熱彈效應 的英文怎麼說

中文拼音 [rèdànxiàoyīng]
熱彈效應 英文
thermoelastic effect
  • 彈 : 彈名詞1. （彈子; 小球形的東西） ball; pellet 2. （內裝爆炸物, 具有破壞和殺傷能力的東西） bullet; bomb
  • 效 : Ⅰ名詞（效果; 功用） effect; efficiency; result Ⅱ動詞1 （仿效） imitate; follow the example of 2 ...
  • 應 : 應動詞1 （回答） answer; respond to; echo 2 （滿足要求） comply with; grant 3 （順應; 適應） suit...
  • 效應 : [物理學] effect; action; influence
  1. Third, on the base of expatiating on experimental research method and theoretical research method of joints, the paper points out two kinds of valid methods, which are used to analyze the tube joints stress of dendriform structure by making use of semi - analytical method and inelastic large deflection finite element analysis method, confirms to apply the evaporative pattern casting process as the facture method of dendriform structure cast joints, and detailed dissertates the casting theory, casting process, generation cause and prevention measure of casting flaws, heat treatment method and inspection standard about cast steel joints

    然後在闡述樹狀結構節點實驗研究方法和理論研究方法的基礎上，提出了利用半解析法和彈塑性大撓度有限元法兩種有效分析樹狀結構管節點應力的方法，並給出兩種方法的詳細表達式及它們各自的優缺點。通過對鑄鋼件常見製作方法的介紹，確定了採用消失模法作為樹狀結構鑄鋼節點的製作方法，並詳細論述了用消失模法製作鑄鋼節點的鑄造原理、鑄造工藝、鑄造缺陷產生的原因及防治措施、鑄鋼節點的熱處理方法以及檢驗標準。
  2. An isotropic viscoelastic model coupled with hydrothermal effects

    含濕熱效應的各向同性耦合粘彈模型
  3. You should follow the installation instructions for the luminaires, such as installing away from combustible surface ( wall paper, wooden false ceiling ), allowing sufficient room for heat dissipation ( particularly luminaires fitted with tungsten halogen lamps ), ensuring effective earthing connection ( such as adding star and spring washers at the earth terminal ), and adopting proper anchorage to support its weight

    燈飾應按照指示安裝，注意要遠離容易燃燒的表面（例如墻紙、木製假天花） ，預留足夠的散熱空間（尤其是裝有鎢絲鹵燈的燈飾） ，確保有效接地（例如在接地終端加上菊花介指和彈弓介指） ，並因應燈飾的重量，選用適當的安裝方法（例如大型的吊燈，須選用拉爆螺絲等） 。
  4. The thermoelastic problem of a point heat source outside an elliptical inhomogeneity is studied, with the complex potentials being obtained

    求解了橢圓夾雜基體中的點熱源效應，獲得了熱彈性場的復勢解答。
  5. The results demonstrate that the theory predicted values of compression, bulk modulus, linear expansion, and thermal expansive coefficient of compressed solids are very agreement with the corresponding experimental data. in summary, the error with respect to theory prediction and its causes are pro bably analyzed in detail. the discussion suggests that the function of the phenomenological short - distance repulsive force constant a ( v ) and approximation for anderson - griineisen parameter 5t ( v ) proposed in this paper are valid and applicable in high pressures ( up to loogpa ) and high temperatures ( from debye temperature 0d to melting temperature tm ) for many types of solids

    在本文最後一節，為了驗證固體在等壓過程中anderson grhneisen參量乓與體積膨脹的唯象假設：乓久w兀的有效性，及由此假設而推導出來的等壓態方程的廣泛應用性，本論文主要針對十六種堿金屬鹵化物、三種堿性氧化物、三種硅酸鹽礦物質的線膨脹八n 、體積熱膨脹v vo （ n 、熱膨脹系數a （ n 、體積彈性模量肘d等隨溫度的變化作了理論上的預測，且與相應的實驗數據作了比較與分析
  6. ( 2 ) on the basis of continuity equation, momentum conservation equation, energy conservation equation, and substantial equation, coupled thm governing equations are derivated with giving up the assumption of local thermal equilibrium, adopting thermal elasto - plastic constitutive relation, taking the effect of temperature gradient on groundwater seepage ( analogous to soret diffusion ) and the effect of viscous dissipation of groundwater on temperature field of rock mass into account

    （ 2 ）根據連續性方程、線動量平衡方程和能量守恆方程以及相應的物性方程推導了飽和巖體溫度場-滲流場-變形場三場耦合作用控制方程組。在推導控制方程組時舍棄了「局部熱平衡」假設，採用了熱彈塑性本構關系，考慮了溫度梯度對地下水滲流的影響（類soret效應）以及地下水的粘性耗散對巖體溫度場的影響。
  7. The model is solved with the finite difference method, the simulation software is organized to simulate the transient thermal response of the front region of projectile wing such as those launched by electrothermal chemical guns

    採用有限差分法進行數值求解，並編制了較為通用的模擬軟體，用於模擬諸如由電熱化學炮發射的高超聲速穿甲彈彈翼前緣的瞬時熱效應。
  8. The missile with its radome is at high temperature during the entrance. due to aerodynamics heating process, the high temperature cause air ionization and ablation of the radome, so the radome is at unsymmetrical heat environment, its electrical properties vary with different parts of the radome

    導彈在再入過程中，由於空氣動力加熱效應，引起空氣電離和天線罩表面被燒蝕，因此，天線罩處于不對稱熱環境中，它各部分的介電性能不同。
  9. Effect of smoke scren wobble on ir imaging guided missile performation

    煙幕的湍流效應對熱成像制導導彈性能的影響
  10. By analyzing the relation between the refractive index and the temperature and the stress field of the optical window in the aero - dynamic environment, according to the thermal - optical effect and the elasto - optical effect, we obtained the relationship of the index - of - refraction and temperature and stress, and explored the further study method of the aero - optical effect

    摘要首先從熱光效應和彈光效應的角度，分析了飛行器在大氣層內飛行時，在氣動熱環境中的材料折射率與溫度場和應力場的關系，得出了溫度和應力對材料折射率的影響關系式，並進而探索氣動光學效應下一步的研究方法。
  11. Taking into account thermal and non - newtonian effects of the lubricant, this paper has theoretically investigated elastohydrodynamic lubrication of involute spur gears, and achieved the pressure distribution, film shape, temperature distribution and the values of the friction coefficient and its varying law along the line of action of gear transmission

    本文在考慮了潤滑劑的熱效應和非牛頓效應后，對漸開線直齒輪的彈流潤滑問題進行了理論研究，獲得了齒輪傳動的壓力分佈、溫度分佈、油膜形狀和齒面摩擦系數的取值范圍及其沿齒輪傳動嚙合線的分佈規律。
  12. The electroelastic interaction of dislocation, inhomogeneity and interior defects is a greatly significative subject in the fields of solid mechanics and materials science

    復合材料中位錯與夾雜及內部缺陷之間的電彈干涉效應問題，是當前固體力學與材料科學研究領域的前沿熱點課題。
  13. For the polymer showing time - dependent character in many situations, the viscoelasticity should necessarily be taken into account in the general model. further, as the conventional j integral is no longer valid for hydrothermal materials cases, investigations on new energy - type fracture criter ia are specifically needed

    此外，在含濕、熱效應的高聚物材料中，傳統的粘彈性或彈性材料的斷裂判據不再適用，所以，對該問題進行研究也是十分必要的。
  14. Thermal residual stresses in short fiber reinforced metal matrix composites ( sfrmmc ) can reach a high level and have a significant effect on the mechanical properties of composites. in this paper, three dimensional elastoplastic finite element analyses were used to study the thermal residual stresses in sfrmmc and its effect systematically. with the interfacial property, fiber ' s orientation and reciprocity of fibers considered, the thermal residual stresses in - al2o3 / al - 5. 5mg, - al2o3 / al - 5. 5zn and - al2o3 / al - 12si alloy composites were calculated and analysed

    本文在分析計算中綜合考慮了界面性能、纖維位向以及纖維間相互作用的影響，分別採用單纖維模型、雙纖維模型和斜向纖維模型，對- al _ 2o _ 3 al - 5 . 5mg 、 - al _ 2o _ 3 al - 5 . 5zn和- al _ 2o _ 3 al - 12si三種al合金基復合材料的熱殘余應力進行了計算和分析；對存在熱殘余應力時復合材料的應力?應變曲線進行了模擬；還基於能量等效原理的有限元方法，考慮了熱殘余應力及纖維位向的影響，推導了短纖維增強金屬基復合材料彈性模量的預測公式。
  15. Based on the heating treatment control system of a spring steel - wire production line in a factory, hubei province, the paper deals with the design of fully automatically monitoring system across its manufacturing process. through research of parameters of temperature control during the period of heating, annealing and tempering in steel wire manufacturing process, the corresponding composite intelligence fuzzy controller is designed. in light with the way of fast heating, a composite intelligent fuzzy controller combined with on - off control & pi control is set up

    本文以湖北某鋼絲繩廠彈簧鋼絲熱處理生產線控制系統為依託，論述了整個生產過程的監控系統的設計，通過對該類鋼絲生產中的快速加熱過程、退火、回火等過程中的溫度控制參數的研究，設計了相應的智能型復合模糊控制器，根據快速加熱過程的實現方式，對于快速反應的被控對象，給出了以模糊控制為基礎的結合開關控制、 pi控制的快速升溫，且不超調的一種智能型復合模糊控制器，對于退火、回火等工藝過程，採用電加熱方式，該類工藝過程作為控制對象屬于具有純滯后的大慣性系統，作者設計出模型預測自適應模糊控制器，並對所設計的控制器進行計算機模擬實驗，取得了滿意的效果。
分享友人
分享到 Line

分享到臉書