  8. Molecular dynamics simulations for melting temperatures of caf

    2熔化溫度的分子動力學模擬
  9. Study on size effect of melting temperature of pb nanowires

    鉛納米線熔化溫度的尺寸效應研究
  10. Increase back pressure or melt temperature

    增加背壓和熔化溫度
  11. Melting temperatures of common alloys

    普通合金的熔化溫度
  12. Reduce nozzle and melt temperature

    降低噴嘴和熔化溫度
  13. For blow molding, melt temperatures of 160 c to 220 c are recommended

    吹塑成型的推薦熔化溫度在160到220度之間。
  14. Standard practice for determination of fusion temperature of dry electrostatic heat - fixing toners

    干靜電熱定影的調色劑熔化溫度的測定
  15. Test methods for lead - free solders - part 1 : methods for measuring of melting temperature ranges

    無鉛焊劑的試驗方法.第1部分:熔化溫度范圍的測量方法
  16. The results show that the sinters for the bf in shuicheng iron and steel co., ltd. have middle rdi ( low temperature reduction degradation index ), choice ri ( reduction index ), wider softening temperature range, high start melt and dropping temperature, smaller melt and dropping temperature range

    研究結果表明，水鋼燒結礦具有中等及中等偏下的低溫還原粉化性能和優良的還原性能；軟化區間偏寬，開始熔化溫度高和開始滴落溫度高，卻有較窄的熔滴區間。
  17. The traditional measuring method of melting and crystallizing temperature is complex and inefficient

    摘要傳統的熔化溫度和結晶溫度測量方法復雜、效率低。
  18. A new measuring instrument for melting and crystallizing temperature of smelting slag is designed by adopting advanced microcomputer technology, micro - controller technology, and computer image processing technology in order to accurately and efficiently measure physical features of smelting slag, e. g. melting temperature, flowing temperature, crystallizing temperature, and crystallizing rate, etc

    設計了一種採用先進的微型計算機技術、微控制器技術、計算機圖像處理技術相結合的冶金爐渣熔化結晶溫度測定儀，能夠準確高效地測試冶金爐渣等材料的熔化溫度、流動溫度、結晶溫度、結晶率等物理特性。
  19. Determination of heats and temperatures of melting and crystallization of electrical insulating materials by differential scanning calorimetry

    用差示掃描量熱法對電氣絕緣材料的結晶熔化溫度和熱量的測定
  20. The results indicate that there are some quasiliquid layers on plane ( 001 ) at some temperature below the melting points of the prefect crystals

    結果表明， （ 001 ）面在低於其完整晶體的熔化溫度出現預熔。
分享友人
分享到 Line

分享到臉書