熔線單位 的英文怎麼說
中文拼音 [róngxiàndānwèi]
熔線單位
英文
fuse unit-
Using the thermodynamic conditions describing the coexistence of two phases and the stability conditions of equilibrium state, we have calculated the normalized temperature and the normalized pressure of the triple point ( t1, p1 ), the melting curve, vapouring curve and the sublimation curve. the whole phase diagram of the 2d monatomic l - j system is obtained
和杜宜瑾等人的方法類似，我們先給出了系統在相變點時的一些參數的數值，在此基礎上，考慮占據率q的因素，利用相平衡的熱力學條件及平衡態的穩定性條件，得到了二維單元l - j系統的熔化曲線、汽化曲線、升華曲線以及三相點的位置，從而給出了該系統的完整的三相圖。Find the law of the influence from the injection pressure to the filling time and the cavity pressure and make certain of the best filling time, injection time and injection pressure. though the analysis of the flowing velocity and pressure spread of the key position element in the injection parts in different gate position, we forecast the injection parts quality and the possibility injection flaw and its position, optimize the gate position. in this paper, though the research of analogue of the runner system of metal - powder injection molding and the process of injection molding, we get the law of how the injection parameter influence the injection process
在相同的注射條件下，通過分析喂料在不同直徑和長度流道中的流動規律，得到了喂料在流道中的速度場、壓力場和溫度場，找到了流道長徑比的合理取值范圍，並得出通過改變流道設計可實現對現有設備資源充分利用的結論；給出了不同注射壓力下，型腔壓力與充模時間關系曲線和喂料熔體平均充填速度與充模時間關系的曲線，得到了注射壓力對充填時間和型腔壓力的影響規律，確定了最佳的充模時間、注射時間和注射壓力；通過分析採用不同位置澆口注射時注射件關鍵位置單元的流動速度和壓力分佈，預測了注射件的成形質量，或可能產生的注射缺陷及位置，優化了澆口設置。
分享友人