熱加工汽油 的英文怎麼說
中文拼音 [rèjiāgōngqìyóu]
熱加工汽油
英文
thermal gasoline-
Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning
通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。It is widely in sectors of petroleum, chemical engineering, power, printing and dyeing textile for heating and steaming system, condensation water recycling and over heating steam projects
該閥廣泛用於石油、化工、電力、紡織印染、等行業的各種蒸汽加熱設備，蒸汽管網、凝汽管網、凝結水回收工程和低過熱蒸汽工程。Because of the difference of production technology and operation condition, the jacket heating type divides electric bar heating, steam heating, conduction oil cyclic heating, and the shaft seal equipment divides stuffing seal and mechanical seal, and mixing type divides anchor type, paddle type, worm wheel type, pusher type and frame type
由於用戶因生產工藝操作條件不盡相同，夾套加熱型式分為電熱棒加熱蒸汽加熱導熱油循環加熱，軸封裝置分為填料密封和機械密封，攪拌型式有錨式漿式蝸輪式推進式和框式。Abstract : the causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
文摘:分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上The causes for low efficiency of the heater in no. 2 crude unit of jpc refinery are described and analyzed including water leaking of steam soot blower, dew point corrosion caused by steam, soot deposits in convection chamber owning to poor soot blowing, high flue gas temperature, no heat recovery of flue gas, and poor performance of insulation lining, etc. by using sonic soot removing system, flue gas recovery system, spray coating of fiber and rock wool, as well as adjustment of flow scheme accordingly in the technical revamping. the dew point corrosion is completely eliminated, the insulation performance is improved, the heat loss is reduced by 1. 25 %, the flue gas temperature is reduced to about 170, and the heater efficiency is increased from 83 % to more than 90 %
分析了金陵石油化工公司煉油廠二套常減壓裝置加熱爐存在的因蒸汽吹灰器漏水，蒸汽引起露點腐蝕及吹灰效果差造成對流室積灰，排煙溫度高，煙氣熱量未回收利用以及爐子保溫襯里效果差等問題，提出採用聲波除灰系統、煙氣回收系統、纖維噴塗和巖棉噴塗及相應的流程調整等改造措施.測定結果表明，本次技術改造解決了因蒸汽吹灰器漏水所造成的露點腐蝕問題，提高了保溫效果，減少散熱損失1 . 25 % ，排煙溫度降至170左右，裝置的爐效率由83 %左右提高到90 %以上Rhodia engineering plastics provides a new range of high viscosity technyl nylon 66 and 6, specially designed to be compatible with the blow - moulding technology. particularly suitable in the automotive industry, they are used to manufacture complex - shaped technical parts such as air ducts, water pipes for cooling and heating systems and fuel filler tube
羅地亞工程塑料提供一系列高粘度的泰克尼尼66和尼6 ，它們為吹塑技術特別設計，適合應用於汽車工業中製造形狀復雜的技術零部件，如排氣管，製冷及制熱系統水管和加油管。The 1owing material balance method, a new method for reservoir engineering dynamic analysis, is presented and applied to the well test analysis of heavy oil steam stimulation, calculating the heating radius and formation contaminant factor in this paper
摘要介紹了一種新的油藏工程動態分析方法流動物質平衡方法，並將該方法應用於稠油蒸汽吞吐試井分析，計算出加熱半徑和地層污染系數。The conclusions reached are as follows : 1. the saturated temperature of refrigerant - oil mixture is higher than that of pure refrigerant at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixture, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture
得出以下結論： 1 、相同壓力下，製冷劑hc600a含油混合物的飽和溫度高於純工質的飽和溫度，這個溫度差，在就是文中稱為的製冷劑含油混合物的過熱溫度，它隨混合物質量含汽率、含油濃度的增加而增加，而飽和壓力對過熱溫度的影響不大。The conclusions reached are as follows : ( 1 ) the saturated temperature of refrigerant - oil mixture is higher than that of pure refrigerant at a same pressure. the temperature difference, which is called superheat temperature of refrigerant - oil mixture, increases as the oil concentration and the vapor quality are increased at a certain saturated pressure and pressure has negligible effect on the superheat temperature of the mixture
得出以下結論： （ 1 ）製冷劑hc290含油混合物的飽和溫度高於相同壓力下純工質的飽和溫度，這個溫度差，也就是文中所謂的製冷劑含油混合物的過熱溫度隨混合物質量含汽率、含油濃度的增加而增加，而飽和壓力對過熱溫度的影響不大。Specialized in producing various connection posts of petrol machines and aluminum alloy castings and so on, our company has more than 40 sets of nonferrous metal casting machines and 100 sets of mechanical processing machines, including many advanced machines such as lijing frozing casting machines and japan ( zhengying ) successive smelting and retaining stoves and burning heat treatment stoves
公司專業生產各種通用汽油機連桿、輪轂及汽車鋁合金鑄件等產品，擁有有色金屬重力鑄造設備40餘臺（套）和機械加工設備100餘臺（套） ，包括力勁冷寶壓鑄機、日本（正英）連續熔解保持爐和燃氣熱處理爐等先進設備。Chapter 5 discusses two kinds of learning in both knowledge creation and technical innovation : learning inward and learning outward of firm, and concludes there is a large gap between china and foreign countries in knowledge density of industries. for chinese industries, learning outward of firms have more significant effects on ircie than learning inward of ones. to a great extent, those industries which ircie are high depend on technical knowledge outside of firms, on the other hand, ones based on learning inward are low in ircie
論文數據來源於國家統計局和科技部編纂的《中國科技統計年鑒》 （ 1991 ? 2000 ） ，扣除數據缺失的其他礦采選業和武器彈藥業，研究樣本包括煤炭采選業、石油和天然氣采選業等6個採掘行業，食品加工業、食品製造業等29個製造行業，以及電力蒸汽熱水的生產及供應業等3個公用事業行業，共計38個工業行業。However, with the demand for environmental prelection inhancing, the emission which had not been taken into account is noticed now. in order to improve heater emission and performance and to meet the full needs of users and the development of futurel automobile environment pretection, the paper which uses qn700 air oil - heater as the research objective, theoretically analyzes, experimentally do researches, searches for the main emission source, and brings up efficient improving methods based on the process of combustion x the characteristics of exhaust. the principle of operation
為了使加熱器的燃燒排放性能更加完善，充分滿足用戶的使用要求和未來汽車環保要求發展的需要，本論文以國產大型客車廣泛使用的qn700型空氣燃油加熱器為研究對象（其燃燒結構和工作原理具有一定的典型性） ，針對這一典型的國產空氣燃油加熱器的燃燒過程、排放特性以及工作原理進行理論分析和試驗研究，找出主要污染源及其產生機理，並在此基礎上根據現有的結構提出有效的改進方案。This paper presents the calculation formula for determination of reasonable soak time and heated radius at end of soaking by analysis of changes of oil layer and steam energy during soaking period, based on basic theories of reservoir engineering and heat transfer
應用油藏工程、熱傳遞基本理論剖析了燜井過程中油層和蒸汽的能量變化，推導出確定合理燜井時間的計算公式和燜井結束后加熱半徑的計算公式。As an equipment for heating bus, truck and engneering vehicle chamber and preheating engine, oil heaters have been largely used all over the world
汽車空氣燃油加熱器作為客車車室、貨車駕駛室和工程車輛的取暖裝置以及預熱發動機的主要設備，已被國內外廣泛採用。分享友人