熱力計算 的英文怎麼說

中文拼音 [rèlìjìsuàn]
熱力計算 英文
heat calculation
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 計 : Ⅰ動詞1 （計算） count; compute; calculate; number 2 （設想; 打算） plan; plot Ⅱ名詞1 （測量或計算...
  • 算 : Ⅰ動詞1 （計算數目） calculate; reckon; compute; figure 2 （計算進去） include; count 3 （謀劃;計...
  • 熱力 : [機械工程] heating power
  • 計算 : 1 （求得未知數） count; compute; calculate; reckon; enumerate 2 （考慮; 籌劃） consideration; pla...
  1. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  2. 3. on boiler retrofit, the calculation of fuel burning, the heat calculation of boiler inside structure and convection section, and the design of structure parameter of feed water heat exchanger are made. the flue gas channels " resistance calculation and the boiler strength verifying are also carried out. replacement of water cooling wall improves heat exchanging and decreases loss of heat radiant

    對鍋爐本體進行了燃料燃燒計算、爐膛結構熱力計算、對流受熱面結構熱力計算、鍋爐給水加熱器結構參數設計、煙道阻力計算及鍋爐元件強度校核等；改進了水冷壁布置使換熱效果更好，減少輻射換熱損失；改進對流段結構，更充分的利用爐膛出口煙氣余熱，提高熱效率；並且進行了煙氣阻力計算、熱效率計算和能量平衡測試，對改進后的稠油燃料和改進前進行了對比，燃燒狀況和熱效率有明顯改善。
  3. In order to apply in reality, this thesis has also given out the basic procedure of the micro - vortex - tube refrigeration device, and has car ried on heating calculation

    為了在實際中進行應用，本文還給出了微型渦流管製冷器的基本流程，並且進行了熱力計算。
  4. 2. design scheme of gravity heat pipe air pre - heater is proposed which fits the actual situation of injecting steam boilers. detailed heat calculation and design on heat recovery of flue gas is carrying out

    提出了採用適合於注汽爐實際工況的重力熱管式空氣預熱器的設計方案，對煙氣的余熱回收進行了詳細的熱力計算和設計。
  5. Especially, to solve the functional heated calculation, which is the core work of boiler project analysis, the dissertation contributes a sequential modular iterative algorithm by referring to the theory of process system simulation

    其中，本文基於過程系統模擬理論，對鍋爐方案分析活動中最為重要的功能性熱力計算提出了一種序貫模塊迭代的新演算法。
  6. For the limitation of the former soviet union boiler unit heating calculation standard methods in 1973 in the boiler furnace ， panel and platen superheater ， this paper puts forward the new methods of the boiler heating calculation

    分析了前蘇聯73年鍋爐機組熱力計算標準方法中爐膛、分隔屏過熱器和屏式過熱器計算方法的缺陷，初步提出鍋爐熱力計算新方法。
  7. In accordance with a boiler whose capacity is 1025t / h in a certain power plant ， this paper builds the heating calculation model of new method and the former soviet union method, finds the solutions to the model under the designed coal quality, compares the results with the design data, verifies and analyzes the new heating calculation model

    針對某電廠1025鍋爐機組，按照新方法和前蘇聯方法分別建立熱力計算模型，在設計煤質下對模型進行求解，將計算結果與設計數據進行比較，對新方法進行驗證和分析。
  8. This thesis will put forward a new design project that aimed at discussing the packing sets of natural - draft counter - flow dry cooling tower, which is the research and application of the spray nozzle. the content mainly includes the experimental study of the application of the jnx - 01 spray nozzle in cooling tower, as well as the heating calculation

    本文將針對自然通風逆流濕冷式冷卻塔中影響效率較大的淋水裝置提出設計改進方案，即旋轉式噴濺裝置的研究與應用，內容主要包括jnx - 01型節能旋轉式噴濺裝置及旋轉濺水碟式噴頭在冷卻塔上應用情況的試驗研究及熱力計算。
  9. Based on the investigation of the average heat load during heating period and non - heating period, the paper conducts the distribution of heat load, thermodynamical calculation and economic index calculation for the union operation of various heating units

    根據調查採暖期和非採暖期的平均熱負荷，對不同類型的供熱機組聯合運行進行了熱負荷的分配、熱力計算及經濟指標的計算。
  10. Puts forward an improved method based on the theory in which the enthalpy difference is considered as the driving force in heat transfer under wet cooling conditions and thinks that the method can halve the testing work, require less for the experiment devices and reach higher accuracy

    認為該方法遵循了焓差是濕工況下換熱推動力的規律，試驗工作量減少一半以上，對試驗裝置的要求降低，由試驗數據整理出的公式用於表冷器熱力計算完全可以滿足空調常用范圍內的要求。
  11. The calculation software, which is compiled by microsoft visual c + +, can calculate the characteristic parameters of water and steam more quickly and precisely than before. further more, it can adjust the thermal parameters automatically

    此軟體界面合理，水和蒸汽的參數計算準確，熱力計算速度快，參數自動調節功能強，能完成多方面的功能，很好的勝任了本文的研究工作。
  12. Establishing on the foundation of the project of " the monitoring state and maintenance assist support system of feed pump for 300mw unit, shiheng power plant, shandong ", this paper ' s content comprise on - line monitoring and thermodynamic calculation on small steam turbine for feed water pump, and supply the necessary data for feed water pump ' s performance analysis, trouble analysis and small steam turbine ' s performance analysis, optimization, heat stress calculation and tremble monitoring

    =本論文的內容是建立在「山東石橫電廠給水泵狀態監測與維修輔助支持系統」項目基礎上，涉及大型機組鍋爐給水泵驅動用小汽輪機進行在線監測和熱力計算，為給水泵的性能分析、故障分析以及小汽輪機的性能分析和優化、熱應力計算和震動監測提供必需的數據。
  13. In the text thermodynamics and heat transfer calculation of the no - pump libr absorption refrigeration were performed, and carried out the values of various state point, the heat load and the areas of each apparatus

    文中對無泵溴化鋰吸收式空調器進行了傳熱與熱力計算，給出了各個狀態點的參數和換熱面積。
  14. This paper introduces in detail both of them and attempts to have a development and research about the thermodynamic calculation of the small sliding pressure running steam turbine

    論文中對這兩種方法都有詳細的介紹，並嘗試性地對滑壓運行的小汽輪機的熱力計算方法進行了探討和研究。
  15. According to the thermodynamics theory of vapor compression refrigeration cycle, hfc - r134a is chosen as refrigerant fluid and the thermodynamics calculation of refrigeration system is accomplished, which is based on the table of r134a thermodynamics characteristics and estimate of portable refrigerator ' s calorific burthen

    本文根據蒸汽壓縮式製冷循環的熱力學原理，從小冷量、小體積的便攜式冷藏箱的熱負荷計算出發，以所選用製冷劑（ r134a ）的熱力性質表為依據，進行了製冷系統的基本熱力計算。
  16. This new technology changes from the traditional method by which the induced and compressor wheel separately are designed and produced to a new one by which the one - piece compressor is designed. on the basis of this new technology and the optimum blade profile, the performance of both the compressor and the turbocharger is largely improved. through the heating power calculation of the compressor, the analysis of the surge and the block of the compressor, the test - bed performance test of the turbocharger, the matching test of turbocharger and diesel engine, the propulsion test of the turbocharger on plateau condition, it is proved that the newly - designed compressor not only has high efficiency, but also improves the flow distribution in the high efficiency area so that the propulsion line can run through the high efficiency area

    主要內容包括：提出一種全新的壓氣機葉輪技術和概念，這種技術將傳統的導風輪和壓氣機分開設計、單獨加工改為整體設計、整體加工的單體葉輪；從增壓器與柴油機配機計算所得出的基本參數出發，通過對壓氣機進行熱力計算，確定壓氣機的基本結構參數；再對葉型以及葉輪輪廓與葉輪罩殼的配合間隙進行優化，對新設計的壓氣機進行喘振和堵塞分析；通過增壓器平臺性能試驗，驗證了新設計的壓氣機的性能水平得到了較大的提高，達到了提高增壓器的整體性能水平的目的；通過增壓器與柴油機配機試驗、以及增壓器用於高原條件下的牽引試驗，驗證了新設計的壓氣機不但具有高效率，還改善了高效率區的流量分佈，使牽引特性線貫穿高效率區。
  17. Based on the analysis of the forms and facilities of the scwr system, the status of scwr was investigated in the industry of printing and dyeing. two projects of scwr system were brought forward and the thermal economics of the scwr system was studied

    首先對印染企業的冷凝水回收進行調查研究，提出了兩種蒸汽冷凝水回收方案，對兩種回收系統進行了管路水力和熱力計算，確定了系統各點的熱力學參數。
  18. Part of content about fluidized bed thermodynamic calculation in the 《 layer and fluidized combustion thermodynamic calculation standard for industrial boiler 》 ( jb / dq1060 - 83 ) are discussed the computing equation of fly ash carbon content and the thermal equilibrium equation in the dense phase considering evaporation of water of unburned coal are given. the revise necessary is provided through calculating examples

    對jb / dq1060 - 83 《層狀燃燒及沸騰燃燒工業鍋爐熱力計算標準》中沸騰爐熱力計算的部分內容進行了探討，導出了沸騰層飛灰含碳量計算式和考慮未燃煤水分蒸發的沸騰層熱平衡方程，通過算例說明了修正的必要性。
  19. A part of content about fluidized bed thermodynamic calculation in the 《 layer and fluidized combustion thermodynamic calculation standard for industrial boiler 》 ( jb / dq1060 - 83 ) are discussed the computing equation of fly ash carbon content and the thermal equilibrium equation in the dense phase considering evaporation of water of unburned coal are given. the revise necessary is provided through calculating examples

    對jb / dq1060 - 83 《層狀燃燒及沸騰燃燒工業鍋爐熱力計算標準》中沸騰爐熱力計算的部分內容進行了探討，導出了沸騰層飛灰含碳量計算式和考慮未燃煤水分蒸發的沸騰層熱平衡方程，通過算例說明了修正的必要性。
  20. Development of the thermodynamic calculation visual software of pulverized coal boiler

    煤粉鍋爐熱力計算可視化軟體的研製
分享友人
分享到 Line

分享到臉書