熱容比 的英文怎麼說

中文拼音 [rèróngbǐ]
熱容比 英文
gamma
  • 比 : Ⅰ動詞1 （比較; 較量高下、 長短、距離、好壞等） compare; compete; contrast; match; emulate 2 （比...
  1. Also the theoretical basis of the method have been checked through simple deducing simulation and the influences of various physical parameters on the method have been studied. it is shown that the method is theoretically reliable for the production oil wells without very high production rate and is more suitable in field production for oil wells ( i ) in area with bigger geothermal gradient ; ( ii ) producing fluids ( oil and water ) with distinguish thermal characteristics ; ( iii ) producing oil with lower heat capacity or water with higher heat capacity ; ( iv ) with good surface measurement accuracy, as well as the method h as certain requirements on the accuracy of the temperature and flowmeter logs sensors

    就該產出剖面方法的理論基礎進行了簡單的正演模擬和可能影響該方法的各項物理參數進行了全面的考察，結果表明，該方法對于非高產的生產油井來說在理論上是可靠的，在實際生產中適合於（ 1 ） 、油井所在地區地溫梯度較大的油井； （ 2 ） 、油水熱特性差別較大的油井； （ 3 ） 、油比熱容值偏低水比熱容值偏高的油井； （ 4 ） 、井口計量精度較高的油井，並且對井溫測井和流量測井的傳感性精度有一定的要求。
  2. Testing methods for specific heat capacity of plastics

    塑料比熱容的測試方法
  3. Specific heat capacity at constant pressure

    定壓比熱容量
  4. What is the specific heat of the metal in the pan ?

    這只鍋的金屬的比熱容是多少？
  5. Specific heat depends not only on the material in question but also on the external conditions of its heating.

    比熱容不僅取決于所研究的物質，而且依賴于加熱的外部條件。
  6. The specific heat of a material is the amount of heat that must be added to a unit mass of the material to raise its temperature by 1 degree.

    物質的比熱容是使單位質量的物質溫度升高1度所須加給的熱量。
  7. 05. 02 test method for specific heat of liquids and solids

    測定液體和固體比熱容的試驗方法
  8. We made use of wheatstone bridge to control ratio of heating power between the samples, thus, it enable to control and measure the differential heating power accurately. consequently, it improves sensitivity of the system. the resolution of the measurement can reach from 1 : 1000 to 1 : 10000 or better in comparison with the traditional differential technique

    我們測量了聚苯胺及其摻雜鹽酸后在1 . 8k至45k的熱容，利用聲子分形子模型來處理非晶態對比熱的貢獻，對獲得的數據進行處理，發現eb和es的比熱數據均不符合德拜理論，超出德拜模型的比熱來源於非晶態的貢獻。
  9. The interior size and the calorific capacity of the borehole are much smaller, moreover the temperature change is slow, so usually we can neglect the influence of calorific capacity but to consider according to the heat transfer in steady state process, thus we can establish one - dimensional and the two - dimensional thermal resistance model in the borehole

    而在鉆孔內部，包括回填材料，管壁和管內傳熱介質，與鉆孔外的傳熱過程相比較，由於其幾何尺寸和熱容量要小得多，而且溫度變化較為緩慢，因此通常可以忽略其熱容量的影響而按穩態傳熱過程來考慮，建立了鉆孔內的一維和二維的熱阻模型。
  10. Specific heat capacity at constant volume

    定容比熱容量
  11. Test methods of thermal diffusivity, specific heat capacity, and thermal conductivity for fine ceramics by laser flash method

    激光閃爍法測定精細陶瓷的熱擴散率比熱容量熱傳導率試驗方法
  12. The photosynthetic characters of super - high - yield rice ( oryza sativa ), its photoinhibition and genetic law of photosynthetic traits and screening of high photosynthetic efficiency materials etc. were reviewed in this paper

    摘要綜述了超高產水稻的光合特性、光抑制、光合性狀的遺傳規律和高光效材料的篩選等內容，比較詳細地介紹了光抑制部位及其表現，光抑制的原因以及光抑制中熱耗散的可能途徑及作用等。
  13. The properties of nd : glass rod lasers in the heat capacity operation, including the temperature and stress distributions, are simulated and compared with the conventional pumping and cooling scheme

    摘要對釹玻璃棒狀激光器在熱容型的運行方式下的特性，包括溫度和應力分佈作了分析，並和常規抽運和冷卻方式下棒橫截面的溫度和應力分佈作了比較。
  14. With high temperature and high pressure in nozzle of wind tunnel, the effect of variable specific heat on nozzle design must be considered

    本文針對超音速、高超音速噴管內馬赫數、溫度變化劇烈的特點，研究了比熱容變化對設計噴管型面產生的影響。
  15. The principles and its system error analysis of measuring specific heat ratio of the air

    空氣比熱容比實驗的原理和系統誤差分析
  16. Standard test method for determining specific heat capacity by differential scanning calorimetry

    用差示掃描熱量測定儀測定比熱容量的標準試驗方法
  17. The aspects which i specified in the draft versions of my thesis, for example, building energy performance, energy conservation models, relationship between building energy efficiency and energy conservation, description for keeping natural environmental conditions within the building, address the following problem of 1992 the governments signed the united nations framework convention on climate change ( fccc ) at the earth summit in rio de janeiro, buildings impact on natural resources and environment, to use “ ecological footprint ” concept and measuring for assessing the impact on resources and environment from use of energy in buildings, method for obtain local climate weather profiles, features of nz weather and how the weather profile associating with indoor conditions, occupants ' interface with indoor thermal conditions, history of nz building energy conservation, operation scheduling technique, analysis of nature lights and energy saving, hvac modeling, doe2 simulation methodology, layout of the figures, tables, and contents, conclusions and so on are taken as her group ' s own contents and going on research topics

    在我的畢業論文草稿里寫下的內容，比如：建築耗能運行，節能模型，建築內部的能效比和節能的關系，表述保持建築物內部的自然環境，提出1992在里約熱內盧地球高峰會議后紐西蘭政府簽署了聯合國fccc協議后的追蹤問題，建築耗能對環境和自然資源的沖擊，使用"生態腳印"的概念來評價建築耗能對自然資源和環境的沖擊，取得天氣剖面圖的方法，紐西蘭的氣候特點及天氣剖面同室內狀況的聯系，建築物內的人員對室內熱力環境的干預，紐西蘭的建築節能史，建築用能模擬運行時刻表編製法，對紐西蘭自然採光和節能的分析，建立暖通空調用能模擬和doe2模擬方法，論文內容，表格和布置，及得出的結論等等，都被這一群人當作他們自己的在使用，以及作為繼續進行的研究課題在使用。
  18. Specific heats of various inorganic materials

    各種無機材料的比熱容
  19. Test method for mean specific heat

    纖維增強塑料平均比熱容試驗方法
  20. Yeap brand water - storage electric warming appliance is manufactured by the sealing combination of energy - storage medium with high ratio of thermal capacity, high - grade medical plastic film and high strength compound fiber

    易普牌貯水式電暖寶是由高熱容比儲能介質與高級醫用塑膠膜、高強度復合纖維有機地密封結合構造而成。
分享友人
分享到 Line

分享到臉書