熱性能測試 的英文怎麼說
中文拼音 [rèxìngnéngcèshì]
熱性能測試
英文
thermal performance test-
Presents its principle and tests its performance, and the results show that it has larger dehumidifying capacity per unit electric power
介紹了熱管調溫除濕機的工作原理並對所開發的熱管調溫除濕機進行了各種性能測試,結果表明熱管調溫除濕機具有較大的單位電能除濕量。The structures and characteristics of several graphite samples are measured by means of powder x - ray diffraction ( xrd ), brunauer - emmer - teller ( bet ) surface area measurement, inductively coupled plasma ( icp ) spectroscopy, particle size analysis and electrochemical measurements. the effects of origin, structure, impurity, particle size, specific surface area of carbon materials on the electrochemical characteristics are studied. a synthetic graphite with abundant resources, low cost and favorable performance is determined as the raw material for modification of graphite
採用xrd 、 bet 、 icp 、激光粒徑分析及電化學性能測試等方法,對國內外多種典型石墨樣品的結構與性能進行比較,研究石墨材料的來源、晶體結構、雜質含量、顆粒大小、比表面積等因素對其充放電性能的影響,確定一種性能較好、價格低廉、來源廣泛的普通人造石墨粉作為熱處理與摻雜改性、以及復合結構炭材料研究的原材料。Specifications and testing method of thermal performance for passive solar houses
被動式太陽房技術條件和熱性能測試方法Method of testing to determine the thermal properties of insulated heating tubes hot water circulation procedure
測定隔熱管熱性能的試驗方法Testing method for the heat characteristics of firewood stoves
民用柴爐柴灶熱性能測試方法The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine
用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌:用xrd進行原料物相分析,及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度;用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性;用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化;用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試;採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定;用萊次偏光顯微鏡( pm )測試固體潤滑劑的硬度;用材料試驗機測試固體潤滑劑的抗壓強度等。Fesi2 - based semiconductors have been studied due to its good performance, low cost and potential application in power generation using waste heat. state - of - the - art techniques such as levitation melting, rapid solidification and hot uniaxial pressing ( hup ) were used for sample preparation in the present work. the phase transformation, micro structure and transport properties of the materials have been analysed with xrd, sem / edx, raman spectroscopy as well as thermoelectric characterization
在綜合評述國內外熱電材料研究新進展的基礎上,本文以懸浮熔煉、快速凝固和單軸熱壓等制備工藝為技術特徵,以mn或al摻雜fesi _ 2基合金為研究對象,採用xrd 、 sem / eds 、 raman光譜以及材料熱電性能測試等分析表徵手段,系統研究相變過程、微觀結構特徵及其對材料熱電性能的影響。Testing method for the thermal characteristic of heatable brick bed together with firewood or straw stoves
民用炕連灶熱性能測試方法Application of image processing in infrared thermal imager testing
圖像處理方法在紅外熱像儀性能測試中的應用The research on the properties of the copper nanoparticles / paraffin thermosensitive composite materials reveals : the thermal sensitivity and the thermal expansion are " aried by the cempress moulding in heat condition with the change in density ; the thermal sensitivity is varied by the mechanical milling with the change in particle shape and particle dimension ; the mass ration of copper and paraffin in the composite materials also affects the thermal sensitivity, the thermal expansion and the thermal stability with the change in copper nanoparticles and paraffin interface
對復合顆粒進行壓力成型后制備的復合材料進行性能測試分析表明:熱壓成型工藝通過改變復合材料的緻密度來影響材料的熱敏性和熱膨脹性。高能球磨工藝主要通過改變球磨時間使銅粒形狀和粒徑發生變化來影響復合材料的熱敏性,以及改變銅粉和石蠟的質量比使納米銅粒和石蠟的復合界面發生變化來影響材料的熱敏性、熱膨脹性和熱穩定性。Household electric thermal storage room heaters - methods for measuring performance
家用儲熱式房間電暖器.性能測試方法Abstract : based on the toughing, comfort and so on, the raw material, weave construction of protective fabrics are choosed, and some kind of fabrics with different weave construction and density were designed. the experiments show that the fabrics designed were better than the cotton canvas which was used to the protective work garmants now
文摘:從防護服的功能性、耐穿耐用、舒適性等因素出發選擇防護服織物的原材料、織物組織結構等,開發研製了幾種不同組織、不同密度的阻燃防熱防護服織物.通過性能測試,並與目前作為防護服用棉帆布相比較得知,所開發的織物各項性能較優良Xps showed that there were much chemical absorbing water on the ti _ ( 2 ) film surface which mainly existed in form of - oh, and the contents of - oh was increasing with the annealing temperature. hydrophilic property became better with the annealing temperature ; the essential relation between the changing of contact angle and light - induced - electrons and light - induced - cavities was studied in details. the photocatalysis of samples without heat treatment was very bad, but that of samples after heat treatment was much better
Xps的分析表明:試樣的表面含有大量的化學吸附水,主要以羥基的形式存在,隨著熱處理溫度的升高,吸附羥基的含量在增加;親水性能測試表明:隨著氧氣分壓的變化,其親水性能變化不大,隨著熱處理溫度的增加,試樣的親水性能在變好,並從理論上解釋了親水性能光照前後變化和光生電子?空穴對之間的本質關系。Whole scheme of frame design of test - bed is proposed as : the host fanner supply the firebox the once and twice air required by diesel oil ' s burning and the cooling air ; the export parameter of the test - bed is varied by the adjust of the flux of air and diesel oil. and the air flux is varied by adjusting the rev of the fanner adjusted by transducer and the corner of the fan inlet adjusted by step motor. the quantity of oil is varied by adjusting the oil valve adjusted by step motor ; the measurement of the air flux in the test - bed adopts the method of fanner dynamics performance test in the nation criterion
確立了實驗臺結構設計方案:主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量;利用變頻器調節主風機轉速、用步進電機調節風門開度來調節風量,用步進電機調節回油閥開度來調節供油量,從而實現對模擬實驗臺出口煙氣熱流量的調節;實驗臺的流量測量採用風機動力性能測試標準中測流量方法等。Whole scheme of frame design of testing flat is proposed as : the host fanner supply the air required by flamer ’ s burning and cooling, the export parameter of the flat varies by different rotate speed of the fanner 、 angle of the fan inlet and the quantity of oil, the measurement of flow in the testing flat adopts the method of fanner dynamics performance test in the nation criterion
確立了實驗臺結構設計方案:主風機為燃燒器提供燃燒所需的一次、二次進風量及冷卻風量;模擬實驗臺出口煙氣熱流量是通過調節風機的轉速、風門開度及燃油量來改變;實驗臺的流量測量採用風機動力性能測試標準中流量方法等。An experimental apparatus has been set up start from scratch and some experiments have been done to study the heat transfer characteristics of the ice - on - coil tank. the comparison of the theoretical predictions and the experimental data has been made and the disagreements between them are also analyzed
建立了導熱塑料蓄冰盤管傳熱性能測試裝置,測試了結冰和融冰過程中載冷劑的進出口溫度、流速和結冰或融冰時間的關系,通過實驗結果與理論計算的比較和誤差分析,驗證了建立的數學模型的合理性。Standard guide for testing the thermal properties of advanced ceramics
高級陶瓷熱性能測試的標準指南The proper amount of mmt could improve the mechanical and thermal properties of the nanocomposites
多項力學性能和熱性能測試結果表明:適量mmt的加入使復合材料的性能有不同程度的提高。Finally, it introduces a lot of things about the measurement of the optical source ' s thermal performance, such as the condition, the principle, the steps, the parameter and the aim of this measurement
最後介紹了光源熱性能測試的測試條件、測試原理、測試步驟、測試參數和測試目的。Moreover, tested results of heat storage and release indicate that the time of thermal - energy storage and release of the composite pcm containing 80 % of paraffin decreases respectively by 69. 7 % and 80. 2 %, as compared with that of paraffin
儲(放)熱性能測試結果表明,含80 %石蠟的復合相變儲熱材料其儲熱時間比石蠟減少69 . 7 % ,放熱時間減少80 . 2 % 。分享友人