熱值測量 的英文怎麼說

中文拼音 [rèzhícèliáng]
熱值測量 英文
measurement of caloric value
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
  1. In order to elaborate the app licability of osl to loess, especially single aliquot regenerative protocol ( sar ), involving stimulation of the same disc with an infra - red laser diode followed by blue leds to polymineralic fine - grains of loess, such explanations as light bleaching, preheat, anomalous fading, prior - ir exposure were investigated in this paper. for drawing adequate coarse grains from loess, quartz and feldspars, as well as loess, were etched by hydrofluoric acid and fluorosilicic acid. the sequence of ages of holocene loess in weihe rivier basin has been established by single - aliquot ( sar ) and multiple - aliquot using fine - grains and sar using coarse - grains

    本文通過渭河流域全新世黃土的光曬退實驗，地表黃土樣品的d _ e值測定，細顆粒單片的預熱、反常衰退、紅外暴露實驗，說明釋光測年在全新世黃土中應用的可行性及單片再生劑量法（ sar ）在黃土細顆粒中的適用性；為了從黃土中分離出足夠的粗顆粒，進行了純石英和長石的氫氟酸（ hf ）和氟硅酸（ h _ 2sif _ 6 ）溶蝕實驗，黃土粗顆粒石英溶蝕分離實驗；通過細顆粒單片、多片的blsl 、 irsl和post - irosl ，熱釋光，及粗顆粒石英的blsl的年代測定，選擇適于全新世黃土的釋光測年方法，並建立了渭河流域全新世黃土的年代序列。
  2. After the bottleneck in the original ethene production plant is analyzed, the revamp design plan for srt - iii cracking furnace is proposed. the measuring results after revampment show that the thermal efficiency and ethene recovery ratio are increased compared with the design data ; the production capacity of ethene cracking furnace is enhanced, and energy consumption is reducted

    通過分析原乙烯裝置生產存在的「瓶頸」 ，提出了srt -型裂解爐改造的設計方案，並對改造後效果進行測量，熱效率和乙烯收率均比設計值有所提高，乙烯裂解爐的生產能力提高了，能耗降低了。
  3. This thesis aims to design one instrument to measurement of the fluid thermal conductivity by used the hot - wire method ( hwm ). firstly expatiated on the theory of this method, got the academic solution by analyzing the ideal model, and then amended the ideal solution to satisfy the factual situations

    本文重點討論瞬態熱線法測量液體的導熱系數，從理論與實驗及數值模擬的角度分析探討瞬態熱線法測量液體導熱系數原理及其實現過程，並分析理論與實際測量過程中的誤差產生原因及誤差避免與校正。
  4. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  5. Test method for gross calorific value of coal and coke by the isoperibol bomb calorimeter

    等溫彈式量熱器測定煤和焦炭總熱值的試驗方法
  6. 05. 01 heat of combustion of liquid hydrocarbon fuels by bomb calorimeter, method of test for

    用氧彈式量熱計測定液態烴燃料燃燒熱值的方法
  7. Standard test method for gross calorific value of refuse - derived fuel by the bomb calorimeter

    用彈式量熱計測量廢棄物中回收燃料的總熱量值的標準試驗方法
  8. Heat combustion of liquid hydrocarbon fuels by bomb calorimeter intermediate precision method, test method for

    用彈式量熱法測定液態烴類燃料的燃燒熱值的方法
  9. Animal feeding stuffs, animal products, and faeces or urine - determination of gross calorific value - bomb calorimeter method

    動物飼料動物產品和糞便或尿液.總熱值的測定.彈式量熱計法
  10. Test method for gross calorific value of coal and coke by microprocessor controlled isoperibol calorimeters

    用微處理機控制的恆溫量熱器測量煤和焦炭總熱值的試驗方法
  11. This paper describes how to calculate the temperature of high - temp gas at the outlet of combustor by means of limited gas composition and analyses how errors in measuring gas composition, low calorific value of fuel, fuel composition and fuel temperature, etc. affect gas temperature

    摘要敘述了一種根據有限的燃氣成分推算燃燒室出口高溫燃氣溫度的計算方法，並分析了燃氣成分測量誤差、燃料低熱值、燃料成分及燃料溫度等對燃氣溫度的影響。
  12. In this paper, the sensibility analysis of the factors affecting the temperature in well bore is relatively systematically made by using a large number of the data calculated with the borehole flow and heat transfer 3 ? d numerical model proposed by the author. the study shows that the thermophysical parameters of the drilling fluid and formation, etc. and the entrance temperature and circulating capacity, etc. of drilling fluid have a greater influence on the temperature in well bore. therefore, accurately mastering the thermophysical parameter values of penetrated formation and drilling fluid in well bore, considering the influence of the temperature and pressure on thermophysical parameters and accurately measuring such parameters as entrance temperature and discharge capacity of drilling fluid, etc. are of utmost importance for accurately simulating the temperature in well bore

    利用由作者提出的井內流動和傳熱的三維數值模型計算所得的大量數據，文章對影響井內溫度的諸多因素進行了較系統的敏感性分析，研究表明：鉆井液和地層等的熱物理參數以及鉆井液的入口溫度、循環排量等對井內溫度有較大影響，因此，準確掌握所鉆地區地層和井內鉆井液的熱物理參數值，考慮溫度壓力對熱物理參數的影響，準確測量鉆井液的入口溫度、排量等參數值，對于井內溫度的準確模擬至關重要。
  13. Standard test method for calorific heating value of gases in natural gas range by continuous recording calorimeter

    用連續記錄量熱器測定天燃氣范圍中煤氣熱值的標準測試方法
  14. Testing of solid and liquid fuels - determination of gross calorific value by the bomb calorimeter and calculation of net calorific value - part 3 : method using adiabatic jacket

    固體和液體燃料試驗.用彈式量熱器測定總熱值以及凈熱
  15. Testing of solid and liquid fuels - determination of gross calorific value by the bomb calorimeter and calculation of net calorific value - part 1 : principles, apparatus, methods

    固體和液體燃料試驗.用單式量熱器測定總熱值並計算凈
  16. Water - source heat pumps - testing and rating for performance : part 2 - water - to - water and brine - to - water heat pumps

    水源熱力泵.性能試驗和額定值測量.第2部分:水-水和鹽水-水熱力泵
  17. The calculation program using the matlab has been worked out to get the numerical solutions of the proposed models. the experiment has first been conducted in the laboratory to get the fundamentals thermal and moisture properties ( such as materials density, specific heat capacity and thermal conductivity ) and also the material moisture absorption isotherms of adobe building materials. the methods of measuring the surface mass transfer coefficient and material moisture content have been proposed

    首次對生土建築材料物性參數進行了實驗測試，得到了常用生土建築材料的密度、比熱和導熱系數等參數值，得到了生土建築圍護結構的等溫吸濕平衡曲線的擬合函數關系式；此外，研究了生土建築圍護結構表面質交換系數實驗測定方法，探索了利用電阻率測量生土建築圍護的安窪築科技人學博十學位論文結構內部含濕量的測試方法。
  18. Much works has been distributed to the development of a vacuum system to simulate the outer space and a measurement system to test the arcjet performance. ignition experiments in various operational modes have been done with argon as propellant. macroscopical working parameters including thrust, mass flow rate, voltage, current, inlet pressure and vacuity are obtained by the test measurement system and actual performance parameters including specific impulse, thrust efficiency, ratio of thrust and power and ratio of power and mass flow are calculated

    以氬氣作為推進劑，在不同工況下進行點火實驗，測量獲得了其工作推力、電弧電壓和電流、推進劑流率和弧室壓力等宏觀參數，得到了不同實驗條件下其工作的實際比沖、推力效率、推力/功率比以及比功率等性能參數，分析了推進劑質量流率、電弧功率、電弧加熱發動機電弧室結構尺寸等因素對其性能的影響，為數值模擬研究和實際的低功率電弧加熱發動機優化設計及研製提供了實驗基礎。
  19. ( 5 ) the ability of carry out a porous shock compression experiments with uncertainty less than 20 % has been had, and then there is a possibility to obtain at high pressure with uncertainty less than 10 %. ( 6 ) another method to get, utilizing the method 3 p _ ( c ) and shock compression data, has been investigated. it has been shown preliminarily that there a simple phenomenal project to calculate by utiliaing this method

    第三方面，考察了以實驗數據計算的一些情況，獲得的主要結果為（ 5 ）就目前所能達到的實驗精度，開展具有適當初始疏鬆度的疏鬆材料的沖擊壓縮實驗可提供不確定度10的高壓實驗測量值； （ 6 ）利用本文給出的冷壓與沖擊壓縮實驗數據聯立的方法計算了大量金屬的寬熱力學范圍的男，初步的分析表明，以該方法為基礎可形成一種更多保留實驗信息的gruneisen系數唯象計算方法。
  20. Water - source heat pumps - testing and rating for performance : part 1 - water - to - air and brine - to - air heat pumps

    水源熱力泵.性能試驗和額定值測量.第1部分:水-空氣和鹽水-空氣熱力泵
分享友人
分享到 Line

分享到臉書