熔化轉變 的英文怎麼說
中文拼音 [rónghuàzhuǎnbiàn]
熔化轉變
英文
melting transition-
The globalization course was that the preformed texture recrystallized and became the granular equiaxed grain, when the temperature rose and the holding time prolonged, the granular grain melted at some area and at the liquid - solid interface the grain globalized at the role of the curvature overheated
過程機制為：擠壓形變組織在加熱過程中首先發生再結晶長大變為顆粒狀等軸晶；隨溫度升高和保溫時間延長，等軸晶發生局部熔化，液固界面的曲率過熱使晶粒外形向球狀轉變。5, both melting point ( tm ) and isotropization temperature ( tj ) of all the three series compounds change regularly with the carbon numbers of the end alkoxy group increased. there is a gradual increase in smectic phase length and in the smectic - nemetic transition temperature. at the same time there is a gradual decrease in nemetic phase length
五，三個類型化合物16ia至16id 、 16ila至16lid 、 17ia至17id 、 17ila至17lid 、 18ia至18id和18ila至18lid的熔點和液晶態的清亮點均化合物分子中末端烷氧基增大逐漸降低；近晶相的溫度范圍和近晶相一向列相轉變溫度逐漸增大，而向列相的溫度范圍遞減。The crystallization and melting behavior of mellocene - catalized branched and linear polyethylenes of low molecular weight was studied. it was found that the crystalline lattice of branched polyethylene is larger than that of linear polyethylene because of the existence of branched chains. the melting behavior of branched polyethylene is similar to that of linear polyethylene since the branched chains can not enter the lattice. however, the crystalline behavior of low molecular weight branched polyethylene is the same as that of high molecular weight linear polyethylene, but different with that of low molecular weigh linear polyethylene. kinetics theory analysis evidenced that the transition temperature of growth regime of the branched polyethylene is about 20 lower than that of linear polyethylene with the same molecular weight. it may be attributed to the existence of short branched chains
研究了金屬茂催化的低分子量支化聚乙烯和線性聚乙烯的結晶及熔融行為，發現支化聚乙烯的結構與線性聚乙烯相同為正交結構，但晶格略有膨脹.支鏈的存在對熔融行為影響不大，兩種聚乙烯的熔點均隨結晶溫度的升高而非線性增加，表現出低分子量樣品的共同特徵.但支鏈的存在對結晶行為卻有很大的影響，主要是由於支鏈的存在降低了晶體的結晶速率從而影響結晶過程，使得低分子量的支化聚乙烯的結晶行為與高分子量線性聚乙烯的結晶行為相似而與低分子量的線性聚乙烯不同.動力學分析表明，低分子量的支化聚乙烯的結晶生長方式的轉變溫度比同等分子量的線性聚乙烯降低了約20Abstract : during the heating of scrap with carbon or hydrocarbon contented substances in some process, it will bring problems like explosion of carbon monoxide, fume and smell from oil volatilization, etc. ， if incomplete combustion occurs. through laboratory experiments, the time related variation of gas contents and post combustion ratio of fume during the heating of oil - bearing scrap are studied. the results show that the restrictive chain of reaction procedure is the thermolysis of oil ; that temperature and ( co ) / ( co2 ) ratio influence transformation ratio and post - combustion ratio under lower temperature ; that 900 is the temperature above which the complete reaction can be ensured at all ( co ) / ( co2 ) ratios
文摘:在某些廢鋼熔煉過程中，當爐料中含碳及碳氫物質且燃燒不充分時，會帶來煙氣中一氧化碳的燃爆、油污揮發時造成的煙霧、臭味等問題.通過實驗室裝置研究含油廢鋼在加熱過程中煙氣成分隨時間的改變以及二次燃燒率的變化，試驗結果表明，反應過程的限制性環節是油分的熱分解；在較低的溫度下（ co ） / （ co2 ）比例影響轉化率和二次燃燒率；而在任意比例下保證充分反應的溫度為900以上Servo control computer system / microcomputer universal testing machines, ozone tester, compression flexometer, computer hdt / vicat tester, digital impact tester, melt flow indexer, moving die rheometer, mooney viscometer, lamination of pvc plastic press tester
伺服控制電腦系統微電腦式拉力試驗機，耐臭氧機，橡膠壓縮生熱試驗機，塑料用維卡熱變形，數位沖擊試驗機，塑膠熔體流動速率機，無轉子密閉膜腔硫化儀，門尼黏度試驗機等等。Meanwhile it retains evenness on lift force to prevent leakage of residue that is caused by installation clearance error or changes in welding criteria, flow off molten iron as well as break - over welding, so that the ideal fosion depth and finishment have been fulfilled
在需原動力的條件下，該機利用彈性夾角變化，隨著筒體轉動，使墊層焊劑始終緊貼筒體外側環向焊接區，並保持托力均勻防止因裝配間隙誤差或焊接規范變化而引起漏渣，鐵水下淌及焊穿現象，達到理想的熔深度和光潔度。Studying the heat - mass transfer and multi - spices electric - chemical reaction, a dynamic temperature model was deduced for molten - carbonate fuel cell stack. the thermal radiation, shift reaction, and the change of gas spices were considered in this model. establishing momentum equation, the paper has developed a 3d temperature and flow fields model for mcfc stack based on cfd technique
建立了熔融碳酸鹽燃料電池堆內部單體的暫態溫度模型，並考慮了電堆的輻射換熱、轉換反應、反應氣體組分變化對溫度場的影響；根據mcfc的微分控制方程組，考慮氣體組分的熱力學性質及動量變化的影響，利用數值分析方法求解熔融碳酸鹽燃料電池堆的三維流場與溫度場，分析了各作用因素對熔融碳酸鹽燃料電池堆溫度分佈的影響機制。For the crystalline polymer matrix, the ptc transition temperature is close to the melting point, while for the amorphous polymer matrix, the ptc transition temperature is close to the glass transition temperature
Ptc轉變溫度與體積膨脹的轉變溫度非常一致，對于結晶聚合物基體體系， ptc轉變溫度在基體的熔點附近，而對于非晶聚合物基體體系， ptc轉變溫度在基體的玻璃化轉變溫度附近。Glass transition temperatures decreased with the length of soft units increasing, however, the effects of soft units were random
隨柔性間隔基k度的增加，玻璃化轉變溫度卜降，但柔性間隔基對熔點的影響是無規律的。Through the analysis of the evolution of the microstructure, the honey comb at the grain boundary and the pool in the grain, furthermore according to the phase change thermodynamic and kinetics, the conclusions of the globalization mechanism and the reheating parameters were drawn as follows. 1
通過對半固態再結晶和半固態熔化過程中的組織轉變、晶界蜂巢及晶內液池現象的分析，結合相變熱力學和動力學原理，提出sima法制備鎂合金半固態球狀化組織的形成機制及工藝參數。Pole shifts are a cataclysmic inversion of the planet ' s axis of rotation, up to 180 degrees ; a sudden slippage of the planet ' s solid crust around the molten core
磁極轉換是行星旋轉軸的大變動倒置，等於180度翻轉；在熔化的地核周圍行星固體外殼突然意外的滑移。分享友人