熱收縮試驗 的英文怎麼說

中文拼音 [rèshōusuōshìyàn]
熱收縮試驗 英文
heat shrinkage test
  • 收 : Ⅰ動詞1 （把攤開的或分散的事物聚集、合攏） put away; take in 2 （收取） collect 3 （收割） harvest...
  • 縮 : 縮構詞成分。
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 收縮 : 1 （由大變小; 由長變短） contract; shrink 2 （緊縮） concentrate one s forces; draw back 3 take u...
  • 試驗 : trial; experiment; test
  1. Through the experimental research, we think : the technological capacity of fiberglass asphalt macadam if weaker than asphalt macadam, however, if use elasticized capacity to solve blending technological problem. adjust the breed of fiber silk, extend its diameter, its paving capacity is still worth exploring, asphalt - rubber macadam structure lager have good deformed - become capacity and crazed - resistance capacity, small gap rate. good water - resistance capacity, good hot - stability and simple construction technology. therefore. pitch rubber spall is a good cover material which is suitable for the second class or lower whose asphalt pavement has split open because of fatigue. and is the good structural measure of preventing half - rigidity grass - roots unit shrink - rift reflecting. pave a thin layer of pitch rubber spall between asphalt - type pavement layer and half - rigidity basic level, although the cost of building is higher than paving togongbu in the middle, the construction technology, crazing - resistance and water - resistance are better than togongbu, not only could reduce greatly the reflex of half - rigidity grass - roots unit material, long then the use lifespan of pavement, but also it is possible to reduce suitably the thickness of asphalt mixture layer, though the cast of building in the early days becomes more, in the long - term opinion, it have fully important technological and economical significance

    通過試驗研究認為：玻璃纖維瀝青碎石的技術性能不如瀝青碎石好，但路用彈性性能較好，如能解決拌和工藝問題，調整纖維絲的品種，增大其直徑，其路用性能仍值得探討，瀝青橡膠碎石結構層具有變形性能和抗裂性能良好，空隙率小，防水性能好，熱穩定性較好，施工工藝簡單的特點，因此，瀝青橡膠碎石是二級及二級以下公路因疲勞而開裂的瀝青路面的良好罩面材料，也是防止半剛性基層收縮裂縫反射的良好結構措施，在瀝青類路面面層和半剛性基層之間夾鋪瀝青橡膠碎石薄層，雖然造價比夾鋪土工布高，但其施工工藝，抗裂性能和防水性能均優于土工布，不僅可以大大減少半剛性基層材料的反射裂縫，延長路面使用壽命，而且可能適當減薄瀝青混合料面層的厚度，雖然初期造價有所增加，從長遠來看，具有十分重要的技術和經濟意義。
  2. The method of concentrating the decoloration solution of tylosin is usually carried out by thin film vacuum concentration. in this experiment, the concentration process is modified by using the nanofiltration membrane technique which is free from corrosive due to the extractant solvent and in the same time, heating and decomposition of the antibiotic are eliminated, the concentration course ia also distinctly shortened. in this process the small molecule can be filtered by water, and the quality of the product such as, the tyramine content, the solubility of the product, improved significantly. in addition, the membrane filtration process could save consumption of steam and cooling water

    泰樂星提煉過程中原工藝脫色液用薄膜真空濃縮，本試驗改進為耐溶媒納濾膜濃縮，料液不需要加熱即可濃縮，防止了料液的高溫分解破壞，濃縮收率明顯提高在濃縮的同時，部分小分子雜質可以隨水分子一起通過納濾膜而除掉，成品質量明顯提高，解決了用原工藝成品酪胺、溶解度不合格的質量問題省去了原工藝濃縮中費用較高的蒸汽、冰鹽水，經濟效益可觀。
  3. Heat shrinkage test

    熱收縮試驗
  4. Test method for expansion or contraction of coal by the sole - heated oven

    用底部加熱爐對煤的膨脹性和收縮性測試的試驗方法
  5. Test method of ironing shrinkage for wool fabric

    毛織物乾熱熨燙收縮試驗方法
  6. With the very low water to cement ratio, rpc has ultra - high strength high ductility and low permeability. in this paper, the compressive strength of rpc can reach to a high point with the number approximately 135mpa. as illustrated from the study results, we can approve some fundamental conclusions : there are big effects on rpc with deferent kinds and properties of raw materials and deferent curing conditions ; stress - strain curve shows the process of destroy with rpc samples ; x - ray diffraction analysis indicates that heat treatment at temperatures 90 accelerate the hydration of rpc sharply, therefore, mechanical and microstructural properties of rpc are highly dependent on heat treatment ; it is believed that rpc materials have excellent resistance to chloride permeability ; during the heat treatment, the shrinkage of rpc developed quickly because of chemical reactions ; the rpc with slag mostly has the advantage of rpc without slag about resistance to solutions corrosion

    研究結果表明：通過對rpc各組分摻量變化的研究，可以找到rpc的最優配合比；試件成型后的熱養護制度對rpc的性能影響巨大； rpc的抗壓應力?應變曲線可以反映出試件受破壞時微裂紋的擴展情況，剛纖維的摻入可以大幅改善rpc的韌性； rpc在成型后存在較大的收縮，而其中的化學收縮要遠遠大於乾燥收縮； rpc具有很強的抗氯離子滲透性能，漿體的密實度很高；通過x射線衍射實驗，可以發現rpc的膠凝體中ch晶體已經幾乎不存在，膠凝體主要由c - s - h凝膠和未水化水泥顆粒組成；在抗溶液侵蝕的實驗中，摻礦渣rpc的抗溶液侵蝕性能在絕大多數情況下要好於不摻礦渣試件，酸、堿溶液和浙江工業大學碩士學位論文摘要一些鹽溶液都會對rpc的結構產生侵蝕作用，但是機理各有不同。
  7. Standard test methods for rubber property - shrinkage of raw and compounded hot - polymerized styrene - butadiene rubber

    橡膠性能的標準試驗方法.熱聚合丁苯橡膠生膠和復合橡膠的收縮性
  8. Standard test method for linear shrinkage and coefficient of thermal expansion of chemical - resistant mortars, grouts, monolithic surfacings, and polymer concretes

    耐化學腐蝕的灰漿薄漿整體面層和聚合物混凝土的熱膨脹系數和線收縮性的標準試驗方法
  9. Test method for thermal shrinkage of synthetic filament yarns

    合成纖維長絲熱收縮率試驗方法
  10. Standard test method for hot air thermal shrinkage of yarn and cord using a thermal shrinkage oven

    用熱收縮爐測定紗線和繩索熱空氣熱收縮率的標準試驗方法
  11. Standard test method of measuring shrinkage from mold dimensions of thermoplastics

    熱塑塑料的模型尺寸收縮率測量的標準試驗方法
  12. Standard test methods for heat - shrinkable tubing for electrical use

    電氣用熱收縮管的標準試驗方法
  13. Test method for measuring shrinkage from mold dimensions of molded thermosetting plastics

    模塑熱固性塑料的模具尺寸收縮量測量的試驗方法
  14. Methods of testing plastics - dimensional properties - shrinkage on heating of film intended for shrink wrapping applications

    塑料的試驗方法.第6部分:尺寸特性.試驗方法643a :收縮包裝用薄膜熱縮變
  15. Standard test method for thermal shrinkage force of yarn and cord with a thermal shrinkage force tester

    用熱收縮力試驗機測量紗線和繩熱收縮力的標準試驗方法
  16. The hydroxyl - terminated and carboxyl - terminated pu - prepolymer were prepared and cured respectively with pf. the molecule structures of two composite systems were characterized by means of ft - ir, and cured - sample morphologies were analyzed by sem. by means of the measurement of properties of pf, impact strength, volume shrinkage and thermal stability of pf / pu composite, effect of pu on pf has been investigated and the toughening differentials have been compared, then two kinds of toughening mechanisms have been discussed

    文中利用紅外光譜對pf / pu共混物的分子結構進行了定性分析，利用掃描電鏡對共混物沖擊斷面形貌進行了表徵、用簡支梁沖擊試驗機按國標測試pf / pu共混物的沖擊強度，並按國標測試共混物體積收縮率，最後利用熱重分析對pf / pu共混物的熱穩定性進行測試。
  17. Testing of plastics ; determination of shrinkage properties of moulded materials from thermosetting moulding materials

    塑料的試驗.熱固性模壓材料制模壓件的收縮特性的測定
  18. Methods of testing plastics - dimensional properties - determination of shrinkage of test specimens in the form of bars of compression moulded thermosetting moulding materials

    塑料的試驗方法.尺寸特性.熱固性模製材料在壓模製棒材過程中試樣的收縮量測定
分享友人
分享到 Line

分享到臉書