熱控管 的英文怎麼說

中文拼音 [kòngguǎn]
熱控管 英文
thermister
  • : 動詞1 (告發;控告) accuse; charge 2 (控制) control; dominate 3 (使容器口兒朝下 讓裏面的液體慢...
  • : Ⅰ名詞1 (管子) pipe; tube 2 (吹奏的樂器) wind musical instrument 3 (形狀似管的電器件) valve;...
  • 控管 : granular access control
  1. Pre - data gathering module achieves the collection and communication of sixteen - route temperature signal. speed measuring and controlling module realizes the control of refolw soldering transfer speed by manipulating transducer. on - off outputting module fulfills calefaction control of calefaction tube by solid state relay. above position operator software programs by delphi, and realizes pid parameter automatic timing and no - oversnooting temperature control. software has friendly interface, convenient operation, complete functions

    前置數據採集模塊完成16路溫度信號的採集和通訊;速度測量模塊與速度制模塊通過制變頻器來調節迴流焊的傳輸速度;開關量輸出模塊通過固態繼電器對加進行制;上位機軟體採用delphi編程,實現了pid參數自整定以及無超調的溫度制。
  2. Second, the starting and stopping behaviors under disturbed condition are analyzed and calculated by using the dynamic concentrative parameter model, which gives some advice to better prescribe refrigeration system and set theoretic foundation for carrying out automatic control of refrigeration system. third, the normal running process is analyzed and calculated by means of rational matching theory, which gives some advice on how to better understand the parameter change under steady state and the affection of inlet - parameter on evaporator. fourth, the simulation software with dynamic characteristic is designed, which can be applied to calculate thernio - parameter of cryogen, air humidity and frost thickness under different initial and boundary conditions, and to carry out dynamic simulation under conditions of dryness, wetness and frostiness, at the same time, to achieve detection and simulation at any stage from starting to stopping

    本文的主要內容如下: 1 )對翅片蒸發器結構特點進行分析,選取適當的微元制體,就干、濕和霜工況下對每個微元分別進行傳傳質分析,基於經驗關系式確定霜的有關參數,對于霜工況下的霜生長建立模型,經適當假設,運用質量守恆、能量守恆和動量守恆方程建立適合動態模擬的蒸發器數學模型,為系統模擬奠定基礎; 2 )對蒸發在大擾動下的開、停機過程,運用動態集中參數模型進行分析和計算,為更好地描述製冷系統運行的全過程奠定基礎,同時也為製冷系統實現自動制提供一定的理論基礎; 3 )對蒸發器正常運行過程,運用動態分佈參數和參數間定量耦合的觀點來分析和計算,為更好地了解穩態工況下各點參數的變化情況及各入口參數對蒸發器動態特性的影響即蒸發器性能對各參數變化的敏感性; 4 )編寫翅片蒸發器動態特性模擬計算程序,可以計算不同邊界條件和初始條件下的製冷劑力參數、空氣溫濕度和霜厚度分佈場,實現對翅片蒸發器在干、濕和霜工況下的動態模擬。
  3. With the rapid increase of society, it has been become more and more anxious requirement of security for people " s life. how we use techniques of the modern cybernation, and computer networks, and manage of the information system, which build our new security automation system will come into view one of important and active area of research

    安全防範系統是智能建築的一個子系統,隨著社會的發展,人們對安全保障的需求也越來越高,如何利用現代制技術、網路技術、計算機信息理技術構築新一代的安全防範系統是人們關注的點之一。
  4. For the manifold of sedan engine, the hest thermal fatigue properties can be obtained by keeping the percent of vermicular graphite at about 50 %, therefore it shouldn ' t he considered that the lowest e. g. percent limit of 50 % specified in chinese vermicular iron standard is too lower, and it is also not proper to take the v. g. percent as the basis for judging the level of production technology

    摘要對轎車發動機排氣歧而言,蠕化率制在50 %左右可以獲得最佳的抗疲勞性能,因此不能認為我國的蠕鐵標準中規定的蠕化率高於50 %的要求偏低了,也不能把蠕化率的高低作為衡量工藝水平的依據。
  5. Ssr - dd series of dc solid relay is vastly applied to output joggle of computer and external equipments, it is also applied to control or switch dc load : dc relay 、 contactor 、 dc electrical motor 、 kinds of electric - heating apparatus 、 dc electromagnetic valve 、 electromagnetic iron 、 solenoid 、 filament lamp 、 indication lamp 、 plc logical electrical appliance and dc solid relay

    Dd系列直流固態繼電器廣泛應用於計算機與外部設備的輸出介面,適用與制或開關直流負載:直流繼電,接觸器、直流電動機、各類電器具;直流電磁閥,電磁鐵、螺線、白熾燈、指示燈; plc邏輯電器。
  6. Magnetron has filamentaryo cathode with small time hearting, the shielded cathodic site, liquid cooling and the filter built - in by radio

    該磁具有加時間短的屏蔽陰極,液體冷卻和內建無線電濾波。
  7. Therefore, the frequency - stabilised double longitudinal modes with thermoregulation were adopted. this method was realised by winding wire with high electrical resistance on to the neck of laser tube. heating was controlled by self - organised fuzzy control method

    為此,提出了增加有纏繞于激光頸上的電阻絲輔助加制環節的自四川大學博一l :學位論文組織模糊制雙縱模穩頻方法。
  8. Magnetron has filamentary cathode with small time hearting, the shielded cathodic site, liquid and air cooling, and also the filter built - in by radio

    該磁具有加時間短的陰極,屏蔽陰極,液體和空氣冷卻,內建無線電濾波。
  9. This device, called the manifold heat-control valve, is built into the exhaust and intake manifold.

    這種裝置稱為「歧制閥」,它拼裝在排氣與進氣歧中。
  10. Chilled water coil are controlled in much the same way as heating.

    冷水盤和加的差不多相同。
  11. Our products include multifunctional fittings such as gas air ratio control systems, and thermal management based on microprocessor - controlled automatic burner controls

    我們的產品包括多功能裝置如空燃比調節系統和基於微處理器制的自動燃燒器的理。
  12. In this article, after the analysis of the type of the joint between the tube and tubesheet and relevant factors, the key stage in the fabrication and appropriate method for controlling the quality of the joint were presented

    通過分析換板與子連接接頭的接頭型式及相關要素,提出了製造過程中的制環節、制方法。
  13. The piping system is designed for full flexibility, permitting all modes of operation, in and out with tank truck, rail tank car and vessel, as well as drumming

    所有儲罐均有產品蒸汽制、氮氣補償、快速清洗裝置,並可迅速安裝加和保溫裝置,以備所需。
  14. Mhc or mhcv manifold heat control valve

    制閥
  15. ( 4 ) thermal pipelines are important parts of concentrated heat supply of the thermoelectricity combination. according to the thermal lube service prospect, the paper calculates thickness of the buried steam pipe, proposes a new opinion of the interface temperature controlling method, and also attempt to determine the resistance loss of the minimal steam tubes and wrote its program

    ( 4 )網是電聯產集中供系統的重要組成部分,本文根據道的發展趨勢,對直埋蒸汽道的保溫層厚度計算,提出採用界面溫度製法的見解,並進行編程計算,此外,還對直埋蒸汽主道阻力損失進行編程計算的嘗試。
  16. Blank detail specification : c. w. magnetrons for rf heating or cooking applications ; german version en 136002 : 1992

    空白詳細規范.高頻加或烹調用c . w .磁
  17. This device, called the manifold heat - control valve, is built into the exhaust and intake manifold

    這種裝置稱為「歧制閥」 ,它拼裝在排氣與進氣歧中。
  18. The design had friend human - computer interfaces to monitor the field situation, realized the high precision temperature control with the pid - fuzzy control method, realized the high precision control for motor combining plc with closed - loop control and tension - monitor on - line of variable frequency drives, avoid the hard border and overlapping yarn by four grades stroke modification and changing winding angle incessantly

    利用友好的人機交互界面,實現強大的監理功能;利用pid模糊制實現箱溫度的精確制;採用plc結合變頻器閉環制和在線張力監測實現電機的高精度制;通過四級動程修正和持續改變卷繞角,防止硬邊和疊絲。
  19. Specification for harmonized system of quality assessment for electronic components - blank detail specification : cw magnetrons for rf heating or cooking applications

    電子元器件質量評定協調體系規范.射頻加和烹調用c w磁空白詳細規范
  20. According to the above, the author designs a heat distribution system suited for our country ' s condition

    根據供系統的發展方向,設計出一套適合我國使用的供網站監理系統方案。
分享友人