熔距 的英文怎麼說

中文拼音 [róngjù]
熔距 英文
melting range
  • 熔 : 動詞（熔化） melt; fuse; smelt
  • 距 : Ⅰ名詞1 （距離） distance 2 （雄雞、雉等的腿的後面突出像腳趾的部分） spur （of a cock etc ）Ⅱ動詞...
  1. The results show that there is anomalistic crystal whose size reaches nanometer grade in fine pvc ; the crystal structure is damaged by jet - milling, which induces the melting point of nanocrystal pvc decreases from 210 to 128. the nanocrystal pvc induces the decrease of plasicizing time and equilibrium torque and the increase of maximal torque, which show that the nanocrystal pvc have self - plasticization in pvc composites

    通過sem 、 tem 、 ftir和dsc測試表明：氣流粉碎制得的pvc微粉中具有不規則納米晶體；氣流粉碎破壞了pvc的晶體結構，使納米晶pvc的熔點從210下降到128 ；納米晶pvc使體系塑化時間、平衡轉距的降低、最大轉距升高，具有自增塑作用。
  2. Distant effect of jurassic collisions of qiangtang terrane, lasa terrane and paleo - pacific land onto the eurasian land made east qinling - dabie mountains in a compressional circumstance for a long time, and suppressed its orogenic extension ; whereas, cretaceous late - collisional extension and appearance of west pacific trench - arc - basin system relieved east qinling - dabie mountains of external compression, instantly result in violent orogenic lithosphere delamination - extension and depressurized - calefactive melting, and consequently, led to the formation of large scale early cretaceous granitoids and intermediate - acidic volcanic rocks

    羌塘地體拉薩地體和西太平洋古陸在侏羅紀與歐亞大陸拼貼碰撞的遠距離效應使東秦嶺大別造山帶長期處于擠壓環境，伸展作用被抑制白堊紀的碰撞晚期伸展和西太平洋溝弧盆體系的遠距離效應使東秦嶺大別地區的外部擠壓消失，導致造山帶巖石圈迅速強烈拆沉伸展和減壓增溫熔融，從而形成大規模早白堊世花崗巖類和中酸性火山巖。
  3. In this investigation carbon black - filled electrical conductive composites of poly ( ethylene terephthalate ) / polyethylene were first prepared through the single - screw melt - blended extrusion, then drawing, followed by the quenching and subsequent press molding. the relationships among the influencing factors including composition, hot stretching ratio and compatibilizer, morphology and properties of composites were systematically investigated. positive temperature coefficients effect and crystallization behaviors of composites were preliminarily analyzed

    本文擬採用單螺桿熔融共混擠出?熱拉伸?淬冷的新的成型方法制備炭黑填充的pet pe復合導電材料，熱拉伸的目的是使材料的分散相（ pet相）在加工過程中原位形成纖維，而炭黑基本分散在纖維中或纖維的表面上，使炭黑粒子間間距減小，形成更多的導電通路，從而提高材料的導電性能，同時保持或提高材料的力學性能。
  4. Specially for welding of thin and mid - thickness steel ; suitable for mag co2 welding of low carbon steel and low alloy steel inner wire feeder structure ; zx5 series thyristor dc arc welder ac arc welder with single phase moveable coil for sma mma welding ; suitable for welding low carbon steel, low alloy steel ; suitable for welding mid - thickness steel

    可用於所有牌號焊條的直接手工電弧焊接引弧容易，無須用戶調節可遠距離調節焊接電流，便於焊工操作焊機動特性好，性能柔和，電弧穩定焊接熔池平靜，飛濺小，不咬邊，焊縫成形美觀。
  5. Extraction of large - fragment genomic dna in order to gain dna template of pcr amplification ( long pcr amplification and salvage pcr amplification ) which was high purity and large fragment, three methods were used to extract genomic dna of bacillus subtilis, i. e. low melting - point agarose embedding method, sds - proteinase k - phenol chloroform extraction method and bacterial genomic dna extraction kit method. the genomic dna of bacillus subtilis were gained by these methods, and the operated programs of the methods were improved. the results showed that the genomic dna extracted by low melting - point agarose embedding method were obviously biggest than that of another two methods

    大片段基因組dna的提取為了獲得用於pcr擴增（長距離pcr擴增和分段pcr擴增）的高純度、大片段（至少為pcr產物長度的4倍）的dna模板，應用三種方法：低熔點瓊脂糖包埋法， sds -蛋白酶k -酚氯仿抽提法和細菌基因組dna提取試劑盒法，分別提取獲得了枯草桿菌基因組dna ，並對3種方法的操作程序進行了不同程度的改進，結果表明：低熔點瓊脂糖包埋法提取的基因組dna片段明顯大於后兩種方法，採用0 . 5瓊脂糖凝膠電泳3h ，仍然跑不出加樣孔。
  6. Due to the great pressure from the spring of upper static interface, it is obvious that there are not only many difficulties, but also many insecure factors in artificial operation, especially when it is raining. up to now, with the exception of self - falling when fault happens, all disjunction and close of the high - voltage explosion fuse are manipulated manually

    由於該類型熔斷器的對地安全距離至少為4 . 5米，且其上部靜觸點的彈簧壓力亦很大，因此人工操作熔管的分合不僅具有相當的難度，且操作過程中的不安全因素甚多。
  7. During the spectacular series of eruptions at etna ' s southeast crater in the first half of 2000, these fountains rose as high as 1, 200 meters above the crater ' s rim ? a stunning height rarely observed at any volcano

    2000年上半年一連串壯觀的噴發中，埃特納的東南方火山口就噴出了距火山口1200公尺高的熔巖噴泉，這麼驚人的高度在全世界任何火山都屬罕見。
  8. The influence of the temperature of durene solution, the height from airway nozzle to liquid level, the temperature and feed rate of air on the vapor phase concentration of durene were studied with the self - made adjustor

    摘要利用自製的高熔點物料氣相濃度調控儀，研究了均四甲苯溶液的溫度、導氣管管口距離均四甲苯液面的高度、空氣進氣溫度和進料量等對均四甲苯氣相濃度的影響。
  9. The structural characterization of v _ 2o _ 5 compounds were measured bymeans of differential thermoanalysis ( dta ) and thermogravimetry ( tg ), scanning electron microscopy ( sem ), and x - ray diffraction ( xrd ). the testsreveale that materials which were prepared by sol - gel ( inorganic sol gel andmelting - coling ) showed that the amorphous structure, and the interlayer spacingenlarge a lot than that of crystalline v _ 2o _ 5

    採用熱重與差熱（ tg - dta ） ，掃描電子顯微鏡（ sem ） ， x射線衍射（ xrd ）等測試手段對材料的結構性能進行表徵，結果顯示兩種溶膠-凝膠法（無機溶膠凝膠法和熔融淬冷法）制備的v _ 2o _ 5材料均為無定型結構，其層面間距均比晶體v _ 2o _ 5成倍增大。
  10. The results showed that there was anomalistic crystal whose size reached nanometer grade in fine pvc ; it ' s about 80nm. the crystal structure was damaged by jet - milling, which induced the melting point of nanocrystal pvc decreased from 210 " c to 128 擄 c. the nanocrystal pvc induced the decrease. of plasicizing time and equilibrium torque and the increase of maximal torque, which showed that the nanocrystal pvc had self - plasticization in pvc composites

    通過sem 、 tem 、 ftir和dsc測試表明：氣流粉碎制得的pvc微粉中具有不規則納米晶體，尺寸在80nm左右；氣流粉碎破壞了pvc的晶體結構，使納米晶pvc的熔點從210下降到128 ；納米晶pvc使體系塑化時間、平衡轉距降低、最大轉距升高，具有自增塑作用；納米晶pvc的加入使pvc的沖擊和拉伸強度都有大幅度上升。
  11. The mechanica1 performance is superior to p1ain pp. 0n the sem photographs of impact fracture surface, it was observed that the pu11out of si licate 1ayers hard1y was found and the compat ibi 1 ity of pp and montmori l 1oni te was improved great l y. xrd resu1 ts suggested that the basal spacing of silicate layer was about 4

    小角xrd結果顯示，復合材料中無機片層間距d _ （ 001 ）在4 . 0nm左右，為插層型材料，通過dsc測試發現復合材料的熔點和分解溫度均有一定的提高，蒙脫土的加入可提高材料的熱性能。
  12. The melting controlling on 3t h two rows distance cold blast cupola

    兩排大間距冷風沖天爐的熔煉控制
  13. Treated with prudent chosen intercalation regent, hydrophilic montmorillonite becomes hydrophobic ; the interlayer distance of montmorillonite is expanded and the compatibility of montmorillonite with polymer matrix is improved. montmorillonite disperses in the polymer matrix promoted by mechanical force and chemical interaction, which make it possible to prepare polymer / clay nanocomposite by melt intercalation process

    通過對蒙脫土進行有機化處理，使蒙脫土由親水性變為親油性，蒙脫土層間距增大並改善蒙脫土與聚合物基體的相容性；利用受限空間內力化學作用促進蒙脫土在聚合物中的分散，使熔融插層法制備聚合物粘土納米復合材料成為可能。
分享友人
分享到 Line

分享到臉書