熱制備 的英文怎麼說

中文拼音 [rèzhìbèi]
熱制備 英文
hotpreparation
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 備 : Ⅰ動詞1 （具備; 具有） have; be equipped with 2 （準備） prepare; provide with; get ready 3 （防備...
  1. Through preparative experiments and optimized experiments on cu ~ zn ultrafine powders that are prepared by the method of thermal spray and ball milling, the author finds that dispersants concentration, dispersing time, ph, temperature and adscititious ions have significant influences on dispersing effects

    西安理工大學碩士學位論文通過對熱噴塗球磨法制備的超細銅鋅粉的分散性進行預試驗和優化試驗，發現分散劑濃度、分散時間、 ph值、溫度和外加離子濃度對分散作用效果有重要影響。
  2. The activation energies of crystal growth were calculated to be 15. 9kj mol " 1 and 148. 7kj mol " 1 respectively. cerous nitrate as originating material, ammonium hydrogen carbonate as precipitator, nanocrystalline cec > 2 powders were prepared by precipitation process. during the experiment, reacting solution was heated by microwave energy

    採用碳酸氫銨作為沉澱劑，聚乙二醇等表面活性劑為保護劑，採用逐滴加入沉澱劑，微波加熱代替傳統加熱的均相沉澱法，制備出了粒度小、分散性好的ceo _ 2納米粉體。
  3. That is the premise of the bg / ha electrophoresis codeposition. the laws of the electrophoresis deposition of the bg and ha partic les were found by the study on each of their deposition under the different conditions. the electrophoresis codeposition of the bg and ha particles had been studied and the bg / ha graded coating, which is compact in the bottom layer and porous near the surface layer, had been prepared on the surface of the dental implant after the low temperature heat treatment ( about 740 ) and fast firing ( 50 - 80 / min, heat preservation time was 5 - 8min. )

    以bg微粉和ha微粉作為塗層原料，通過研究bg和ha微粉在非水介質中的分散情況和帶電特性，選擇冰醋酸為介質，使分散在其中的bg顆粒和ha顆粒表面均帶上正電荷，為電泳共沉積提供前提條件；通過對不同條件下bg 、 ha各自電泳沉積的研究，探索出了兩者電泳沉積的規律；通過對bg和ha在冰醋酸中電泳共沉積以及后續低溫（ 740左右）快燒（ 50 ? 80 min ，保溫5 ? 8min ）熱處理的研究，在鈦合金牙根種植體基體上成功制備出了底層緻密而表層多孔的bg ha梯度塗層。
  4. In this paper, 6013al / sicp / gr metal matrix composite ( mmc ) was produced by spray codeposition, by means of changing the medium of quenching, influence of five types of heat treatment system ( furnace cooling, air cooling, water quenching, dry ice quenching, liquid nitrogen quenching ) and different aging temperature on the damping was studied systematically

    本文採用噴射共沉積方法制備了6013al sicp gr金屬基復合材料（ mmc ） ，通過改變淬火介質，較為系統地研究了五種熱處理制度（爐冷、空冷、水冷、乾冰冷及液氮冷）以及不同時效溫度（ 120 、 150 、 170 、 190及210 ）對6013al sicp grmmc阻尼性能影響。
  5. In this thesis, the development of emulsion polymerization theory and related new technologies are comprehensively reviewed, and the synthetic technologies of acrylate latex modified by organosilicon both at home and abroad are also reviewed. based on the current development and research in this field, attentions of this study are focused on three ways for preparing novel acrylate latexes modified by organosilicons, that is, 1 ) the acrylate monomers are copolymerized with unsaturated silicons by emulsion copolymerization ; 2 ) a new latex with microphase separation morphology is synthesized, which shows a core - shell structure character ; 3 ) soap - free polymerization is explored for preparing a higher - performance latex using an unsaturated silicon monomer, different acrylates and a reactive emulsifier. by using techniques of delaying addition of organosilicon monomer and a hydrolysis inhibitor, the hydrolysis and condensation of 3 - ( trimethoxysilyl ) propyl methacrylate during polymerization can be effectively prevented, as a result, organosilicon content in the macromolecular chain is increased

    同時採用有機硅單體延遲滴加及添加水解抑制劑等技術，有效防止了-甲基丙烯酰氧基丙基三甲氧基硅烷在乳液聚合過程中的過渡水解及縮合反應，提高了聚合物大分子鏈中有機硅鏈節的含量；利用紅外光譜與差示掃描量熱儀對產物分子結構進行了表徵，並通過對共聚產物力學和吸水率的測試，證實了本研究所制備的有機硅改性丙烯酸酯共聚物具有比純丙烯酸酯聚合物更優良的力學及耐水性能；從分子設計角度出發，利用醇解反應合成出水解、縮合反應速率較慢的兩種新型不飽和有機硅單體： ?甲基丙烯酰氧基丙基三乙氧基硅烷和?甲基丙烯酰氧基丙基三異丙氧基硅烷；利用核磁共振對新型硅烷單體結構進行了證實；研究表明利用新型硅烷單體可以制備出高硅烷含量的有機硅改性丙烯酸酯乳液，且其聚合產物具有較高的力學及耐水性能。
  6. This thesis reports some results on the hot press sintering of nano - composite wc - co powder, which is prepared by spray pyrogenation & continuous deoxidization and carbonization process

    本課題採用熱壓燒結技術對以噴霧熱解?連續還原碳化法制備的納米復合wc - co粉末進行了熱壓燒結研究。
  7. Linio2 - based compounds were promising candidates of cathode materials for lithium ion batteries. but they still possessed various problems such as the difficulty of preparation, the poor heat stability and the dissatisfactory cycleability performance and so on, which insolubility for its practical applications, so it must be optimized synthesis and changed perfomance

    鋰鎳氧系列電極材料是當前鋰離子電池新一代正極材料的研究熱點之一，但是由於該系列材料存在著諸如制備困難、熱穩定性差、循環性能差等問題而不能實際應用，必須對其進行合成優化和性能改性。
  8. In chapter two, we fabricated r - ni - fe / al2o3 nanocomposites successfully by using ball - milling mixing method plus hot - pressing process. meanwhile, their microstructures are characterized by x - ray diffraction ( xrd ) analyser, transmission electron microscopy ( tem ), field emission scanning electron microscopy ( fe - sem ) and brunauer - emmett - teller ( bet ). the results indicate that ni - fe particles are homogenously dispersed in the matrix in the composites

    在第二章中，我們採用高能球磨混合方法加上熱壓燒結工藝，成功制備了ni - 20fe al _ 2o _ 3納米復合材料，並通過x射線衍射儀（ xrd ） 、透射電鏡（ tem ） 、場發射掃描電鏡（ fe - sem ） 、比表面孔隙儀（ bet ）對該復合材料的微結構進行了表徵。
  9. Characterization of ferric oxide nanocrystal prepared by thermal decomposition

    熱解法制備氧化鐵納米晶及其表徵
  10. 6 the zn3n2 is prepared on focus glass substrate at low temperature. and for the first time, a p - zno with a carrier density of 1017 ? cm - 3 is obtained by thermal zn3n2 in an oxygen ambient

    5 、用等離子體增強的化學汽相沉積的方法制備了zn3n2薄膜，首次通過熱氧化zn3n2的方法，制備出了受主型載流子濃度為1017cm - 3的p - zno薄膜。
  11. The photocatalytic activity of the samples was evaluated by the photocatalytic oxidation of nitrogen monoxide in the gaseous phase and the photocatalytic decolorization of methyl orange solution in the aqueous phase, respectively. the titania thin films on fused quartz were prepared by lpd method and then calcined at different temperatures

    用液相沉積法在石英玻璃上制備了二氧化鈦薄膜，並在不同的溫度下進行熱處理，用甲基橙水溶液的降解脫色評價二氧化鈦薄膜的光催化活性。
  12. The samples with smaller grain sides were obtained in our experiment, and the properties are corresponding with that of those samples prepared by melting method mentioned previously. several approaches can be proposed for further increasing the thermoelectric properties. preparation of the material with different compositional deviations availably controlled from stoichiometry is one of the ways to change the carrier concentration, and hence to optimize the value of power factor

    該方法獲取的塊體樣品的片狀顆粒的粒度遠小於熔煉法制備的樣品，樣品的性能也與熔煉法相當，如果能有效控制樣品的化學計量比，提高生成物的純度將會更大程度的提高材料的熱電性能。
  13. Bituminous mixtures - test methods for hot mix asphalt - specimen preparation gyratory compactor

    瀝青混合料.熱混瀝青的試驗方法.用旋轉式壓實機制備樣品
  14. Bituminous mixtures - test methods for hot mix asphalt - part 31 : specimen preparation by gyratory compactor

    瀝青混合物.熱混瀝青的試驗方法.第31部分:用旋轉式壓實機制備試樣
  15. Sicp / al matrix composites, with 5, 15 and 25 % volume fraction of sic particles, were prepared by vacuum hot - pressing sintering processing in this paper. based on mechanics properties, sem observation and energy dispersive x - ray analysis, the interface reaction phenomenon of sicp / al composites made by vacuum hot - pressing sintering, as well as the reinforcement and fracture mechanisms of this composite were analyzed. the dynamic responses of sipc / al composites were studied by a split hopkinson high - speed pressure bar impact system which strain rate was from quasistatic state strain rate ( 3. 3 10 - 3s - 1 ) to dynamic state strain rate ( 5. 2 103 s - 1 )

    本研究以武裝直升飛機防護裝甲材料為研究對象，採用真空熱壓粉末冶金燒結工藝制備了含sic顆粒體積分數分別為5 、 15和25的sic顆粒增強鋁基復合材料，結合其力學性能、掃描電鏡和界面微區能譜分析結果，分析了sic _ p al復合材料的真空燒結過程中的界面現象，以及材料增強和斷裂機理，並利用hopkinson高速壓桿沖擊實驗系統對其從靜態到動態（應變率為3 . 3 10 ~ （ - 3 ） s ~ （ - 1 ） 5 . 2 10 ~ 3s ~ （ - 1 ） ）的壓縮破壞響應進行了研究，分析了不同體積分數sic _ p al復合材料高應變率壓縮載荷下，材料的變形和微觀損傷機理，以及利用高速沖擊空氣炮測定了改復合材料制備剃度復合板的穿透性能。
  16. Peg assisted hydrothermal synthesis of zno nanorods

    輔助氧化鋅納米棒的水熱法制備
  17. The heat - reaction characteristics of ni / si and tin / ni / si structure and the regularity for forming the nisi film have been studied deeply and formed the excellent ni - salicide shallow junction diode

    文中對ni si和tin ni si的熱反應特性以及nisi薄膜的形成規律進行了詳細的研究。制備了優質的ni硅化物淺結二極體。
  18. Tio2 thin films with super hydrophilicity were deposited onto soda - lime glass using the spray pyrolysis method, and the films doped with different content of fe3 + or zn2 + were also prepared

    根據防霧易清潔玻璃的性能要求，利用噴霧熱解法，以透明載玻片為基板進行薄膜的制備。
  19. Hydrothermal synthesis and characterization of cu2 - doped sno2 nanoparticles

    2納米晶的水熱制備與表徵
  20. In this thesis, the relationship between environment temperature of photocatalysis reaction and photocatalytic activity of nanosize tio2 and nanosize ag - tio2 was studied

    研究了光催化環境溫度等因素對水熱制備的納米tioz和納米ag汀102的光催化活性的影響規律。
分享友人
分享到 Line

分享到臉書